9
English
Original operating instruction - professional tow bar
Organisational measures and safety
General
Extreme caution must be exercised during any towing operation. Be aware that a towing operation is not an
everyday trac situation. Always drive slowly and in a controlled manner.
- The driver of the towed vehicle does not have to be in possession of a driving licence in Germany. However,
he or she must be mentally and physically t and be able to steer.
- (Please note the different regulations in your country).
- In accordance with § 47 paragraph 1 of the German accident prevention regulation BGV D29, the tow bar
must correspond to the total mass of the towing vehicle and the vehicle to be towed.
- Only vehicles capable of braking and rolling may be towed.
- If a vehicle is towed on a motorway, the motorway must be left at the next exit. It is also not allowed to drive
onto motorways (§ 15a StVO).
- The visibility between the two vehicles must be such that the rear and brake lights of the towing vehicle can
be observed from the towed vehicle.
- When steering and braking a towed vehicle, the increased steering and braking forces must be observed
(due to loss of steering and braking assistance)!
- The towed vehicle must be illuminated in accordance with the regulations. If necessary, follow-on lighting
must be tted.
Attachment of the tow bar
- Only attach the tow bar to the towing eyes or ball head couplings provided for this purpose on the
vehicle. Information on suitable attachment points can be found in the vehicle manufacturer‘s operating
instructions.
- Before towing, make sure that the towing eyes or ball head couplings are in perfect condition.
- Watch your hands when attaching the tow bar. There is a risk of crushing.
- Secure inoperable vehicles against rolling away on slopes (§ 55 Para. 1 German Federal Motor Accident
Insurance Regulations (BGV D29)).
- Make sure that there is a safe connection between the vehicles. Only start the towing operation when both
vehicles are securely connected to each other.
- If possible, hook the tow bar hooks into the towing eyes from top to bottom.
- Ensure that the tow bar has the necessary clearance.
- The towing devices of the vehicles to which the tow bar is to be attached must be suciently strong.
Therefore, consult the vehicle manufacturer‘s operating instructions or a specialist workshop to nd out
whether the mounting points are suitable for the use of this tow bar. The tow bar is not suitable for sharp-
edged, for cross-sections that are too small (less than 8 mm in diameter) and at sheet metal eyelets.
Driving
- When towing vehicles, observe the trac regulations of the country where you are.
- When reversing/manoeuvring, the help of an instructor should be sought (§ 46 BGV D29).
- During the towing process, both vehicles must switch on their hazard warning lights in accordance with §
15a of the Road Trac Act.
- The tow bar should be approximately horizontal while driving.
- Appropriate care should be taken when starting and braking, if possible both vehicles should brake at the
same time. The tow bar and the pick-up points on the vehicles are not capable of safely absorbing extreme
loads due to thrust forces occurring!
Removing
- Before removing the tow bar, secure both vehicles against rolling away. Apply the parking brakes apply.
Start-up
Attach
1. Drive the towing vehicle at a distance of approx. 2.50 metres from the vehicle to be towed.
2. Connect the individual parts of the professional tow bar with each other depending on the purpose of use.
Please refer to the following illustration.
