Page 3For technical questions, please call 1-888-866-5797.Item 63917
Instructions for Putting into Use
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Functions
Decrease
Torque
Increase
Torque
Memory
PowerPeak and Trace
LED
Light
Anvil
Display
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
1. Securely fasten Adapter to ratchet.
2. Attach an adapter to end of anvil,
if desired. Once fastened, press the Power
button to activate the Adapter. The LCD
Display will show “trACE” and “PtoP.”
3. After two seconds, the Display will show “00.0”.
4. Swing the Adapter. The Display will
show the measured torque.
5. Note: If you do not use the Adapter for 70
seconds, the Adapter will automatically shut off.
6. Press the Memory (“M”) button and the “P/T” button
at the same time to select the desired torque unit.
7. The Adapter contains three unit
selections: kg-m, ft-lb and N-m.
8. To increase the current torque value,
press and hold down the Increase (“+”)
button until value is reached.
9. To lower the current torque value,
press and hold down the Decrease (“-”)
button until value is reached.
10. Note: The Display will show “00.0” if no
selection is made after ten seconds.
11. During operation, the LED light will flash GREEN.
12. Once you are 20% away from targeted torque, the
LED will flash YELLOW and the buzzer will beep.
13. When targeted torque is reached, the LED will
change to RED and a long buzz will sound.
14. To set peak torque, press and release
the “P/T” button when Adaptor is on.
15. The Display will show “PtoP” and
then “00.0” two seconds later.
16. To trace torque setting, press
and release “P/T” button.
17. The Display will show “trACE” and
then “00.0” two seconds later.
18. To store a torque reading, have the Adapter
in “PtoP” mode. When you use it, the Adapter
can store the reading automatically.
19. Press the Memory button. The Display Panel
will show the stored reading as “P01”.
20. To show the second stored reading, press the
Memory button again for one second. The second
torque value will be designated as “P02”.
21. The Adapter can store up to fifty torque
values, the highest being “P50”.
22. Note: “P50” will be the most recent saved
setting while “P01” will be the oldest.
23. If the torque setting is exceeded by 125%, the
LED will flash RED and the alarm will beep.
24. WARNING! Do not press the Memory and
Power buttons at the same time. This will
calibrate the tool and alter the preset values.
25. To turn off the Adapter, press the Power button
OR wait for the Adapter to turn off automatically.
26. Clean, then store the tool indoors
out of children's reach.
