Prince Castle EC12 Series Bedienungsanleitung

EC-C60003 RevA_EN 1/ 8

LIMITED WARRANTY

This product is warranted to be free from defects in material

and/or workmanship for a period of one (1) year from date of

original installation, not to exceed 18 months from date of

shipment from our factory. Any part or component which

proves to be faulty in material and/or workmanship within the

warranty period will be replaced or repaired (at the option of

Prince Castle, Inc.) without cost to the customer for parts or

labor.

This warranty is subject to the following exceptions/conditions:

• Use of any non-genuine Prince Castle parts voids this warranty

and all work must be performed by an authorized Prince Castle

Service Agent.

• All labor shall be performed during regular work hours.

Overtime premium will not be covered.

• Travel charges are limited to 100 miles/200 km round trip, 2

hours travel time, one trip per repair.

• Damage caused by carelessness, neglect, and/or abuse (e.g.,

using wrong current, dropping, tampering with or altering

electrical components, or improper cleaning) is not covered.

• Equipment damaged in shipment, by fire, flood or an act of

God is not covered.

• Damage to non-sticking Egg Ring is not covered by this

warranty.

OPERATION MANUAL

EGG

COOKER

EC12 Series

Product Identification

TABLE OF CONTENTS

Product Identification ……………………............1

Safety Information …………………….................2

Electrical Information …………………………….…2

Model Number ……………………......................2

Installation …………………….............................2

Operation ……………………………………………………3

Programming…………………..…………………………4

Temperature Calibration …………………..............5

Load Factory Presets …..……………………..........5

Daily Cleaning……………….……………………........6

Part List …………………….................................. 7

Troubleshooting & Wiring Diagram ……………...8

Prince Castle reserves the right to change

specifications and product design without

notice. Such revisions do not entitle the buyer

to corresponding changes, improvements,

additions or replacements for previously

purchased equipment

Prince Castle LLC (China)

Building 5, No. 889 Kungang Road.,XiaoKunShan Town, Songjiang District, Shanghai, China, Zip Code 201616

Tel: +86-021-6040-1728 www.princecastle.com

DISPLAY

PRODUCT

INDICATOR

LIGHT(1-4)

PRODUCT 1 &

UPPER ARROW

BUTTON

PRODUCT 2 &

LOWER ARROW

BUTTON

PRODUCT 3 BUTTON

PRODUCT 4

BUTTON

TEMPERATURE

BUTTON

HEAT ON

INDICATOR

LIGHT

SET BUTTON

EC-C60003 RevA_EN 2/ 8

Remove the unit from the carton and inspect for signs of damage. If there is damage to the unit:

• Notify the carrier within 24 hours of delivery.

• Save carton and packaging materials for inspection purposes.

• Contact your local dealer, or if purchased directly, the Prince Castle Sales Department at 86-21-6040-1716

to arrange for a replacement unit.

•Place unit on a sturdy, level table and place the Service Pans on each side of the unit

•Remove packing materials and clean the Egg Rings, Egg Ring Frame, Top Lid, Platen surface and Service Pans in

hot, soapy water. Rinse in clear water and allow to air dry.

Ensure the unit is placed in a perfectly horizontal position, otherwise it will cause egg undercooked due to the

shortage to steam.

NOTE: When using this unit, the ambient temperature at the mounting site should not exceed 43°C (110°F)

All electrical connections must be in accordance with local electrical codes and any other applicable codes.

Plug the unit into an applicable electrical receptacle.

To prevent an electric shock hazard this device must be bonded to equipment in close proximity with an

equipotential bonding conductor. This device is equipped with a grounding lug for this purpose and is marked

with the following symbol.

EC12 Series

Safety Information

Electrical Specification

Volts

208-240V

50/60Hz

Frequency

Power

2500-3350W

Model Number

EC12 Series

Description

Egg Cooker

Indicates information important to the proper operation of

the unit. Failure to observe may result in damage to the

equipment and/or severe bodily injury or death.

Indicates information important to the operation of the unit.

Failure to observe may result in damage to the equipment.

This equipment is intended for commercial occasions and operated

by trained staff. Operation by untrained personnel or those with

reduced physical, sensory or mental capabilities may result in severe

injury or death.

Failure to connect unit to rated power supply may cause damage to

the unit and voids the warranty.

Model Number

Installation

EC-C60003 RevA_EN 3/ 8

Installation

EC12 Series

Operation

1．Turn power switch to ON position and allow it to

warm up for approximately 10–20 minutes.

