Installing the door element
Turn the door element into the installation
position and place it in front of the wall
opening.
Route the connection cable hanging on the
lock side towards the front and let it hang.
Lift the door element into the wall opening
and place on the protruding packer
material at the bottom.
Firstly, the door frame must be pushed
against the bottom side packer material.
Align the door element flush with the
mounting frame, secure it against falling
out and tilting.
The four bottom countersunk head screws
4.5 x 80mm are then tightened and then
the frame is aligned using the cross-line
laser.
Use the countersunk head screws 4.5 x
80mm to screw the remaining frame of the
door element onto the mounting frame.
After screwing the frame onto the
mounting frame the door leaf can be
opened.
A power adapter with 24V or a test device
is required for this. White cable +24V,
brown cable -24V.
Screw the nameplate onto the mounting
frame, in the middle of the opening side,
using a panhead screw 4.5 x 20mm.
After the functional test, lay the connection
cable in the shaft between the mounting
frame and the wall (see detail below).
Fill the wall edge joints with mortar or
gypsum (e.g. Knauf Uniflott) depending on
the wall type.
