Ricoh Priport vt3600 Bedienungsanleitung

PRIPORT VT3600

Operating Instructions

-——~— —..——.

For good print quality, Ricoh recommends that you use genuine Ricoh master

and ink.

IRicoh shall not be responsible for any damage or expense that may result from

the use of parts other than genuine Ricoh parts in your Ricoh office product. ,

Power Source: 120V ,60Hz ,more than 4.1A

Please make sure to connect the power cord to apower source as above. For

sabout power connection, see page 6.

Power Comsuption: Master Making :374W Printing :372W

INote: Some of the illustrations may be slightly different from your machine,

_—.— ——------

..—..——————

Safety During Operation INTRODUCTION

INTRODUCTION

This manual contains detailed instructions on the operation and care of this

machine. To get the maximum versatility from this machine, all operators should

read and follow the instructions in this manual. Please keep this manual in a

handy place near the machine.

SAFETY INFORMATION

When using your machine, the following safety precautions should always be

followed.

Safety During Operation

In this manual, all safety messages are identified by

“Caution”. These words mean the following:

WARNING:

Important information to alert you to asituation

injury and damage to your property if instructions

Caution:

Important information on how to

avoid asituation that might cause

-WARNING -

prevent damage to

minor injuty.

the words “WARNING” and

that might cause

are not followed. serious

your equipment, or how to

IJ Do not modify or replace any parts other than the ones specified in this

manual.

CJSince some parts of the machine are supplied with high voltage, touch

on/y the parts specified in this manual.

IJ Do not operate the machine without covers. You might get your fingers

caught in the machine, or the machine might be damaged because of

something, such as dust, getting inside it.

IJ Since some parts of the machine are sharp and might cause injury,

touch only the parts

–Caution –

I_JWhile copying, do not

CIWhile copying, do not

specified in this manual.

turn off the main switch.

open the door.

SAFETY INFORMATION General Safety Information

IJ While copying, do not unplug the power cord.

~While copying, do not move the machine.

CJKeep corrosive liquids, such as acid, off the machine.

CJDo not allow paper clips, staples, or other small objects to fall inside the

machine.

#Open and close the door and covers softly.

fJ Do not put anything except originals or command sheets on the machine.

nDo not spill liquid on the machine.

~When you open or close the door or cover, don’t let go of them.

~When you open or close the platen cover or optional document feeder, be

careful not to pinch your fingers between the platen cover or document feeder

and the back cover.

IJ If you clean rubber parts with benzine, wipe them with adry cloth afterwards.

General Safety Information

~Always turn the machine off when you have finished printing for the day.

uWhen the machine will not be used for long periods, disconnect the power

cord.

CI If the machine must be transported by vehicle, please contact your service

representative.

Chapter I

Machine Exterior GUIDE TO COMPONENTS

GUIDE TO COMPONENTS

Machine Exterior

Original Holder

Convenient place for

holding originals while Original Table Release

operating the machine. Lever

Use to open the original

table unit when installing

the master.

Platen Cover

Lower this cover

over an original

before printing.

Front Door

Open for access

too::i$eside of the

Feed Roller Pressure

Lever

Use to adjust the con-

tact pressure of the pa-

per feed roller accord-

ing to paper thickness.

Separation Roller

=Pressure Levers

Use to adjust the sepa-

ration roller pressure to

,prevent double feed.

rFeed Table

aper on this table

W\!1 \‘orpr’nt’ng”

IPaper Feed Side Plates

Use to prevent paper

skew.

Paper Feed Table Down

key

Press to lower the paper

feed table.

Side Plate Fine

Adjusting Dial

Use to shift the pa-

per feed table side-

ways.

GUIDE TO COMPONENTS Operation Panel

Operation Panel

Screen key Combine 2Originals

Press to select the desired key Reset key

screen image according to the Press to combine two Press to reset error

type and quality of the origi- originals onto one print indicators.

nal. See page 30. image. See page 40 and

ad.

Contrast key

Press to select the de-

sired contrast according

to the type and quality of

the original. See page 30.

Margin Erase key

Press to print book origi-

nals that have asolid

image on the edges.

See page 27.

IIII

Enhrge

pwx8xmAJd4

p8XXll ➤11 x~

➤84Jfll ➤11 X17

Reduce

➤Create M8rgln

➤8XX14 ➤8XX11

P11 X15*%X11

➤11 X17 MMX11

Full Slzo

Monitors

The monitors light up or

blink when anon-standard

condition occurs within the

machine. See page 92.

wEl db

Make Up key

Press to use the

optional Make-

up function. See

chapter 2.

Image Mode key

Press to select Line

mode, Photo mode, or

Sharpen Image mode ac-

cording to the type and

aualitv of the original.

ISee page 30 and 31.

Image Density key

Press to make

prints darker or

lighter. See page 18.

Reduce/Enlarge key

Press to reduce or en-

large the image. See

page 21.

Auto Cycle key

Use to automat-

ically process the

master and make

prints. See page

32.

Size key

Zoom keys

Press to alter the repro- Full

duction ratio in 1940in- Press to make

crements from 50’%0to prints the same

200?40.See page 24. size as the original.

TROUBLESHOOTING

When one of the following messages is displayed on the guidance display

Guidance Display

CHECK THE PAPER SIZE

PRESS MASTER KEY

RE-ENTER COPY NUMBER

MAXIMUM IS XXXX

IRE-ENTER cow NumERl

lMINIMUM IS xxxx I

200% MAXIMUM

ENLARGEMENT

50?40 MINIMUM

REDUCTION

ISET COMMAND SHEETS I

SET THE ORIGINALS

ORIGINAL IN ADF

CLOSE PLATEN COVER

IINPUT YOUR ID CODE

You can resume your operation, but

the entire image might not appear com-

pletely (paper size too small). Change

the paper size to match the print area.