NOTE: HEAT ON indicator will be on until unit reaches

presetting temperature. A beep will sound and

cooking time will no longer flash, the HEAT ON

indicator is off.

2. When unit reaches presetting temperature,

raise the Top Lid and brush the Egg Rings and

Grill surface with melted butter or equivalent.

Ensure all cooking sides are covered evenly.

NOTE ：Failure to apply melted butter or

equivalent to cooking surfaces and Egg Rings

may result in egg sticking.

4. Cover the eggs with the top lid, then fill the two

troughs on the Top Lid with warm water (above

50℃)until they are completely full. This is very

important to get a completely cooked egg with a

jelled yolk. Using less water results in under-cooked

eggs.

3. Crack the eggs into the Egg Rings in the order

specified below. Break the egg yolks with plastic tool

(optional).

NOTE: Eggs should be kept in room temperature for

approx.30 mins before cooking. Cold eggs may result

in under cooked products.

5. Press and release product button to start cooking cycle. Time

will start to count down on display. A sound will beep and 0:00

will flash when cooking is completed. Press the product button

again. Open the Top Lid and raise the Egg Ring Frame about 1

inch (26cm), then drop the rack to loosen the eggs. Move

cooked eggs with a spatula (optional).Remove any residue from

the platen and Egg Rings after each cooking cycle.

EC-C60003 RevA_EN 4/ 8

Programming of Cooking Time and Temperature

2. Once the correct sequence has been entered, the

preset time will now displayed, set the desired time

with the "1” increase or “2" decrease buttons.

3. Press the “SET” button to save the change.

4. Then the preset temperature of heater platen will

be displayed, set the desired temperature with the

"1” increase or “2" decrease buttons.

5. Press the “SET” button to save the temperature setting

as shown below.

1. Press any number product button and the LED above it

will light, then press “SET” button one time and the

display will read "_ _ _ _." Enter the four-digit security

code sequence: 4, 3, 2, 1.

Press any number product button and the LED

above it will light, then press “SET” button one time and

the display will read "_ _ _ _." Enter the four-digit

security code sequence: 4, 3, 2, 1.

below.

EC12

Series

EC-C60003 RevA_EN 5/ 8

Temperature Unit Switch & Calibration

Load Factory Presets

1. Press “SET” button one time and the display will

read "_ _ _ _." Enter the four-digit security code

sequence: 2, 3, 4, 1.

2. The window will display “dEGC” or “dEGF”, set the

desired temperature unit with the "1” or “2" buttons

3. Press the “SET” button to save the change.

4. Place an external thermometer on the middle of

the heater platen.

5. Press the Up or Down arrow until the display

matches the external meter.

6. Press the “SET” button to save the change.

To revert all settings back to the original factory defaults:

1. Turn off the power switch, press and hold “3" buttons.

2. Turn on the power switch and hold “3" buttons for 5 seconds.

3. The window will display "PSE." That means to reset to factory defaults.

Factory presets：

Cooking time：2:30 mins；Temperature：302 οF (150°C )

Load Factory Presets

EC12

Series

EC-C60003 RevA_EN 6/ 8

NOTE: Cleaning on heater platen and egg ring should be performed after each cycle for optimal product quality.

操作

Daily Cleaning

Daily Operating hours:

1. After each cook cycle remove all food residues from the cooking surfaces and Egg Rings with a

non-abrasive brush.

2. Empty Service Pans at least daily or as necessary during high use periods.

After Hours:

1. Turn off the unit, unplug and let it cool for 10 minutes.

2. While wearing protective gloves, remove the Top Lid and Egg Ring kit by lifting it up and out of the

unit. Proceed with caution, unit is still hot!

3. Remove the egg rings from the frame.

4. Wash with approved mild sanitizer solution in the back sink

5. Rinse with clear water and let air dry.

Turn the unit off and unplug the power cord from the electrical receptacle. Proceed with caution, unit

is still hot!

This unit is not watertight. Do not clean with a water jet/jet spray. Do not immerse the unit in water.

1. Never use pumice, griddle stones, or abrasives on platen surface.

2. Never strike the griddle surface with a sharp instrument or spatula edge.

3. Never use steel wool.

4. Never use commercial liquid grill cleaner on the griddle surface.

5. Abusing surface voids the warranty.

6. While unit is still hot, remove food residue from the cooking surface with a non-abrasive brush.

7. Apply a tablespoon of Heat Activated Grill Cleaner to a damp cloth and apply to the heating surfaces

and let the cleaner rest for 5 to 10 minutes.

