5
Common Tasks
Change the LAN
IP Address Mode Tab Enter the IP address to be assigned to the
EtherLINQ and select the subnet mask for
the LAN. The DHCP Server will
automatically adjust to the new subnet.
Configure the
LTE APN LTE Tab Enter the Access Point Name (APN)
assigned to your SIM. Also configure LTE
Keep-Alive settings.
Change the WiFi
Password WiFi Tab Configures the Access Point’s SSID and
security settings.
Forward Ports to
LAN Devices Mode Tab > NAT
Router Mode Enter up to 10 port-forward / translation
rules.
Set up a VPN VPN Tab Enable IPSec and Add new rules for each
VPN tunnel.
Configure WAN
Fail-Over WAN Tab Set WAN priority, fail-over and connection
Keep-Alive settings.
Restart
Periodically Advanced Tab >
Scheduled Reboot Select the frequency for the EtherLINQ to
automatically reboot.
Change the
System Name Advanced Tab >
Device Access Enter the System Identification.
Change the
EtherLINQ
Password
Advanced Tab >
Device Access Passwords are case sensitive. The
username cannot be changed from
“admin” however, multiple users may log
in concurrently.
Change the
Administration
Ports
Advanced Tab >
Device Access HTTP and HTTPS can be assigned to any
port or disabled as necessary to avoid
port conflicts or increase security.
Backup / Restore
Settings Admin Tab >
Configuration
Settings
Settings can be saved or restored;
EtherLINQ can be reset to factory default
settings.
Enable Bridge
Mode Mode Tab > IP
Pass-Through Passes the WAN IP address to first LAN
device that requests a DHCP address.
Enable Virtual
Cable Mode Mode Tab > Virtual
Cable Bridges the EtherLINQ to other
EtherLINQs and PocketPORTs through
any intervening network toplogy.
Update Firmware Status Tab> Check
For Updates button Requires an active WAN connection to
check the Proxicast server for updates.
Consult the EtherLINQ User’s Guide for more detailed information on how to
configure all of the EtherLINQ’s features.
