P-5
2. When the CD Door is closed with a CD inside, the total number of tracks will be shown on the CD LED
Display and it will go to "Stop" mode.
3. If the CD Door is not closed or there is no disc inside and it will go to "Stop" mode.
PLAY/PAUSE MODE
1. When the Play/Pause Button is pressed during "Stop" mode, the first track will be played. The Play/Pause
LED Indicator will be lighted. The CD LED Display will show the specific number of tracks played.
2. For interruption while the CD is playing, press the CD Play/Pause Button once. The Play/Pause LED
Indicator will flash continuously.
3. Though the sound stops, the disc will continue to spin. To re-start playing, press the CD Play/Pause Button
once again. The music will start from the exact position where it was interrupted.
4. To stop the CD, press the CD Stop Button once whether the CD is in Play or Pause mode.
REPEAT MODE
REPEAT 1: When the Repeat Button is pressed once, the Repeat LED Indicator will light and flash continuously.
This single track will be repeated.
REPEAT ALL: When the Repeat Button is pressed twice, the Repeat LED Indicator will stay lighted. The whole
disc will be played continuously.
TO CANCEL THE REPEAT FUNCTION: Press the Repeat Button until the lighted Repeat LED Indicator turned
off.
SKIP AND SEARCH MODE
1. During Play or Pause mode, when CD Skip Forward "" or CD Skip Backward "" Button is pressed once,
it will go to the next track or go back to the beginning of the track.
2. During play mode, when CD Skip Forward "" or CD Skip Backward "" Button is pressed and held, it will
search the track with audible high speed forward or backward playback.
PROGRAM MODE
1. During the CD Stop mode, press the Program Button once and the Program LED Indicator will light up. Press
the CD Skip Forward "" or CD Skip Backward "" Button to your desired musical track, the CD LED
Display will show the appropriate track number and press Program Button.
2. Repeat above procedure until all desired tracks have been programmed. Up to 20 tracks can be
programmed.
3. To start the programmed playback, press the CD Play/Pause Button once.
4. To cancel the programmed play mode, simply open the CD Door.
RECORDING FROM CD PLAYER
1. Slide the Function Switch to "CD" position.
2. Put a CD into the CD compartment with the label on top.
3. Insert a blank cassette into the Cassette compartment and press Pause Button of the cassette deck.
4. Press Record Button and Play Button simultaneously of recording stand-by. With the built-in ALC, the best
recording quality is adjusted.
5. Activate the CD player, playing in a desired track as described in the CD Player Operation section. Release
the Pause Button of the cassette deck to start recording.
6. To temporary stop recording, press the Pause Button. To continue recording, press the Pause Button again.
7. Press Stop Button of the cassette deck to stop recording, then stop CD playback by pressing CD Stop Button
of the CD player.
