Quantum DLTtape DLT1 Bedienungsanleitung

DLT™ TAPE UNIT INSTALLATION

HP® 9000 Series 700 System

HP-UX® 9.X

Installation

The system must have the appropriate SCSI interface for DLT drive to attach to, i.e., a SCSI single-ended

DLT drive can be attached only to a SCSI single-ended interface. The same is true for SCSI differential

attachment. The hardware attachment simply requires the DLT tape peripheral to be attached to the

interface while the system is powered down. After the DLT tape peripheral has been attached, you will

need to perform certain system operations that will allow DLT device system recognition.

Perform the installation as follows:

1. Shutdown the system and remove ac power from the system. Install the DLT tape

peripheral and connect it to its SCSI controller. Refer to the following manual for

switch and jumper settings and SCSI bus termination:

• DLT1/DLT7 Install and Operations Guide Set the DLT SCSI device address to an

unassigned ID.

1. Power up the system. During the power-up, the process allows you to stop the

sequence by pressing the ESC key. By doing so, you can verify drive attachment

by issuing a search for boot device selection. This will display all attached SCSI

devices including the DLT tape drive. The boot process can continue by selecting

the appropriate boot disk.

2. Log on as root and change directory to /dev/rmt

In the next step, you will create a set of device files that will allow DLT device access. These device files

allow certain DLT device modes of operation.

1. Enter the following commands:

mknod 1m c 54 0x201402

mknod 1mn c

54 0x201403

mknod 1c c 54 0x2014c2

mknod 1cn c 54 0x2014c3

The device files created are for an installed DLT device with a SCSI ID of 4 and are shown below along

with their corresponding operating characteristics:

1m - drive 1, rewind on close

1mn-d

rive 1, no rewind on close

1c - drive 1, compressed, rewind on close

1cn - drive 1, compressed, no rewind on close

Associating the device files to a DLT device with a SCSI ID other than

requires that the number "4" in the minor number of the

mknod command be changed to the new ID.

DLT Mini-Library Usage

The HP-UX operating system does not support SCSI-2 media changer device commands. Therefore, an

installed DLT7 mini-library can not be utilized in random access mode and can only be accessed in

sequential mode. Refer to the DLT1/DLT7 Install and Operations Guide for detailed description of these

access modes.

Andere Handbücher für DLTtape DLT1

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Quantum Lagerung Handbücher

Quantum

Quantum ActiveScale X100 Bedienungsanleitung

Quantum

Quantum Scalar LTFS Gebrauchs- und Pflegehandbuch

Quantum

Quantum DXi6900 Kurzanleitung

Quantum

Quantum DXi4500 Bedienungsanleitung

Quantum

Quantum LTO-4 (Model B) Bedienungsanleitung

Quantum

Quantum DLTtape SDLT 600 Bedienungsanleitung

Quantum

Quantum QDFLD25-***MUH1I Series Bedienungsanleitung

Quantum

Quantum P4000 Series Montage- und Bedienungsanleitung

Quantum

Quantum QXS-312 Technisches Handbuch

Quantum

Quantum PX502 Referenzhandbuch

Quantum

Quantum DLTtape DLT 2000 Bedienungsanleitung

Quantum

Quantum P4000 Series Bedienungsanleitung

Quantum

Quantum Quantum Atlas 10K II 9.2/18.4/36.7/73.4 GB Bedienungsanleitung

Quantum

Quantum DPM 5500 Bedienungsanleitung

Quantum

Quantum StorNext QD7000 Bedienungsanleitung

Quantum

Quantum QXS G2 Series Betriebsanleitung

Quantum

Quantum ValueLoader LTO-2 Bedienungsanleitung

Quantum

Quantum StorNext QD7000 Handbuch

Quantum

Quantum A-Series FTP Bedienungsanleitung

Quantum

Quantum DLTtape SDLT 220 Bedienungsanleitung

Quantum

Quantum DXi6900 Bedienungsanleitung

Quantum

Quantum DLT-S4 Bedienungsanleitung

Quantum

Quantum StorNext QD7000 Installations- und Betriebshandbuch

Quantum

Quantum DLTtape DLT 4000 Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

HP StorageWorks MSL2024 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

HP P9000 Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung