Rocktron TRUE BYPASS Tru-Loop Bedienungsanleitung

May be covered by one or more of the following: U.S. Patents #4538297, 4647876, 4696044, 4745309, 4881047,

4893099, 5124657, 5263091, 5268527, 5319713, 5333201, 5402498 and 5493617.

Other patents pending. Foreign patents pending.

Tru-Loop

Instruction Manual

This pedal is:

Your Tru-Loop™pedal has been tested and complies with the following Standards

and Directives as set forth by the European Union:

Council Directive(s): 89/336/EEC Electromagnetic

Compatibility

Standard(s): EN55013, EN50082-1

This means that this product has been designed to meet stringent guidelines on

how much RF energy it can emit, and that it should be immune from other sources

of interference when properly used. Improper use of this equipment could result

in increased RF emissions, which may or may not interfere with other electronic

products.

To insure against this possibility, always use good shielded cables for all audio input

and output connections. This will help insure compliance with the Directive(s).

For more information about other Rocktron products, please see your local dealer

or one of our importers closest to you (listed on the Rocktron website

(www.rocktron.com).

Read all instructions contained in this manual.

Keep these instructions

Heed all warnings

Follow all instructions.

Do not use this apparatus near water.

Clean with dry cloth

Compliance

Do not block any ventilation openings (if applicable). Install in accordance with the

manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat registers, stoves or other ap-

paratus (including ampliers) that produce heat.

This product is not equipped with a plug or cable. This pedal runs on a 9 Volt Battery, if a

9Volt DC adapter is the used please follow adapter manufacturer’s operation instructions.

Only used attachments/accessories specied by the manufacturer.

Do not use this product with any case, stand tripod, bracket or table that is not specied by

the manufacturer. Insure that the case, stand, tripod, bracket etc. is properly adjusted and

setup (follow all instructions). Extra care and caution should be taken to avoid tip over

and injury.

Unplug this apparatus during lightening storms or when unused during long periods of time.

Refer all service to qualied service personnel. Servicing is required when the apparatus

has been damaged in any way, such as power supply or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus or if the apparatus has been exposed to rain

or moisture, does not operate normally or has been dropped.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. QUALIFIED PERSONNEL

SHOULD SERVICE THIS EQUIPMENT ONLY. DO NOT MAKE ANY INTERNAL

ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT ANY TIME OR TAMPER

WITH INTERNAL ELECTRONIC COMPONENTS AT ANY TIME. FAILURE TO FOL-

LOW THESE INSTRUCTIONS MAY VOID THE WARRANTY OF THIS EQUIPMENT

AS WELL AS CAUSING A SHOCK HAZARD.

OPERATING TEMPERATURE

Do not expose this unit to excessive heat. This unit is designed to operate between 32 F and

104 F (0 C and 40 C). This unit may not function properly under extreme temperatures.

Precautions

Introduction

So you have favorite stomp boxes that you just love and adore but you wish

they were TRUE BYPASS pedals. Admit it. Everyone does. Well let Rocktron

put a smile on your face with the Tru-Loop, our incredible new product that lets

you add True Bypass to any non-true bypass effect! You read that right. Your

wish has come true with the Tru-Loop.

The original tone of the source input (such as that favorite pedal of yours)

is unchanged! One more time: the original tone of the source input remains

unchanged while using the Tru-Loop.

The Rocktron Tru-Loop provides Serial or Parallel effects mixing. The “Re-

turn” can merge stereo effect output (RTS) to mono. The Tru-Loop can be used

as a buffered A-B box as well. It can also be used as a 3 channel signal mixer.

D TUNING MADNESS ALERT:

Add an exciting new dimension to your sound using any distortion pedal and

the Tru-Loop’s capability to PARALLEL mix between Heavy Distortion and

your guitar’s original clean sound! The Tru-Loop is great for 7 string or Metal

D tuning to add a sense of focus and articulation to the fastest licks.

Part of the Rocktron Boutique Series of stomp boxes this pedal design comes

in a rugged metal chassis with eye popping retro custom design laser etched

artwork.

Controls on the Tru-Loop include MIX which allows the mix between the

original audio input signal and the effect return. Full counter clockwise equals

series effect. At 12 o’clock setting, you have 50% of the effect plus the original

audio.

INPUT is for the original audio source. SEND is the original audio source to

be used by the effect input. RETURN is the output of the effect.

The footswitch on the Tru-Loop controls On/Off status (indicated by the LED).

This stomp box runs on a 9V Alkaline battery. You may also use the Rocktron

DC OnTap Universal Power Adaptor.

