8Distributed by Rockler Companies, Inc.
©2015 Rockler Woodworking and Hardware
55666
Rev 06/15
Install a Tabletop and Secure the Tubing
Note: The maximum recommended top size is 30"x 60".
The tabletop should be centered on the table assembly, and
weight on the table should be evenly distributed to prevent
tipping and to ensure proper lift performance. The lift
mechanism requires a load of 20 lbs. for even lowering.
1. Place the tabletop, top side down, on a
non-scratch surface.
Note: Hold on to the Feet (2) when flipping the
assembly so that the inner leg doesn’t drop out of the
upper leg. Be careful not to damage the hydraulic
tubing.
2. Carefully turn the table assembly over and position it
so it is centered on the tabletop, with the front of the
tabletop extending no more than 3"beyond the ends of
the Table Arm Supports (6).
3. Use the holes in the Table Arm Supports (6) to mark
and drill pilot holes for the included #14 x 1"Screws
(26).
4. Secure the tabletop to the table assembly.
5. Carefully coil the hydraulic tubing in loops no smaller
than 3"in diameter; hold with Zip Ties (24) and secure
to the tabletop with the included Tube Clips (25).
6. With a helper, carefully turn the table upright, being
sure to hold on to the Feet (2) to prevent them from
dropping and the Leg Assemblies from separating.
PARTS LIST Quantity
24 Zip Ties 4
25 Tube Clips 4
26 #14 x 1" Screw 4
Install the Handle
• Use a 5/16" nut driver to tighten.
PARTS LIST Quantity
17 Handle 1
22 Handle Bolt 1
23 Handle Nut 1
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
or support@rockler.com
17
23
22
23
22
25 26
24
