MAINTENANCE
• Clean Secure Touch Lock with a clean, dry cloth as needed.
• Lubricate moving parts with standard consumer lubricant as needed.
• Please only use provided charge cable to charge lock. Recommended charger output: 120mah 3.7V. Light
will be GREEN while charging, and will turn o when complete.
• Stop using lock if it starts smoking, starts smelling, is overheated, discolored, or deformed.
• Do not use the lock in a violent manner.
• If lock is left unused for a long time, battery will drain and will need to be recharged.
• Do not use if lock is soaked, as shocking could occur.
• Children must use this lock with parental guidance. Recommended for Ages 14+.
• If your padlock starts acting abnormally, try resetting: see Deleting All Fingerprints section to reset lock.
• See www.Pro-4Tactical.com for Warranty and Replacement Information.
WARNING: This product can expose you to chemicals including Benzene and Ethylbenzene which are known to the
State of California to cause cancer. For more information, go to www.p65Warnings.ca.gov
WARNING
TROUBLESHOOTING
DELETING ALL FINGERPRINTS
1. After altering the lock, press and hold administrator
ngerprint on the pad. The light will ash BLUE
along with two beeps. Continue to hold. The light
will then blink BLUE and RED. Continue to hold until
the light blinks RED. Release ngerprint.
2. Press and hold the
administrator ngerprint
to the ngerprint pad.
A RED light and one long beep
indicates successful deletion. All
stored ngerprints have been erased.
Any ngerprint will open the lock until
an administrator is entered.
A RED light and four beeps indicates
an unsuccessful deletion. All stored
ngerprints remain stored.
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
Lock shackle
LED instruction
lights Fingerprint
sensor
TSA007 lock
cylinder
micro-USB
Charging interface
setting button
1.Registered fingerprint
2.Press the setting button after the red light is out.
WARNING: This will delete all ngerprints, including the administrator, and reset the lock to factory settings. Please use caution.
