Prem-I-Air EH1372 Bedienungsanleitung

EH1372

2 kW Convector Heater

Radiateur Convecteur 2 kW

2 Heat settings

Adjustable thermostat

Free-standing

or wall mounting

Convenient built-in

carrying handle

Safety overload cut-out

2 year guarantee

2 Réglages de Chaleur

Thermostat réglable

Installation au Sol ou au Mur

Poignée de Transport

très pratique

Coupure de Sécurité

en cas de Surchauffe

Garantie 2 Ans

Page 1

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the

user of the product for future reference.

INSTALLATION

For free-standing use: attach the feet to the underneath of

the heater using the four 12mm (½") screws. The feet fit over

the second and third slots from the end of the case.

To wall-mount: Referring to the diagram opposite, draw two

horizontal lines on the wall 330mm (13") apart, the lower line

more than 50mm (2") from the floor.

On the upper line, drill holes 155mm (6·1") from the centre

line, using a 6mm (¼") masonry bit, and insert a wall plug.

On the lower line, drill holes 218mm (8½") from the centre

line using a 6mm (¼") masonry bit, and insert a wall-plug.

Fix the two hook-brackets to the upper holes using the 30mm

(1¼") screws.

Fix the two L-shaped brackets to the underside of the heater

using the 12mm (½") screws through the round hole in the

bracket - the oval hole in the bracket locates over the screw

that fixes the case together,

Hang the heater on the hook-brackets using the two 25mm

(1") slots.

The L-shaped brackets will now line up with the lower holes

in the wall. Attach to the wall using the other two 30mm (1¼")

screws.

Page 2

DRILLING DIMENSIONS FOR WALL MOUNTING

155mm155mm

Page 3

PRODUCT SAFETY

•This appliance can be used by children aged from 8

years and above and persons with reduced physical,

sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and

understand the hazards involved.

•

Children shall not play with the appliance.

•Cleaning and user maintenance shall not be made by

children without supervision.

•Place the EH1372 on a firm flat surface. Ensure that the air

inlets (at the bottom) and the air outlets (at the top) are not

obstructed.

•Ensure that curtains are at least 900mm (3') from the top of

the heater.

•Leave a gap of at least 50mm (2") at the sides of the

heater.

•If used free-standing, do not operate unless the feet are

correctly attached.

•Do not place on soft surfaces.

•Do not cover. This symbol shown on the casing of

the heater means that the heater should not be

covered.

•Do not use outdoors.

•Do not use in bathrooms, or in wet or damp locations.

•Do not use in the immediate surroundings of a bath, a

shower or a swimming pool.

•Do not place the mains lead beneath a carpet or rug.

•Do not use the heater in locations where paint, petrol or

other flammable liquids are used or stored.

•Do not locate the appliance immediately below a socket

outlet

•Do no insert any object into the heater through the grilles.

This may damage the heater or result in overheating or

electric shock.

Page 4

Page 5

PAT TESTING

When used in an office environment, this product must be

safety-tested yearly by a qualified electrician (PAT Tested) in

order to comply with the Electricity at Work Regulations.

We recommend that it is PAT tested regularly when used in a

domestic environment.

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified

electrician at least once every 10 years or at every change of

occupancy.

For office and retail premises, and buildings such as village

halls, the wiring must be inspected at least once every 5

years.

It is recommended that all building be fitted with smoke

alarms (it is mandatory for new buildings).

OPERATION

Plug the mains lead into a 13 Amp mains socket.

If connecting via an extension lead, make sure that the lead

is rated at 10 Amps or more, and that it is fully unwound.

Switch the unit on at the mains socket.

Use the two switches on the side to select the required

operation:

•One switch on = Low Heat (1000W)

•Both switches on = High Heat (2000W)

Do not touch the air output grille when the heater is in

operation, because it will be hot and may cause burns.

Unplug the heater from the mains when not in use.

Page 6

USING THE THERMOSTAT

The thermostat can be use to regulate the room temperature.

Turn both switches on (high heat), and rotate the

temperature control fully clockwise.

The heater will then operate at maximum output. When the

desired temperature is reached, rotate the temperature

control anticlockwise until a click is heard. The heater will

then switch on and off to keep the room at the desired

temperature. The indicator light will show that this is

happening.

Either the "low heat" or the "high heat" setting may be used.

If the temperature control is rotated fully anticlockwise, it will

operate as a "frost-stat" and switch the heater on if the

temperature drops below 4°C, preventing damage by frost.

OPERATING COSTS

At time of going to press, the average cost of electricity is

£0.12 per unit (kilowatt-hour). The amount you are being

charged will be shown on your electricity bill.

At this cost, the EH1372 will cost £0.12 per hour to run on the

"low heat " setting, and £0.24 per hour to run on the "high

heat" setting with the thermostat set to its maximum.

If the thermostat is used to regulate the temperature the

operating costs will be lower, depending on the room

temperature.

