Ricoh MP7083A Bedienungsanleitung
NOTICE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communication. However, there is no
guarantee that interference will not occur in a particular
installlation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
● Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
● Consult the dealer or an experienced radio / TV technician
for help.
Warning as to USE
This CD-R/RW drive together with software is a product for
utilizing CD-R/RW recording media with rewriting, erasing and
readout capabilities, as an external computer memory device.
Except in the case where copying of CD-ROMs or the like is
especially recognized under the copyrights laws as being for
the purpose of individual use by the customer or the like, or in
the case where the customer has obtained permission to make
copies from the rightholder, reproduction of CD-ROMs and
copyright laws. Take notice that unauthorized copying may be
subject to claims for damages and to penalties.
CAUTION
Rating voltage for peripherals.
1. Headphone Jack
Rating Voltage output Audio Signal Max. 2V
FCC WARNING
Changes or modification not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
Lower a volume
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
The volume that exceeds 70dB occurs and the obstacle
sometimes breaks out.
Declaration of Conformity
"The Product complies with the requirements of the EMC
Directive 89/366/EEC and the Low Voltage Directive
73/23/EEC."
Please take notice that the manufacturer of this
equipment does not offer any warranty against data loss
due to inappropriate installation or handling, or direct or
indirect damages.
●
Please take notice that the manufacturer will bear no
responsibility for direct or indirect damages caused by
the use of this product or its malfunction.
●
Please take notice that the manufacturer will bear no
responsibility for damage to data caused by this product.
●
Please backup (copy) all important data as protection
against data loss.
●
PC DOS is a trademark of IBM Inc.● MS-DOS, Windows, Windows ® 95, Windows ® 98, Windows NT® and Windows® 2000 are
trademarks registered in the United States and other countries by the Microsoft Corporation.
●
The company names and product names written in this manual are trademarks or registered
trademarks.
●
This manual uses the following symbols to indicate important information relating to the drive.
Failing to comply with the information in this manual and/or incorrect handling of the drive
may result in serious personal injury or damage to the product.
Indicates restriction or precaution that should be observed.
Provides useful additional information.
This manual contains important notes and product handling information. Be sure to read the
manual before using the product. For easy reference in the future, please keep the manual
at a handy location.
Multimedia Printer series
Thank you for purchasing the Multimedia Printer series drive MP7083A (hereafter referred to as the
drive). The drive enables you to play CD-ROM discs, write once and play CD-R discs, or write, play,
and rewrite CD-RW discs.
The following marks indicate media that can be used with the drive.
Obey the following cautions when handling the drive or discs.
Cautions During Installation
Install the drive in accordance with the specifications. Be careful to avoid locations likely to cause
vibration or shock.
●
Avoid locations where there is high humidity, excessive dust, or poor ventilation.●
Avoid locations in direct sunlight, with severe changes in humidity, or places where there are
extremely high or low temperature variations.
●
Don't use the drive near radio or television receivers. It may interfere with their reception.●
Do not disassemble the drive. Dismantling the drive to attempt repairs or for other reasons is
dangerous because the laser may radiate outside the unit.
●
Cautions During Use
Don't suddenly move the drive from a cold place to a warm place, or suddenly raise the room
temperature. Condensation may occur, causing abnormal operation.
●
Make sure to remove the disc before moving the drive. The disc may be damaged, causing data loss.●
Be careful to prevent foreign objects such as liquids or metal from entering the drive. Should by
chance a foreign object enter the drive, please consult the dealer where the drive was purchased.
●
Don't use benzene or thinner to clean dirt from the drive. Don't allow chemicals such as insecticides
to contact the drive. Use a soft cloth to wipe the drive, or moisten a cloth with neutral detergent
diluted with water and use it to clean particularly dirty areas.
●
Don't cutoff the electric power while the drive is operating.●
When connecting two E-IDE devices to the Primary or Secondary connectors, make sure that the two
devices are not both configured as Master, or both as Slave. If they are both set the same, Windows
may fail to run or recognize the drives.
●
The total length of the E-IDE cable should be less than 18 inches (about 45 cm).●
Make sure the power to the host computer is turned OFF before connecting.●
Never insert a damaged disc into the drive.●
In wintertime, don't use a disc soon after bringing in from outdoors. Use it only after it has reached
room temperature.
●
Cautions Concerning Disc Cleaning
Remove the disc by pressing the eject button.●
Use compressed air to clear dust from the disc. (Spray the compressed air for about 5 seconds).●
Check to see if there is dirt on the surface of the disc. Be careful not to touch the disc with the fingers
when doing this. (See Fig. 1)
●
After cleaning the disc with compressed air, place it on the disc tray and mount it.(See Fig. 2)●
We suggest using dry air cleaner as compressed air for cleaning.●
Other Cautions
When moving the equipment, make sure that the disc has been removed from the drive.●
When connecting connectors, make sure that the power is OFF. If the power is ON, there is a
possibility of short circuit.
●
When not using the drive for a long period, dust may adhere to the disc tray. Before using the drive
again, use dry air cleaner to remove the dust from the tray.
