RCA WHR120RS Installationsanleitung
Thank you for choosing RCA Wireless Headphones. You have selected
a fine product designed to provide years of performance. Before
attempting to use your Wireless Headphones, please remove all parts
from the box and read the installation and use instructions carefully.
STEREO INFRARED
HEADPHONE
Limited 1 Year Warranty WHR120RS
wireless
HEADPHONES
WITH FLAT TRANSMITTER
WHR120RS_IB 7/3/02 8:49 AM Page 1
2
2
This infrared (IR) wireless headphone system transmits stereo sound
signals throughout the room allowing you to enjoy music or sound
privately from any audio or video device. With a range of up to 25
feet, you may have freedom from wires while listening to your TV,
video or audio CD in the same room. Just connect the transmitter to
any stereo receiver, TV, DBS, DVD, or CD device and enjoy clear
stereo sound from across the room!
HEADSET SAFETY
•Do not play your headset at high volume.
Hearing experts advise against continuous extended play.
•If you experience a ringing in your ears, reduce the volume or
discontinue use.
•Make sure the volume level of the headphone is set at a
comfortable listening level before placing it in position over
IR stereo transmitter
IR stereo headphone
AC/DC adapter
6.3 mm stereo adapter
Rechargeable batteries
Instructions for use
THE FOLLOWING COMPONENTS ARE INCLUDED:
• Transmits the stereo audio signal from your audio or video
source to your IR headphone without wires
• Uses high-frequency IR signals to carry audio signal,
ensuring clear, sharp reception
• Rechargeable batteries for powering the headphones
FEATURES
INTRODUCTION
WHR120RS_IB 7/3/02 8:49 AM Page 2
3
ON THE IR STEREO TRANSMITTER (see figure 1 below)
1. IR transmitting LEDs,to transmit the audio signal to the IR
headphone
2. Power on/off switch
3. DC input connector, to power the IR transmitter
4. Recharge cable, to charge the batteries of IR headphone
5. Input stereo audio signal cable with 3.5 mm jack connector
3
Figure 1
ON THE STEREO HEADPHONE RECEIVER (see figure 2 below)
6. Power on/off LED indicator
7. Volume control
8. Power on/off switch
9. IR sensors, to receive IR signals from the transmittes
10. Recharge cable input socket to recharge the batteries of
the IR headphone
11. Charge LED indicator
Figure 2 10
8
7
9
6
(FRONT)
(BACK)
32
4
5
11
EXPLANATION OF CONTROLS
1
RIGHT LEFT
WHR120RS_IB 7/3/02 8:49 AM Page 3
4
2. Insert the connector of the AC/DC adapter into the 12V DC input
connector on the rear of the IR transmitter (see figure 3 above).
3. Plug the adapter into a 120 Volt wall outlet.
4. Remove the soft earpads from the earcups by gently lifting them
up. They have plastic tabs that hold them in place to the inside of
the earcup. See figure 4 which illustrates the soft earpads
separated from the earcup on the headset. Insert the two
rechargeable batteries (AAA size) into the left and right battery
compartments, ensuring that the polarity is correct (see figure 4).
Replace the earpads by snapping them back in place on the
earcups. The plastic tabs on the soft earpads must be matched
correctly with the slots in the earcups.
5. Note: Before using the IR headphone for the first time, please
ensure that batteries are fully charged (for 16 hours). This will
guarantee a longer operating life for the batteries.
4
1. Connect the audio signal cable located on the back of the
transmitter to the headphone jack of your audio source. This
headphone jack is located on the front panel of most TVs and
stereo receivers. Insert the plug on the audio signal cable into the
headphone jack. Use the plug adapter included in this package if
the jack is the 1/4” (6.3 mm) size. If you wish to connect
directly to the “AUDIO OUT” jacks that are standard on most
equipment, then you must purchase a seprate adapter with the
phono plugs at your local dealer.
3.5 mm STEREO PLUG
AC
SOCKET
DC
ADAPTER
AUDIO
CABLE
RECHARGE
CABLE
Figure 3
TO AUDIO
SOURCES
6.3 mm STEREO
ADAPTER
INSTALLATION
RIGHT
WHR120RS_IB 7/3/02 8:49 AM Page 4
5
5
1. Switch on the (IR) transmitter and position it in a location at
approximately the same height as that of the headphone when
it will be in use. This system operates using IR light signals
that are invisible to the human eye. It is important for the per-
formance of the unit to have the transmitter and headphone at
about the same height for optimum reception. Placement on top
of a TV or bookshelf at a height of approximately 4 feet should
be sufficient.
2. Make certain that there are no obstructions that may block the
IR signals that are emitted from the translucent plastic window
on the front of the transmitter. The headphone must receive
these signals clearly for best performance.
