Ricoh MP6200S Bedienungsanleitung

NOTICE

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate ra-

dio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communication.

However, there is no guarantee that interference will not occur in a particular

installlation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

--- Reorient or relocate the receiving antenna.

--- Increase the separation between the equipment and receiver.

--- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

--- Consult the dealer or an experienced radio / TV technician for help.

FCC WARNING

Changes or modification not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

CAUTION

Use of controls or adjustments or performance of procedures other than

those specified herein may result in hazardous radiation exposure.

a Pay careful attention not to let the invisible laser beam emitted from the

optical pickup enter into your eyes.

b When you find a troubled state of the component in the optical pickup

containing the laser diode, change to the specified new optical pickup.

Do not open the optical pickup housings.

Akustischer Geräuschpegel

Dieser Drucker überschreitet einen Geräuschpegel von 70 dB (A) während

dem Betrieb nicht.

Declaration of Conformity

“The Product complies with the requirements of the EMC Directive

89/366/EEC and the Low Voltage Directive 73/23/EEC.”

iii

Please take notice that the manufacturer of this equipment does not

offer any warranty against data loss due to inappropriate installation

or handling, or direct or indirect damages.

Please take notice that the manufacturer will bear no responsibility

for direct or indirect damages caused by the use of this product or its

malfunction.

Please take notice that the manufacturer will bear no responsibility

for damage to data caused by this product.

Please backup (copy) all important data as protection against data

loss.

PC DOS is a trademark of IBM Inc.

MS-DOS, Windows, and Windows95 are trademarks registered in

the United States and other countries by the Microsoft Corporation.

Adaptec, and the Adaptec logo are trademarks of the Adaptec Cor-

poration.

The company names and product names written in this manual are

trademarks or registered trademarks.

Multimedia Printer Series

Ricoh developed the world's first rewritable CD, the CD-Rewritable, and it

has become a commercial success.

The Multimedia Printer Series Drive (the CD-R/RW Drive) can do much more

than read and write the usual CD-R discs. When you load it with a rewritable

CD-RW disc, you can record, read, and edit any kind of data, because these

discs allow you to rewrite information that has already been recorded.

zRicoh's original completely sealed flexible-door construction pro-

vides high reliability.

zRunning OPC*1gives a flatter writing signal that improves reliabil-

ity.

zAn improved anti-heat design means that no cooling fan is needed.

zEasy-to-use tray model.

zUses the world standard SCSI II interface

zCan read not only CD-R and CD-RW discs, but also video CDs,

music CDs, and photo CDs.

zCan read data at 6x speed (900KB/sec data transfer rate) and write

data at 2x speed (300KB/sec data transfer rate).

zThe recorded CD-RW media can be played in a DVD player or

multiread CD-ROM player, maintaining future compatibility.

zSupports random UDF for easy writing to CD-RW discs.

*1 Continuously monitors the signal level during recording and adjusts the

laser power to compensate when the disc is dirty, insuring a flat signal.

Features:

The MP 6200SR Series

Thank you for purchasing the Multimedia Printer Series (Compact Disc Re-

corder/Rewriter) MP 6200S series (abbreviated CD-R/RW).

Be sure to read this manual carefully before using this product.

This manual explains everything you need to know to operate this product.

Keep it in a safe place and refer to it whenever necessary.

When connecting the CD-R/RW drive, a separate connection kit (SCSI inter-

face) and software (writing software) are needed. For details about the con-

nection kit and software, refer to the manuals for each one.

The MP 6200SR series is an easy-to-use drive.

SCSIinterface

Disc tray model

Random UDF support

CD-Rewritablecompatible

The MP 6200SR Series

Section 1

The MP 6200SR Series

2. System environment

This unit can be operated in the system environment explained here.

CPU 80486 DX2-66MHz or beter,

Pentium recommended. (PC/AT compatible)

Memory Windows 95: 16MB or greater.

Windows NT4.0:32MB or greater.

Adaptec Inc. AHA-154x, 2940, 3940,

recommended.

Hard disk with average access time of

19msec or less, and data transfer speed of

600KB/sec or greater. 75MB or more free

space.(The free space needed for writing

depends on the quantity of data.)

Windows 95,

Windows NT 4.0 (Service Pack 2) or later

Ricoh, Kao, Mitsubishi Chemical, Taiyo Yuden,

MitsuiToatsu,TDKorKodakdiscsarerecommend.

Occasionally the CD-R and CD-RW discs written by the CD-R/RW drive

cannot be read by other CD drives*1. These unreadable discs should be

read using the CD-R/RW drive.

As the power and interface environments on notebook PCs differ from

desktops, the CD-R/RW might not be supported.

The CD-R/RW drive has been confirmed to work in the following envi-

ronment:

CPU: 100-MHzPentium

OS: Windows95

SCSI Interface Card: Adaptec APA-1460A SlimSCSI

Memory: 24MB

*1 The discs written using the CD-R/RW drive might not be readable by CD-

ROMs other than Multi-read compatible (Random UDF compatible) CD-

ROMs.

Multiread compatible (Random UDF compatible) CD-ROMs are:

- CD-ROMs that can read low reflectance discs

- CD-ROMs that support Packet Write.

System

requirements

SCSI

interface

Hard disk

Software

Required OS

CD-R,

CD-RW discs

The MP 6200SR Series

3.Drive functions and settings

3.1 Front Panel

Name Function

Disc tray This is the tray for the disc. Place the disc on

the ejected disc tray, then lightly push the tray

(or push the eject button) and the CD will be

loaded.

