2
Drawing No. LP1112 Effective 07 2020
DA70 INSTALLATION
1. Prior to installing the Sled(s) for your DA70 Controller
application, ensure that the Controller is not receiving power.
2. Remove the carriage from the Controller case by releasing the
two retaining latches and pulling straight out from Controller.
3. Remove blank panel from the carriage slot of the target sled
installation location.
4. Install sled by aligning the two sled mounting hole fasteners,
with the controller mounting posts. Be sure locating holes on
bottom side of sled align with the locating pins on the
carriage, and the sled sits flush against the carriage.
5. Hand tighten the sled captive fasteners, or use a screwdriver
if necessary.
6. Repeat the above steps for any additional sleds.
7. Carefully align the carriage with Controller base and press
carriage into the controller.
8. Close the retaining latches to ensure the carriage is fully
seated into the Controller case.
CONFIGURING THE DUAL ETHERNET SLED
DA50N CONFIGURATION
The Dual Ethernet Sled is configured using the web GUI. For
configuration and troubleshooting information, please refer to
the DA50N Software Manual for troubleshooting steps at
www.redlion.net/support/documentation.
DA50A or DA70A CONFIGURATION
The Dual Ethernet Sled is configured using the web GUI or
Crimson 3.2 (or later) software. Find additional information in the
Crimson 3.2 User Manual.
LEDs
STS LED
The STS LED provides status for the Dual Ethernet Sled. Refer
to the software user manual for more detailed information of
possible LED statuses.
LED COLOR(S) MEANING
YELLOW solid Link established.
YELLOW flashing Data being transferred.
GREEN (OFF) 10 BASE-T Communications
GREEN (ON) 100 BASE-TX Communications
RED LION CONTROLS TECHNICAL SUPPORT
If for any reason you have trouble operating, connecting, or
simply have questions concerning your new unit, contact Red
Lion’s technical support.
Support: support.redlion.net
Website: www.redlion.net
Inside US: +1 (877) 432-9908
Outside US: +1 (717) 767-6511
Red Lion Controls, Inc.
20 Willow Springs Circle York, PA 17406
ORDERING INFORMATION
PART NUMBER DESCRIPTION
DAS00PN1EE200000 Dual Ethernet Sled
COPYRIGHT
©2020 Red Lion Controls, Inc. All rights reserved. Red Lion
and the Red Lion logo are trademarks of Red Lion Controls,
Inc. All other company and product names are trademarks of
their respective owners.
CAUTION: Failure to properly align the carriage can
result in damage to the Sled connector pins.
ATTENTION: Si le chariot n’est pas correctement
aligné, les broches du connecteur du chariot
risquent d’être endommagées.
LIMITED WARRANTY
(a) Red Lion Controls Inc. (the “Company”) warrants that all
Products shall be free from defects in material and workmanship
under normal use for the period of me provided in “Statement
of Warranty Periods” (available at www.redlion.net) current at
the me of shipment of the Products (the “Warranty Period”).
EXCEPT FOR THE ABOVE-STATED WARRANTY, COMPANY
MAKES NO WARRANTY WHATSOEVER WITH RESPECT
TO THE PRODUCTS, INCLUDING ANY (A) WARRANTY OF
MERCHANTABILITY; (B) WARRANTY OF FITNESS FOR
A PARTICULAR PURPOSE; OR (C) WARRANTY AGAINST
INFRINGEMENT OF INTELLECTUAL PROPERTY RIGHTS OF
A THIRD PARTY; WHETHER EXPRESS OR IMPLIED BY LAW,
COURSE OF DEALING, COURSE OF PERFORMANCE, USAGE
OF TRADE OR OTHERWISE. Customer shall be responsible for
determining that a Product is suitable for Customer’s use and that
such use complies with any applicable local, state or federal law.
(b) The Company shall not be liable for a breach of the warranty
set forth in paragraph (a) if (i) the defect is a result of Customer’s
failure to store, install, commission or maintain the Product
according to specicaons; (ii) Customer alters or repairs such
Product without the prior wrien consent of Company.
(c) Subject to paragraph (b), with respect to any such Product
during the Warranty Period, Company shall, in its sole discreon,
either (i) repair or replace the Product; or (ii) credit or refund the
price of Product provided that, if Company so requests, Customer
shall, at Company’s expense, return such Product to Company.
(d) THE REMEDIES SET FORTH IN PARAGRAPH (c) SHALL
BE THE CUSTOMER’S SOLE AND EXCLUSIVE REMEDY AND
COMPANY’S ENTIRE LIABILITY FOR ANY BREACH OF THE
LIMITED WARRANTY SET FORTH IN PARAGRAPH (a).
BY INSTALLING THIS PRODUCT, YOU AGREE TO THE TERMS
OF THIS WARRANTY, AS WELL AS ALL OTHER DISCLAIMERS
AND WARRANTIES IN THIS DOCUMENT.