3. Slide the switch on the headphone to “ON”.
4. Before placing the headphone over your ears, listen to the
volume from the earcups to make certain that the volume is not
too loud before placing the unit on your head (see page 2).
Adjust the volume as needed with the volume control thumb
wheel located on the “RIGHT” earcup. Once the volume level is
at a comfortable setting, place the headphones over your ears
and adjust the volume as desired.
Figure 4
OPERATION
EARPAD AND
BATTERY COVER
AAA SIZE BATTERY
WHR120RS_IB 7/3/02 8:49 AM Page 5
6
6
1. Switch off the power of the headphone before charging.
2. Note: Before using the IR headphone for the first time, please
ensure that the batteries are fully charged (for 16 hours). This
will guarantee a longer operating life for the batteries.
3. Connect the recharge cable located on the back of the
transmitter into the charge input of the headphone.
4. The charge indication Green LED on the headphone will light
to indicate that the batteries are charging.
5. The batteries are fully charged after charging for at least 16
hours. Do not charge the batteries longer than 24 hours as
this will reduce battery performance. After charging, discon-
nect the headphone from the recharge cable.
1. Place the transmitter unit so that the front of the IR transmitter
approximately faces the center of your listening area (see
figure 5 on page 7).
2. Because IR light travels in a straight line, place the transmitter
at the same height, or slightly higher than the reception height,
of the headphone.
3. High IR light content such as sunlight and bright indoor lighting
may degrade the audio signal and cause interference. If you
experience such problems, simply move the system to a darker
area away from the source of the bright light.
RECHARGING
POSITIONING OF IR TRANSMITTER
WHR120RS_IB 7/3/02 8:49 AM Page 6
7
7
Figure 5
35°35°
25 FT.
IR TRANSMITTER
OPTIMUM
LISTENING RANGE
HEADPHONES
RANGE OF
TRANSMITTER
WHR120RS_IB 7/3/02 8:49 AM Page 7
8
8
Thomson multimedia Inc. warrants that for 1 year from date of pur-
chase, it will replace this product if found to be defective in materi-
als or workmanship. Return it postage prepaid to the Product
Exchange Center address for prompt, no charge replacement with a
current equivalent. This replacement is Thomson multimedia Inc.’s
sole obligation under this warranty. Thomson multimedia Inc. will
not be responsible for any incidental or consequential damages, or
for any loss arising in connection with the use or inability to use this
product. Some states do not allow the exclusion or limitation of inci-
dental or consequential damages, so the above limitation or exclu-
sion may not apply to you. This warranty excludes defects or dam-
age due to misuse, abuse, or neglect. This warranty gives you spe-
cific legal rights, and you may also have other rights, which vary
from state to state.
LIMITED 1 YEAR WARRANTY
© 2001 Thomson multimedia Inc.
Product Exchange Center
11721 Alameda Ave.
Socorro, TX 79927
PWHR120RSI/B Rev0501
Trademark(s) ® Registered
Marca(s) Registrada(s)
Made In China
www.rca.com
System : Infrared (IR)
Carrier frequency : Left channel 2.3 MHz
Right channel 2.8 MHz
Modulation : FM
Power supply transmitter : 200mA, 12V DC
Power supply headphone : 2 X AAA rechargeable batteries
Frequency response : 40 - 12,000 Hz
S/N ratio : 50 dB
Distortion : 1% THD
Channel separation : 40 dB
SPECIFICATIONS
WHR120RS_IB 7/3/02 8:49 AM Page 8
Inhaltsverzeichnis
Andere RCA Kopfhörer Handbücher
RCA
RCA 900 MHz Bedienungsanleitung
RCA
RCA HP59MIC Bedienungsanleitung
RCA
RCA WHP141 - WHP 141 - Headphones Bedienungsanleitung
RCA
RCA WHP145 Bedienungsanleitung
RCA
RCA WHP170 Bedienungsanleitung
RCA
RCA WHP150 Bedienungsanleitung
RCA
RCA WHP140 Installationsanleitung
RCA
RCA WHP141 - WHP 141 - Headphones Bedienungsanleitung
RCA
RCA WHP160 Bedienungsanleitung
RCA
RCA RC59i Bedienungsanleitung
RCA
RCA HP350 Gebrauchs- und Wartungshandbuch
RCA
RCA WHR120 Bedienungsanleitung
RCA
RCA WHP140 Bedienungsanleitung
RCA
RCA WHP170 Bedienungsanleitung
RCA
RCA HPNC - 050 - Headphones Bedienungsanleitung
RCA
RCA WHP151 Bedienungsanleitung
RCA
RCA Casque sans fil CWHP160 Bedienungsanleitung
RCA
RCA WHP150 Bedienungsanleitung
RCA
RCA WHR 100 Bedienungsanleitung
