Rexing S1 Pro Bedienungsanleitung

S1 Pro

User Manual

The information in this manual is subject to change without notice.

www.rexingusa.com

Notice

Menu Setup Operation: The menu is to be set up in non-video mode. If the

device is in video mode, proceed after stopping the video recording.

Memory card: A new card must be formatted to the device before use.

Continuous image recording for long periods of time may produce protected

files that are not subject to long-term protection (these files may not be

overwritten during loop recording) and storage fragments, which need to be

cleared regularly in order to save stable storage space.

Standard Voltage for On-board Charger: Standard input voltage is configured

at 12V. If a charge voltage greater than 12V is found, contact your dealer or

our service center to replace it with an applicable charger. An OEM charger

must be used.

Parking Monitor: Do not enable this function during driving. When it is enabled,

repeated start/stop recording may affect the integrity of your video.

Do not install the device within the range that could be impacted by airbag or

in a location that interferes with the driver’s view or other safe operation of the

vehicle. Make sure it is securely mounted.

The features described in the operation manual are available for all products

of the same type. Your model may have come with optional or additional

functions. Menu operations may vary. Please refer to the instructions that

apply to your actual product.

The battery (module or pack) must not be expose to an overheat

environment such as direct sunlight or flame.

Never remove, strike, or squeeze the battery or put it in fire. Stop

using the battery if it is ballooned, warped, leaking, or shows any

other visible signs of damage.

Warning

Thank you for choosing REXING! We hope you love your new products as

much as we do.

If you need assistance, or have any suggestions to improve it, please contact

us. You can reach us via

Our support team will respond you as soon as possible.

•https://www.facebook.com/rexingusa/

•https://www.instagram.com/rexingdashcam/

•https://www.rexingusa.com/support/registration/

Overview

Thank you for choosing REXING!

Check us out here.

Facebook Instagram Site Product Support

[email protected]

(877) 740-8004

What’s in the box?

S1 Pro

User Manual

The information in this manual is subject to change without notice.

www.rexingusa.com.

132 4

5678

1. Rexing S1 Pro Dash Camera

2. Rear Camera with Extension

Cable (20ft)

3. Free Smart Hardwire Kit

4. GPS Logger

5. 3M Adhesive Mount

6. USB Computer Cable

7. Cable Management Tool

8. Quick Start Guide

Table of Contents

Camera Overview

Installation

Basic Operations

Mobile Connection

GPS Player

Product Specifications

General Troubleshooting 31

Warranty and Support 32

Camera Overview

I. Visual Features

1. Menu/Mode Button

2. Record/Up Button

3. Power Button

4. Down/Toggle Button

5. OK Button

6. Power Cord Connection Port

7. Rearview Camera Connection Port

8. Reset Pinhole

GPS

Socket

USB 5V

Socket

Smart

Hardwire

Kit Socket

Rearview

Camera

Socket

IR light

Cabin Camera

Front Camera

6 7

8123 4 5

Note:

GPS is an optional feature, needs to connect to the included GPS Logger. The S1 Pro does not

support memory expansion.

1. In standby mode, press this button to start/stop the related menu

options such as recording mode, photography mode, playback mode.

2. In recording mode, press and hold the button for 3 second to enter

picture-taking and playback interface. Depress it again to exit.

Buttons

Buttons and Description

M Button

(Menu/Mode

Switch)

1. In standby mode, press this button to start/pause video recording.

2. Video Mode: Depress this button to start/stop audio recording.

3. The button is defined for page up in menu setup and playback mode.

4. During playback, press the button shortly to play fast rewind.

Record/Up/MIC

Button

1. Press this button to start the device. Depress it for 3 seconds to power

off the device.

2. In power-on state, press the button shortly to turn off/on screen

backlight.

Power Button

1. This button is defined for page down in menu setup and playback mode.

2. Press this button to switch between front/rear camera view and PIP

display.

3. During playback, press the button shortly to play fast forward.

4. In video mode, depress the button to switch the IR light to

OFF/ON/AUTO.

Down/Toggle

Button

Description

1. This button functions as a confirmation in each of the setups.

2. In video recording, press this button to start emergency recording.

3. Depress this button to switch Wi-Fi on/off.

4. In photography mode or playback mode, press the button to take a

picture or play back a file.

OK Button

Power charging port/USB data cable portUSB Port

Power cable connection port

Power Port

Rearview Camera Connection PortRearview Camera

Connection Port

If the system crashes, use a pin to reset the system.Reset Pinhole

1. Turn off the car’s engine.

2. Secure the dashcam to a place close to the original rearview mirror.

3. Plug the GPS module into the GPS port and secure the module to a position close

to A-pillar of the car. The antenna receiver side (the side without 3M adhesive)

faces the outside and the side with 3M adhesive faces down. It should be properly

secured.

4. Plug the charger into the car’s cigarette lighter. Connect the device to the cigarette

lighter through the car charger.

Installation

The charger extension cable can be wired along the edge of the windshield during

installation. The optional rearview camera should be mounted on the rear

windshield of the car. Pay attention to its orientation during installation. It can be

wired against or above the interior’s headliner. Plug the rearview camera

connector into its rear camera port of the device once the camera is securely

mounted. Adjust the position of the lens to make sure that it remains horizontal

with the ground. Start the engine to check the video operation of your device.

Note:

Andere Handbücher für S1 Pro

Inhaltsverzeichnis

Andere Rexing Dashcam Handbücher

Rexing

Rexing V1 Bedienungsanleitung

Rexing

Rexing MTC1 Bedienungsanleitung

Rexing

Rexing V2 PRO Bedienungsanleitung

Rexing

Rexing V5C Bedienungsanleitung

Rexing

Rexing V33 Plus Bedienungsanleitung

Rexing

Rexing M1 Bedienungsanleitung

Rexing

Rexing V55 Bedienungsanleitung

Rexing

Rexing W303 Bedienungsanleitung

Rexing

Rexing M1 Bedienungsanleitung

Rexing

Rexing V1P Pro Bedienungsanleitung

Rexing

Rexing S1 Bedienungsanleitung

Rexing

Rexing GW101 Bedienungsanleitung

Rexing

Rexing S800 Bedienungsanleitung

Rexing

Rexing M2 Bedienungsanleitung

Rexing

Rexing R1 Bedienungsanleitung

Rexing

Rexing V1 Max Bedienungsanleitung

Rexing

Rexing V360 Bedienungsanleitung

Rexing

Rexing V5 Bedienungsanleitung

Rexing

Rexing V1P Bedienungsanleitung

Rexing

Rexing S1 Pro Bedienungsanleitung

Rexing

Rexing V33 Plus Bedienungsanleitung

Rexing

Rexing V2 Bedienungsanleitung

Rexing

Rexing V1 Bedienungsanleitung

Rexing

Rexing V1P SE Bedienungsanleitung

Beliebte Dashcam Handbücher anderer Marken

Cansonic

Cansonic UltraDuo Z2 Bedienungsanleitung

Gazer

Gazer F720 Bedienungsanleitung

HP f500g Bedienungsanleitung

Xblitz

Xblitz TANGO 4K Bedienungsanleitung

Maka Technologies

Maka Technologies Marbella MXPro Bedienungsanleitung

NESA

NESA NRC-80DLM Montage- und Bedienungsanleitung

Kaiser Baas

Kaiser Baas R20 Bedienungsanleitung

Boyo

Boyo VTM43TC Bedienungsanleitung

Minolta

Minolta MNCD37 Bedienungsanleitung

Thinkware

Thinkware FA10 Bedienungsanleitung

Momento

Momento MD-5200 Bedienungsanleitung

BlackVue

BlackVue DR590X-1CH Bedienungsanleitung

HP F300 Bedienungsanleitung

CammSys

CammSys BlackSys BH-300 Bedienungsanleitung

Snooper

Snooper DVR-2HD Bedienungsanleitung

Lukas

Lukas Q900 Bedienungsanleitung

RVS

RVS 450C Bedienungsanleitung

BlackVue

BlackVue 750G PRO Referenzhandbuch