Red20Rc R220 Bedienungsanleitung
R220 Mini H Quadcopter
&
R220 Pro MiniQuad
© Red20RC 2014
2
© Red20RC 2014
3
Thank you for purchasing the R220 Mini H Quadcopter!
We hope you have a lot of fun building and flying this miniquad.
REMEMBER
RC Aircraft are not toys! This is a complicated flying machine that
requires skill to build and fly. Whilst the R220 Mini H Quad is a stable
and capable flyer, it is not really intended for new pilots.
Make sure you know the rules for the country you are flying in. If in
doubt, seek help from an experienced pilot.
© Red20RC 2014
4
© Red20RC 2014
5
The R220 Mini H Quad is supplied in kit form and contains everything you need
to complete the frame:
Top, bottom and belly plates
X4 arms
FPV camera mounting plate
HD camera vibration isolation plate
A complete fixings and fasteners pack
Although quality is our primary focus, if you find a part is missing or broken
© Red20RC 2014
6
The R220 is not aimed at beginners so it is likely you already have a pretty good
idea of what you are going to use for this build. As a general rule you will need:
Motors –1806 size, 2300kv
ESCs –SimonK flashed 12A
Props –Gemfan 5030 2 blade
Flight controller –Naze32 Acro recommended
Radio receiver
FPV camera and transmitter
Battery –1300mah 30C 3S LiPo recommended
HD recording camera to capture your exploits!
Motors: RCTimer 1806-2300KV Multi-Rotor Motor
ESCs: RCTimer ESC12A SimonK Firmware Speed Controller
Flight Controller: SpiritFly32 Standard or AfroFlight Naze32
Propellors: Gemfan 5030
Battery: Turnigy 1300mah 3-cell 30C
Receiver: FrSky Delta 8
Flight Camera: Turnigy IC-120NH Mini CCD Video Camera or 1/3-inch
SONY CCD Video Camera (or similar)
Video Transmitter: ImmersionRC 5.8Ghz Audio/Video Transmitter with
ImmersionRC 5.8GHz Circular Polarized SpiroNet Antenna V2
Battery Strap
SMA to SMA Flexible Extender
HD Camera: Mobius Action Camera (Lens B)
© Red20RC 2014
7
Heat up the soldering iron, you’re going to be using it a lot!
The first thing to do is work out how you are going to distribute power through
your frame. For the prototype we used the Mini Power Distribution Board from
Hobbyking as this is the same form factor as the flight control board mounting
holes so can be easily secured.
Run your wires through the hole in the base plate to keep things neat. You
should be able to sandwich the PDB and wiring between the bottom and belly
plates when you are done.
© Red20RC 2014
8
Complete the wiring by adding any additional components and your power input
connector.
Here we have added two LED strips to help with orientation and an XT60
connector.
© Red20RC 2014
9
Mount the four center standoffs to the base plate using four M3 10mm nylon
screws. It is important to do this now as you won’t be able to access the screw
heads once the belly plate is installed.
© Red20RC 2014
10
Install the belly plate and arms using the M3 10mm steel screws and lock-nuts.
For the prototype we only actually used 8 screws but 16 are provided for extra
security and strength. We have also supplied washers to go underneath the lock-
nuts although using these is entirely optional and can be omitted if preferred.
If you have used a PDB, you can secure this in place using the screws and
standoffs supplied to mount your flight controller.
Andere Red20Rc Quadcopter Handbücher
