Resson
Technologies Precautions
Precautions
For your protection, please read these safety instructions completely before operating the
appliance.
Selection of mains voltage●
The Digital readout unit is supplied for 100V 230V, 50Hz/60Hz, 20W max operation.～
Instructions prior to activation of unit
1. Please ensure that the voltage rating corresponds to the mains supply prior to activation.
2. If this unit is to be operayed via an autotransformer from mains supply of higher voltage,
it must be ensured that the low end of the transformer is connected to the neutral wire
of mains.
The mains connector may only be inserted into a socket with earthing contact. The protective●
effect should not be cancelled by an extension lead without an earthed conductor.
Any interruption of the earthed conductor either inside or outside of the unit or
disconnection of the earthed conductor can render the equipment potentially dangerous.
Any intentional break is not permissible.
Please install the Linear Encoder finish after that switch on the Digital Readout Unit. If●
switches on Digital Readout Unit before install the Linear Encoder not finished yet. This may
cause electronic parts burnt away of the Linear Encoder.
Do not use the instrument in an extremely hot or humid place.●
Do not use the instrument near strong magnetic or magnetic field noise place. This is the●
main reason that causes instrument error working.
Wipe the Digital readout unit surface with a soft cloth to remove fingerprints, dust, etc.●
Clean the Digital readout unit surface with a soft cloth slightly moistened with Neutral●
purger to remove serious dirt.
Do not use the organic solvent products such as oil, diesel fuel, kerosene, alcohol,etc clean●
the Digital readout unit.
Do not use the Air guns fanned Digital readout unit and Linear Encoder accessories to let●
grease, dust or bits get into the Digital readout unit. This may cause the system working
unstable and malfunction.