Descriptions

Descriptions continued.........

RETURN Jack - Use this jack to return the signal from pedals in the

loop. This jack can also accept a RTS Stereo cable and will merge a

stereo effect output (RTS) to mono.

MIX Control -This control allows the you to mix between the original

audio input signal and effects in the loop. When the knob is set at 12

o’clock, you have 50% of the origional audio signal and 50% off the

effect. When turned fully to the left you have only the original signal.

When turned fully to the right you have the full amount of the effect

in the loop.

9VDC Input - This input jack provides 9VDC power to the pedal from

the Rocktron DC OnTap 9V power supply (sold seperately).

SEND Jack - Use this jack to send the signal to the loop. From here,

plug into the input jack of the rst pedal in the loop.

ON/OFF Led - This LED shows if the pedal is on or off. When the

LED is light the pedal is on. When the LED is not light the pedal is

off.

INPUT Jack - Using a standard 1/4” guitar cable, plug your guitar into

this jack.

OUTPUT Jack - This jack provides the output of the pedal. Use a 1/4”

guitar cable to plug into the next pedal or into a guitar amplier.

FOOTSWITCH - Use this switch to turn on or off the loop. When the

LED is ON, the loop is on (or in the signal path). When the LED is

OFF the loop is OFF (or out of the signal path).

Typical Connection

Specications

How to change the battery:

Maximum Input

Maximum Output

Imput Impedance

Output Impedance

Current Consumption

Power Requirements

Dimensions

Weight

10dBu

9.6Bu

1MΩ

100Ω

25mA

9V Alkaline Battery or

Rocktron DC OnTap

Univeral Power Supply

(sold seperately)

95mm x 122mm x 56mm

3.75” x 4.75” x 2.25”

420g

14.81 oz

To change the battery, turn the pedal over and remove the 4 screws on the

bottom. Remove the back cover. Carefully remove the old battery and

replace it with a new 9V Alkaline battery. Replace battery in the same

area as the old battery was located. Place the back cover on the pedal and

re-insert the screws.

Save yourself tons of money in batteries by using the Rocktron DC OnTap

Universal Power Supply to power this pedal (sold seperately). The Rocktron

DC OnTap provides a constant ow of power to the pedal, unlike a battery

that will degrade over time. The Rocktron DC OnTap Univeral Power

Supply can also power up to 20 pedals and can be used with both 110V and

220V power sources.

Check, www.rocktron.com for more information on the DC OnTap and

where to purchase.

Rocktron - A Division of GHS Corporation

2813 Wilber Ave

Battle Creek MI 49037

USA

www.rocktron.com

[email protected]

tel: 1-269-968-3351

rev. 7-27-09

2009.1

Inhaltsverzeichnis

Andere Rocktron Musikpedal Handbücher

Rocktron

Rocktron HEX Bedienungsanleitung

Rocktron

Rocktron BIG CRUSH Bedienungsanleitung

Rocktron

Rocktron XCHANGE Bedienungsanleitung

Rocktron

Rocktron Reaction Phaser Bedienungsanleitung

Rocktron

Rocktron TRU-BYPSASS Black Rose Octaver Bedienungsanleitung

Rocktron

Rocktron HEART ATTACK Bedienungsanleitung

Rocktron

Rocktron Reaction Compressor Bedienungsanleitung

Rocktron

Rocktron Reaction Super Booster Bedienungsanleitung

Rocktron

Rocktron Reaction Octaver Bedienungsanleitung

Rocktron

Rocktron BLACK MOAN CAT Bedienungsanleitung

Rocktron

Rocktron DEEP BLUE Bedienungsanleitung

Rocktron

Rocktron Sweet Spot Bedienungsanleitung

Rocktron

Rocktron Cyborg Bedienungsanleitung

Rocktron

Rocktron BANSHEE Bedienungsanleitung

Rocktron

Rocktron Reaction Distortion 1 Bedienungsanleitung

Rocktron

Rocktron Mega Booster Bedienungsanleitung

Rocktron

Rocktron Reaction Dynamic Filter Bedienungsanleitung

Rocktron

Rocktron O.D.B. Bedienungsanleitung

Rocktron

Rocktron ZOMBIE Bedienungsanleitung

Rocktron

Rocktron Celestial Delay Bedienungsanleitung

Rocktron

Rocktron Reaction Tremolo Bedienungsanleitung

Rocktron

Rocktron Unity Tuner Bedienungsanleitung

Rocktron

Rocktron Short Timer Retro Digital Delay Bedienungsanleitung

Rocktron

Rocktron Reaction Digital Delay Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung