Red Arrow FLSMD50Y-1 Bedienungsanleitung

PAGE 2 (TWO - INSIDE DPS)

FLSMD Site Flood Multi-voltage

Product Codes: FLSMD50Y1, FLSMD100Y1, FLSMD150Y1,

FLSMD200Y1

Box Contents -

1 x LED SMD Yellow Floodlight

Dimensions:

FLSMD50Y-1: L: 310 x W: 310 x D: 65mm

FLSMD100Y-1: L: 320 x W: 320 x D: 90mm

FLSMD150Y-1: L: 365 x W: 370 x D: 94mm

FLSMD200Y-1: L: 425 x W: 410 x D: 110mm

Material: Body: Die-Cast Aluminium

Lens: Tempered Glass

Colour

Temperature: 6500k

CRI: Ra70

LED Lifetime: 35,000 Hrs

Beam Angle: 120° Symmetrical

IP Rating: IP65

Ik Rating: IK07

Working

Temperature: -20°C - 40°C

Power Factor: 0.9

Guarantee: 3 Years

Safety Warning

• The installation should be carried out

by a qualied electrician in compliance

with the current edition of the IEE

Wiring Regulations.

• Prior to installation, carry out the

necessary risk assessment considering

the people who could be at risk,

the level of risk and the precautions

required to control the risk

• Ensure that the circuit supply is

isolated either by the circuit supply

fuse being removed or the applicable

circuit breaker being turned o before

installation or any maintenance.

• Check the total load on the circuit

ensuring the luminaire does not exceed

the rating of the circuit cable, fuse or

circuit breaker.

• Long-term use and voltage uctuations

can reduce the life span of the tting.

• If the tting incorporates control gear,

ensure careful sizing to avoid instances

of nuisance tripping of the protective

device used in the installation.

• Follow the provided installation

instructions, using the xings supplied

or recommended.

• Keep out of reach of children.

86-

264V

IP65

YRS

GUARANTEE

INSTALLATION INSTRUCTIONS

IK07

PAGE 1 (FRONT PAGE)

Specication

50-

200

WATT

LED

6500K

W mm

L mm

D mm

PAGE 2 (TWO - INSIDE DPS)

PAGE 1 (FRONT PAGE)

1. Ensure there is adequate free air circulation of at least 100mm around the luminaire. All luminaires run hot. It is the installer’s responsibility to consider any

re risks and take appropriate precautions.

2. The nearest illuminated surface must be at least 0.5m from the front of the tting.

3. Do not use if the glass is broken. Replace the luminaire

4. Select an appropriate mounting position. Drill holes for xing at spacing corresponding to the holes on the ttings bracket..

5. Fix the bracket to the wall or similar hard surface with suitable xings (not included).

6. Connect the cable correctly to the supply, observing the colour-coding shown below. Ensure all electrical connections are tight with no loose strands.

Installation Instructions

• Please note this is an IP65 rated product, take care not to break any seals as this will aect it’s water resistant rating.

• Do not modify this product. Any modication to this tting will void the warranty.

• Red Arrow will not take any responsibility for any product damages caused by mounting procedures which are not in accordance with these instructions.

• These ttings comply to CE and UKCA standards.

• Powder coated nish

Additional Information

L = Brown

= Green/ Yellow

N = Blue

INS/SITE/0010/FLSMD-1/V2

T: 0800 195 0006

sales@redarrowelectrical.co.uk

Red Arrow Electrical Distribution

Cortonwood Drive, Brampton,

Barnsley, S73 0UF

redarrowelectrical.co.uk

This product is guaranteed for a period of 3 years from the date of purchase. The guarantee is invalid in the case of improper use, tampering, removal of the Q.C.

date label, installation in an improper working environment or installation not according to the current edition of the I.E.E. Wiring Regulations (BS7671). The

guarantee is also invalidated if the luminaire has been insulation tested. Should this product fail during the guarantee period it will be replaced free of charge,

subject to correct installation and return of the faulty unit. We do not accept responsibility for any installation costs associated with the replacement of this

product. Your statutory rights are not aected. We reserve the right to alter specications without prior notice.

• This tting will require routine cleaning if used in adverse (dust, paint, welding, oils etc) environments. Do not use solvents, aggressive detergents or

abrasives.

• The light source & driver in this luminaire can be replaced at end of life. This should be carried out by a competent person. Contact Red Arrow for details of

replacements.

Guarantee

Maintenance

• When this tting comes to the end of it’s life or you choose to replace it, please do not dispose of it with your normal waste. Please recycle where the

facilities exist, check with your local authority for suitable options.

Dieses Handbuch passt für folgende Modelle

Andere Red Arrow Scheinwerfer Handbücher