The maximum number of prints that

can be entered is specified by the

Service Program mode. Change the

number of prints.

The minimum number of prints that can

be entered is specified by the Service

Program mode. Change the number of

prints.

The maximum enlargement ratio that

can be entered is 200940. If the entered

reproduction ratio is over 200?4, 200%

will be selected.

The minimum reduction ratio that can

be entered is 50?40. If the entered re-

duction ratio is under 50?4, 50?40will be

selected.

Make prints after you confirm whether

there is an original or acommand

sheet on the exposure glass.

Lower the platen cover completely or

remove originals used previously from

the document feeder before making the

master.

User Code mode is set. Before printing,

enter your user code.

GUIDE TO COMPONENTS Machine Interior

Machine Interior

Master Eject Unit

Open Button

Main Switch

P~essto remove mis-

fed paper or amisfed

master.

Use to turn the power

on or off.

Master Cut Button

Press this button to cut

the master paper leading

edge after installing a

new master roil.

*’

Master Eject Container

Cover

Open when removing the

master eject box.

Paper Delivery Side

Plates

Use to align the prints

on the paper delivery ta- ll 70!

ble. \rIN

Pressure Release

Lever

Use to install the

master roll.

111’d’

Operation Panel

T& Operator controls

!JI”k‘N and indicators are

located here.

/Drum Rotation

Paper Delivery End

m> q‘$‘ \

Button

Plate Press to replace

Use to align the leading the drum unit.

edge of prints larger than

A4, 81/2” x11”.

// ~\ ‘Drum Unit Lock Lever

Lift to unlock and pull

out the drum unit.

Small Size Paper Delivery

End Plate

Use to align the leading

edge of prints that are A4,

81/2” x11” or smaller.

/,njo,?,nzrapped

Paper Delivery Table Set the ink cartridge in

Completed prints are this holder.

delivered here.

INSTALLATION REQUIREMENTS Power Connection

Power Connection

IJ Connect the power cord to an appropriate power source (as described inside

of the front cover).

nMake sure the plug is firmly inserted in the outlet.

CIAvoid multiwiring.

~Do not pinch the power cord.

CI Make sure that the wall-outlet is near the machine and easily accessible,

Andere Ricoh Multifunktionsdrucker Handbücher

Ricoh

Ricoh P800 Bedienungsanleitung

Ricoh

Ricoh 7025 Bedienungsanleitung

Ricoh

Ricoh Aficio AP4510 Bedienungsanleitung

Ricoh

Ricoh Aficio MP 8000 Bedienungsanleitung

Ricoh

Ricoh MP W7100 Bedienungsanleitung

Ricoh

Ricoh MP 3353 Series Bedienungsanleitung

Ricoh

Ricoh 5502 Gebrauchsanweisung

Ricoh

Ricoh A172 Bedienungsanleitung

Ricoh

Ricoh Aficio 615C Betriebsanleitung

Ricoh

Ricoh 9016 Bedienungsanleitung

Ricoh

Ricoh Type 8000 Bedienungsanleitung

Ricoh

Ricoh A292 Bedienungsanleitung

Ricoh

Ricoh All in One Printer Bedienungsanleitung

Ricoh

Ricoh Aficio MP C2030 Bedienungsanleitung

Ricoh

Ricoh 5100WD Gebrauchsanweisung

Ricoh

Ricoh Aficio SP C231SF Bedienungsanleitung

Ricoh

Ricoh G133 Bedienungsanleitung

Ricoh

Ricoh Aficio MP 171F Bedienungsanleitung

Ricoh

Ricoh Aficio SP C830DN Betriebsanleitung

Ricoh

Ricoh MP C2003 Series Bedienungsanleitung

Ricoh

Ricoh Aficio 3224C Bedienungsanleitung

Ricoh

Ricoh Aficio SP 3510SF Bedienungsanleitung

Ricoh

Ricoh Aficio SP 8200DN Bedienungsanleitung

Ricoh

Ricoh Aficio SP 5210SF Bedienungsanleitung

Beliebte Multifunktionsdrucker Handbücher anderer Marken

Triumph Adler

Triumph Adler DC 2016 Handbuch

Epson

Epson WorkForce WF-2510 Benutzerhandbuch

Epson

Epson Stylus Scan 2000 Installations- und Betriebshandbuch

Epson

Epson PictureMate Snap PM 240 Bedienungsanleitung

Konica Minolta

Konica Minolta bizhub C35 Bedienungsanleitung

Brother

Brother MFC-J430w Bedienungsanleitung

Konica Minolta

Konica Minolta BIZHUB 558 Bedienungsanleitung

Lexmark

Lexmark MX710 Series Handbuch

Brother

Brother MFC-9760 Bedienungsanleitung

Lexmark

Lexmark XC8155 Bedienungsanleitung

Lexmark

Lexmark X642E Bedienungsanleitung

Sharp

Sharp MX-2310U Leitfaden

Aficio

Aficio 200 Bedienungsanleitung

Canon

Canon ImageCLASS 2300 Handbuch

Lexmark

Lexmark X925 Bedienungsanleitung

Brother

Brother Business Smart MFC-J4510dw Bedienungsanleitung

Epson

Epson Stylus CX8400 Series Bedienungsanleitung

Oce

Oce VarioLink 5022 Bedienungsanleitung

Ricoh priport vt3600 Bedienungsanleitung

Beliebte Multifunktionsdrucker Handbücher anderer Marken