Don't use force to pull out or push in the

disc tray. This might cause damage to

the loading section of the drive.

Eject button This is the button used to eject or bring in the

disc tray.

Volume control This is used to adjust the output volume of

the headphone jack. It can't be used to adjust

the output volume for the audio output con-

nectors on the rear panel.

Headphone jack This jack is for connecting headphones or

mini-speakers.

Power/Busy indicator This indicator light shines green when power

is on. When the disc tray or disc is being ac-

cessed, the light shines or flashes orange.

Even when a disc is loaded and a disc is not

being accessed, the light shines grean. When

a illegal disc is loaded or some hardware

trouble occurs, the indicator blinks.

Eject button

Disc tray

Headphone jack

Volume control Power/busy indicator

The MP 6200SR Series

3.2 Rear panel

Name Function

SCSI ID jumper Used when selecting the SCSI ID number.

Don't use jumpers to change anything be-

sides the SCSI ID, but keep the drive as ini-

tially set (no jumper pins: ID 0). SCSI ID

changes become valid after power is turned

off, then on again.

Installing jumper pins besides the ones

for SCSI ID settings may be the cause of

damage or abnormal drive operation.

SCSI connector Use a 50 pin double-end flat SCSI cable to

connect to the SCSI interface.

Connecting or disconnecting connectors

while power is on may result in a short

circuit, causing damage to the equipment.

When connecting or disconnecting con-

nectors, make sure to turn off the power

beforehand.

Audio output connector Used to connect to the sound card.

Power connector Used to connect to the host computer's power

supply (DC 5V).

Be careful not to reverse the power con-

nector when attaching it. A reversed con-

nection may cause damage to the equip-

ment (not covered by the warranty).

SCSI connector Power connector

Audio output

connector Terminators

SCSI ID jumper

The MP 6200SR Series

4. SCSI ID settings

Before installation, set the SCSI ID on the rear panel. A single SCSI interface

can connect with a maximum of seven peripheral SCSI devices. When using

multiple SCSI devices, a different SCSI ID must be set for each of them.

If two peripheral devices use the same SCSI ID number, it will cause

the host computer to operate abnormally or fail to start up.

ON (When the jumper is attached)

OFF (When the jumper is removed)

Before attaching or removing jumpers, make sure the power to the

drive is turned OFF.

Attach the pins as shown in Figure 1. If the pins are attached side-

ways as shown in Figure 2, the drive may be damaged.

Fig. 1 Fig. 2

The pins besides pins 2-4 don't have any function. If jumpers are

attached to them, abnormal operation may result.

Pin no.

Reserve (Fixed OFF)

SCSI ID

Reserve (Fixed OFF)

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Ricoh CD/CDR-Laufwerk Handbücher

Ricoh

Ricoh MP8040SE Bedienungsanleitung

Ricoh

Ricoh MP7400A Bedienungsanleitung

Ricoh

Ricoh MP5120A Bedienungsanleitung

Ricoh

Ricoh MP7080A Bedienungsanleitung

Ricoh

Ricoh MP7060A Series Bedienungsanleitung

Ricoh

Ricoh MP7125A Bedienungsanleitung

Ricoh

Ricoh MP7040A - MediaMaster - CD-RW Drive Bedienungsanleitung

Ricoh

Ricoh MP5163A Bedienungsanleitung

Ricoh

Ricoh MP7163A Bedienungsanleitung

Ricoh

Ricoh MP6200A Bedienungsanleitung

Ricoh

Ricoh MP7200A Bedienungsanleitung

Ricoh

Ricoh MP7083A Bedienungsanleitung

Ricoh

Ricoh MP7320A Bedienungsanleitung

Ricoh

Ricoh MP7063A Bedienungsanleitung

Ricoh

Ricoh MP7120A Bedienungsanleitung

Ricoh

Ricoh MP9120A Bedienungsanleitung

Ricoh

Ricoh MP5308D Bedienungsanleitung

Ricoh

Ricoh MP5316DA Bedienungsanleitung

Ricoh

Ricoh MP7060S Series Bedienungsanleitung

Ricoh

Ricoh MP7240A Bedienungsanleitung

Ricoh

Ricoh MP7040S Series Bedienungsanleitung

Beliebte CD/CDR-Laufwerk Handbücher anderer Marken

Philips

Philips CDD3610 Bedienungsanleitung

QPS

QPS Que!Fire Bedienungsanleitung

LG GCC-4241N Bedienungsanleitung

Plextor

Plextor 12X-3 Leitfaden

Sony

Sony CRX230AE Bedienungsanleitung

Sony

Sony CRX - 160E Bedienungsanleitung

Panasonic

Panasonic KX-LD742 Bedienungsanleitung

Pioneer

Pioneer BDR-S13U-X Bedienungsanleitung

Panasonic

Panasonic LK-MC606BP Bedienungsanleitung

Panasonic

Panasonic CF-VCW Series Bedienungsanleitung

LG CRD-8320B Bedienungsanleitung

Conner

Conner CFP2107 Series Bedienungsanleitung

Sony

Sony CRX-1611 Bedienungsanleitung

Plextor

Plextor 12-20C Leitfaden

Sony

Sony DRX-120L Bedienungsanleitung

Samsung

Samsung SC-152G Bedienungsanleitung

Philips

Philips CDD3610 Bedienungsanleitung

Yamaha

Yamaha CD Recordable/Rewritable Drive CRW3200 Bedienungsanleitung