Instruction Manual ECO FL
8
Additional Instructions
In case the table disposes a Vario iron system (optional):
Hook the steam iron from the balancer and adjust the distance of the steam iron from the working
surface (approximately 5cm). After you have finished ironing, unhook the steam iron from the balancer
and put it on the iron rest mat.
7. Maintenance
Make sure that the covers of the table and the ironing buck remain clean, in order to have
high performance of suction and blowing air. Wash periodically the blue polyester fabric and
the foam blue in the washing machine (30-40 οC).In case you use felt molletone instead of blue
foam, do not wash it in the washing machine, but wash it by hand. Replace them regularly, in
order to keep high suction performance.
Clean the dust of the fan wheel /impeller at least 2-3 times per year.
Clean periodically and grease the arm’s as well as the buck’s bearings.
Clean periodically the internal parts of the table as well as the electronic circuit by using
compressed air.
Keep the machine clean.
CAUTION!
Before doing maintenance work, please disconnect the machine from the electrical power supply.
8. Troubleshooting
For the instructions mentioned in the current section please see the drawing of the spare parts
of the machine on page 11.
8.1 The vacuum does not function properly
Check if there is power supply.
Check if the power feeding cable No 05 is for some reason cut off.
Check the fuse inside the fuse case No 07.
Check if the suction’s button pedal No 21 is faulty.
Check if the motor No 01 is for some reason damaged.
Check the electronic circuit Νο 26.
8.2 The heating of the working surface is not activated
Check if the fuse inside the fuse case No 07 is burnt out. Replace it.
Check if the thermostat No 10 is faulty. Replace it.
Check if the heating element No 09 is burnt out. Replace it.
Check if the thermostat No 11 is faulty. Replace it.
8.2The heating of the ironing buck is not activated.
Check the buck’s cable and plug.
Check the switch (No 8) which indicates the buck’s heating on the panel.
Check the heating element of the ironing buck.
8.4 The machine operates loudly
Check if the ball bearings of the motor are faulty. Replace them.
Check the impeller to be sure, that there is no dust which could cause the vibration.
