V1.0 24 X 36 IN. WELDING TABLE 8663833
Visit www.princessauto.com for more information 5
1. The tabletop (#1) is attached to the base (#2) with 10
screws (#10). Flip the table upside-down so he base is
facing up.
2. The support legs (#3) have two sets of bolt holes. The set
that is closer to the end of the leg attaches to the table.
3. Hold the support leg against the base and align the bolt
holes. Push a bolt (#6) through the bolt hole and secure
with a nut (#8). Push a second bolt through the other bolt
hole and also secure with a nut. Hand-tighten the nuts to
allow a bit of play during assembly.
4. Repeat with the other three support legs.
5. Connect each set of support legs along the short sides of
the table with a beam (#4).
6. Place a beam on the inside of the support legs. The beam’s
flat top will face the bottom of the table.
7. Align the bolt holes and pass a bolt (#9) from outside
through to the inside. Place a flat washer (#13), then a
spring washer (#7) on the bolt. Screw a nut onto the bolt
and hand-tighten. Repeat for other end of the beam.
8. Repeat on other side of table to install the second beam.
9. Install the two long beams between the legs on the long
sides of the table.
10. Place a long beam (#5) on the inside of the support legs.
The beam’s flat top will face the bottom of the table. Align
the bolt holes and make sure the flat top is either over or
under short beams on each end.
11. Align the bolt holes and pass a bolt (#9) from outside
through to the inside. Place a flat washer (#13), then a
spring washer (#7) on the bolt. Screw a nut onto the bolt
and hand-tighten. Repeat for other end of beam.
12. Repeat with the support legs on other side of the table.
