1. Press the “MODE” and “SETUP” at same time for a few seconds later, will restore factory settings, the data will
be initialized.
2. This fixture with the temperature detection functions. In order to avoid other problems, when the temperature
detection fault occurs, the fixture will auto entered into self-protection state and the LED display will flash “-rt-”
character, to prompt temperature control error.
3. Be careful with your operations. You endanger your own safety and others, please follow the operation in this
manual.
4. When the fixture operating in a environment temperature is beyond the scope of parameter allows, if the
temperature is higher than allows, please reduce full power use time, to prevent overheating damage fixture.
5. In DMX mode, if there is a control signal, the display board will flicker for prompting.
the temperature detection fault occurs, the fixture will auto entered into self-protection state and the LED display
will flashing “-rt-”character, to prompt temperature control error.