8. Remove cleaner with a damp cloth and let air dry.

9. Wipe the external surfaces with a damp cloth and let air dry.

Top Lid

Egg Ring Kit

Egg Ring

EC12

Series

EC-C60003 RevA_EN 7/ 8

No.

Part No.

Description

QTY

No.

Part NO.

Description

QTY

EC-C10018

Top Lid

PM-096

Transformer

EC-021

Egg Ring

EC-C30001

OVERLAY, DISPLAY

EC- C10019

Egg Ring kit

78-233

SWITCH,ROCKER,DPST,

EC-C20001

Heat Platen

EC-C10023

BACKER, DISPLAY

600-C198-4

Heater Element

EC-C30002

MAIN PCB

600-C305

Probe-Bot

542-164

GUARD,SWITCH

600-C206

Insulation, Bot

EC-019

Knob

301-117

THERMOSTAT

EC-C10007

BRACKET,BOT

EC-C10021

Tray, Right

EC-C10004

MAIN BRACKET

EC-C10011

Tray, Front

10-C0043

KNURLED THUMB SCREW

77-082

Terminal Block

EC-C10010

Tray, Left

197-232

Foot, Mounting

72-423

POWER CORD, IEC309(Not shown)

65-058

Relay

PM-123A

POWER CORD, CH2-16P (Not shown)

操作

Exploded View and Part List

EC12 Series

EC-C60003 RevA_EN 8/ 8

Troubleshooting

Symptom

Possible Cause

Remedy

No power

Faulty power switch

Replace

Faulty PCB

Replace

Unit unplugged from power

Plug in power cord

Facility circuit breaker tripped

Reset circuit

Product

undercooked

Low heater temperature

Check heater platen temperature

Egg too cold

Use warmer eggs

Egg yolk not broken

Ensure egg yolk is broken

In correct water volume/water too cold

Check water volume/temperature

Steam escaped

Check and ensure Top lid is not misplaced.

Product

overcooked

High heater temperature

Check heater platen temperature

Insufficient water

Fill water trough till it’s full

Longer cooking time

Check setting on cooking time

Error Code: E1

The set temperature of heating plate is not reached

within 20 minutes.

Check circuit connection and relay

Error Code: E2

The temperature of the heating plate exceeds 285 ℃

Check circuit connection and relay

Error Code: E3

RTD fails cause open circuit (Resistance>= 2810 ohms )

Check & Replace RTD

Error Code: E4

Incorrect RTD installed (Resistance <= 922 ohms)

Check & Replace RTD

Error Code: E5

Write operation failed or memory corrupted (CRC)

Replace PCB Board

Error Code: E6

Buttons are broken or no respond after pressing

button for more than 30 seconds

Check & Replace PCB Board and Overlay

Wiring Diagram

Troubleshooting and Wiring Diagram

EC12

Series

Inhaltsverzeichnis

Andere Prince Castle Eierkocher Handbücher

Prince Castle

Prince Castle Redi-Gril 804-SL Bedienungsanleitung

Beliebte Eierkocher Handbücher anderer Marken

Caso

Caso E7 Bedienungsanleitung

NEO

NEO NEO-BOIL Bedienungsanleitung

Eldom

Eldom eggo EM101C Bedienungsanleitung

Salton

Salton EG2LT Looney Tunes Bedienungsanleitung

Dash

Dash DELUXE Technische Daten

Copper Chef

Copper Chef Copper Eggs Kurzanleitung

Bestron

Bestron AEC700 Bedienungsanleitung

Bifinett

Bifinett KH 401 Bedienungsanleitung

Westfalia

Westfalia Laser 2000 JA-313S Bedienungsanleitung

Roundup

Roundup ES-1200 Bedienungsanleitung

WMF

WMF KUCHENminis 1-Ei-Kocher My Egg Bedienungsanleitung

Black & Decker

Black & Decker EG100 Bedienungsanleitung

Sinbo

Sinbo SEB 5802 Bedienungsanleitung

Gastroback

Gastroback DESIGN EGG BOILER MINI Bedienungsanleitung

Mesko

Mesko MS 4485 Bedienungsanleitung

Fritel

Fritel EC 1475 Bedienungsanleitung

MCM Electronics

MCM Electronics K41589 Installations- und Betriebshandbuch

Breville

Breville Eggspert BEG100 Bedienungsanleitung