3INSTALLATION AND OPERATION MANUAL FOR FLAT ROOF SYSTEM Q.FLAT-G6 – Q CELLS
Please note that our general safety information must be observed. First read through the general safety instructions
and the assembly instructions.
1 GENERAL SAFETY INFORMATION
ÎThe current project report must be used for all information regarding ballasting, dimensions of the module area and the roof
area, etc.!
ÎThe building data specified in the project must be compared with the actual building data. In the event of deviations, this
must be agreed with Hanwha Q CELLS GmbH and the planning adjusted. Hanwha Q CELLS GmbH reserves the right to
exclude liability in the event of non-compliance.
ÎBefore installation, the compatibility of the system with the roof must be checked.
ÎSystems may only be installed and commissioned by persons who, due to their professional qualification (e.g. training or
activity) or experience, can guarantee that they are carried out in accordance with the regulations.
ÎBefore installation, it must be checked whether the product meets the static requirements on site. In the case of roof sys-
tems, the load-bearing capacity of the roof on site must also be checked. National and local building regulations, standards
and environmental protection regulations must be observed.
ÎFor roof pitches greater than 2.5°, we strongly recommended connecting the system to the roof structure in order to prevent
a “bead effect” caused by thermal linear expansion.
ÎOccupational safety and accident prevention regulations, corresponding standards and regulations of the employers' liability
insurance association must be observed.
ÎThe Q CELLS installation instructions for the solar modules must be observed.
ÎIn the event of non-observance of our general safety instructions, installation instructions and non-use of all system com-
ponents as well as the installation and removal of components that were not purchased from us, we accept no liability for
any resulting defects and damage. The warranty is excluded to this extent.
Intended use
ÎThe Q.FLAT-G6 flat roof system is only permitted for use on flat roofs.
ÎThe Q.FLAT-G6 may only be used with Q CELLS solar modules with the dimensions 1673 mm × 1030 mm × 32 mm (e.g.
Q.PEAK DUO BLK-G9), 1840mm × 1030 mm × 32 mm (e.g. Q.PEAK DUO ML-G9) and 1740mm × 1030 mm × 32mm (e.g.
Q.PEAK DUO-G6), including frame.
ÎIf the Q.FLAT-G6 is not to be installed or operated according to the specifications in these installation and operating instructions,
please contact a certified sales partner or employee appointed by Hanwha Q CELLS GmbH.