●
Completely sealed door construction provides high reliability.● An improved anti-heat design means that no cooling fan is needed.● Easy-to-use tray model.● Enhanced-IDE (ATAPI) model● Compliant with industry standard Orange Book Part II (CD-R) and Part III (CD-RW).● Can read not only CD-R and CD-RW discs, but also video CDs, audio CDs, photo
CDs*1, and CD-Text
●
Can read data at 32x speed (4.8MB/sec data transfer rate), write data at 8x speed
(CD-R, 1,200KB/sec data transfer rate.) and write data at 8x speed *2(High Speed
CD-RW, 1,200KB/sec data transfer rate).
●
The recorded CD-RW media can be played in a DVD player or a multi-read CD-ROM
Player, maintaining future compatibility.
●
Supports random UDF for easy writing to CD-RW discs.
*1 Bundled software does not support this writing format.
*2 The speed at which to write on the current standard CD-RW discs is 4x
recording (at a data transfer rate of 600KB/sec).
●
Explains the system environment required for using the drive as a CD-R/CD-RW drive.
PC IBM PC/AT compatible
Operating System Windows 98/95(OSR2 or later)
Windows NT Workstation Ver.4.0 (Service Pack 5) or later*1
Windows 2000 (Professional)*1
CPU Pentium 200 MHz or higher
Memory Windows NT (Workstation) / 2000 64MB or more (Windows 95/98 32MB or
more)
Harddisk Hard disk with average access time of 19msec or less, and data transfer speed
of 2,500KB/sec or greater. 1GB or more free space.
Interface Enhanced-IDE interface (as Primary Slave, Secondary Master, or Slave)
Drive bay 5.25-inch half height bay required
Power +5V/+12V power socket required
Recommendation discs*3 CD-R(74min): Ricoh, Mitsubishi Chemical, Taiyo Yuden, Mitsui Chemicals,
TDK and Maxell discs
CD-R(80min): Ricoh, Taiyo Yuden, TDK discs
CD-RW: Ricoh and Mitsubishi Chemical discs*2
High Speed CD-RW: Ricoh discs *2
*1 abCD does not support these Operating System.
*2 The disc written using the CD-R/RW drive may not be readable by CD-ROM drives.
Multi-read compatible (Random UDF compatible) drives are necessary.
*3 Even if it is the recommendation disc, some of discs may have possibility to fail writting with
highest writting speed with the problem on the disc. In this case, please try to write with
lower writting speed, or please try to use another disc.
Multi-read compatible (Random UDF compatible) drives are:
Drives that can read low reflectivity discs.● Drives that support Packet Write.●
Front Panel
Rear panel
Front Panel
Disc tray
This is the tray for the disc. Place the disc on the ejected disc tray, then lightly push the tray (or push
the eject button) and the disc will be mounted.
Caution
Don't use force to pull out or push in the disc tray. This might cause damage to the loading
section of the drive.
1.
Headphone jack
This jack is for connecting headphones or mini-speakers.
2.
Volume control
This is used to adjust the output volume of the headphone jack. It can't be used to adjust the output
volume for the audio output connectors on the rear panel.
Caution
Turn the volume down before turning on the power. Sudden loud noises can damage your
hearing.
3.
Busy indicator
This indicator lights green when a disc is mounted into the drive. When the disc is being accessed, it
flashes or lights green. If a disc is not mounted, the indicator does not light even when the power is
turned on. When a illegal disc is loaded or some hardware trouble occurs, the indicator blinks.
4.
Eject button
This is the button used to eject or insert in the disc tray.
5.
Inhaltsverzeichnis
Andere Ricoh CD/CDR-Laufwerk Handbücher
Ricoh
Ricoh MP5120A Bedienungsanleitung
Ricoh
Ricoh MP8040SE Bedienungsanleitung
Ricoh
Ricoh MP5316DA Bedienungsanleitung
Ricoh
Ricoh MP7320A Bedienungsanleitung
Ricoh
Ricoh MP7125A Bedienungsanleitung
Ricoh
Ricoh MP7200A Bedienungsanleitung
Ricoh
Ricoh MP7163A Bedienungsanleitung
Ricoh
Ricoh MP7063A Bedienungsanleitung
Ricoh
Ricoh MP7240A Bedienungsanleitung
Ricoh
Ricoh MP7040S Series Bedienungsanleitung
Ricoh
Ricoh MP6200A Bedienungsanleitung
Ricoh
Ricoh MP7060A Series Bedienungsanleitung
Ricoh
Ricoh MP5308D Bedienungsanleitung
Ricoh
Ricoh MP7400A Bedienungsanleitung
Ricoh
Ricoh MP5163A Bedienungsanleitung
Ricoh
Ricoh MP7040A - MediaMaster - CD-RW Drive Bedienungsanleitung
Ricoh
Ricoh MP6200S Bedienungsanleitung
Ricoh
Ricoh MP9120A Bedienungsanleitung
Ricoh
Ricoh MP7080A Bedienungsanleitung
Ricoh
Ricoh MP7060S Series Bedienungsanleitung
Beliebte CD/CDR-Laufwerk Handbücher anderer Marken
SmartDisk
SmartDisk Firewire CD-R/W Bedienungsanleitung
Axis
Axis CD-ROM SERVER Bedienungsanleitung
LG
LG CRD-8322B Bedienungsanleitung
Memorex
Memorex 32023234 - 52x32x52x External USB2.0 CD... Montageanleitung
Yamaha
Yamaha CD Recordable/Rewritable Drive CRW3200 Bedienungsanleitung
Sony
Sony CRX230AE Bedienungsanleitung