FAULT-FINDING

The EH1372 has an overheat protection switch, which

disconnects the power if the element gets too hot. The usual

reason for this is because the air-flow has been obstructed,

or the grilles have been blocked. If the heater ceases to

operate, leave it for 20 minutes to cool down, then check that

the grilles are not being obstructed.

Page 7

Switch back on, and check that the unit is operating normally.

If not, contact an authorised service agent for repair.

MAINTENANCE

Before cleaning, turn the heater off, and disconnect from the

mains supply. The heater may then be cleaned using a damp

cloth with a drop of washing-up liquid to remove any dust or

dirt from the case. Do no use stronger detergents or solvents

as these may damage the paint finish.

Using a dry 1" (25mm) paint-brush, remove any dust from the

grilles.

If the mains lead is damaged, it must be replaced by the

manufacturer or and authorised service centre. If the mains

plug needs to be replaced, proceed as follows:

•Connect the brown wire to the

terminal labelled "L".

•Connect the blue wire to the

terminal labelled "N".

•Connect the green/yellow wire

to the terminal labelled with the

earth symbol or "E".

•Make sure that the cord-grip is

positioned correctly (over the

outer sheath of the cable) and it

fully tightened.

DISPOSAL AND RECYCLING

You must not dispose of this appliance with domestic

household waste. Most local authorities have specific

collection system for appliances and disposal is free of

charge to the end-user. When replacing an existing appliance

with a similar new appliance your retailer may take the old

appliance for disposal.

Page 8

TECHNICAL SPECIFICATION

Dimensions (wall mounting): 600×350×95mm

Dimensions (floor standing): 600×385×222mm

Weight: 3.6kg

Power supply: 230V AC

Power consumption: 2000W

Operating current: 8.7A

SERVICE WARRANTY

Prem-i-Air guarantees the product free from defects in

materials and workmanship for a period of two years.

Should this appliance be operated under conditions other

than those recommended, at voltages other than the voltage

indicated on the appliance, or any attempts made to service

or modify the appliance, then the warranty will be rendered

void.

The product you buy may sometimes differ slightly from

illustrations. This warranty is in addition to, and does not

affect, your statutory rights.

If you have any problems with this product, please call our

Help Desk on (0845) 459 4816.

Prem-i-Air Appliances Ltd.,

Lancots Lane,

Sutton,

St. Helens,

Merseyside.

WA9 3EX

website: www.prem-i-air.com

Page 9

IMPORTANT

Installateurs et Utilisateurs, veuillez noter:

Vous devez lire attentivement cette notice et la conserver

pour une éventuelle future consultation.

INSTALLATION

Pour une utilisation autonome au sol: Fixez les pieds sous

le radiateur en utilisant les quatre vis 12mm. Chaque pied se

place à chaque bout du radiateur.

Pour une installation murale: En vous référant au schéma

fourni, tracez deux lignes horizontales distantes de 330mm

sur le mur, la ligne du bas devant être tracée à plus de 50mm

du sol.

Sur la ligne du haut, percez des trous à 205mm de l'axe

central, en utilisant un foret à maçonnerie de 6mm puis

insérez une cheville murale.

Sur la ligne du bas, percez des trous à 218mm de l'axe

central, en utilisant un foret à maçonnerie de 6mm puis

insérez une cheville murale.

Fixez les deux crochets fournis sur les trous supérieurs en

utilisant des vis de 30mm.

Fixez les deux supports en forme de L sur la face inférieure

du radiateur à l'aide des vis 12mm qui passeront au travers

du trou rond du support „ le trou ovale du support qui se situe

au-dessus de la vis maintient le boîtier.

Accrochez le radiateur sur le support en utilisant les deux

fentes de 25mm.

Le support en forme de L doit être aligné avec les trous

inférieurs percés dans le mur.

Fixez au mur en utilisant les deux autres vis de 30mm.

Page 10

Andere Handbücher für EH1372

Inhaltsverzeichnis

Sprachen:

Andere Prem-I-Air Heizung Handbücher

Prem-I-Air

Prem-I-Air N10T24 Bedienungsanleitung

Prem-I-Air

Prem-I-Air N10Turbo Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1896 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1524 Handbuch

Prem-I-Air

Prem-I-Air EH1434 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1794 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1442 Bedienungsanleitung

Prem-I-Air

Prem-I-Air C307 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1422 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1842 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1892 Bedienungsanleitung

Prem-I-Air

Prem-I-Air HT2007 Bedienungsanleitung

Prem-I-Air

Prem-I-Air PFH550 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1844 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1566 Bedienungsanleitung

Prem-I-Air

Prem-I-Air Elite EH1365 Bedienungsanleitung

Prem-I-Air

Prem-I-Air PCH0501 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1840 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1712 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0286 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1426 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0152 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

iLO

iLO IHP2424 Betriebsanleitung