Rocktron O.D.B. Bedienungsanleitung

May be covered by one or more of the following: U.S. Patents #4538297, 4647876, 4696044, 4745309, 4881047,

4893099, 5124657, 5263091, 5268527, 5319713, 5333201, 5402498 and 5493617.

Other patents pending. Foreign patents pending.

O.D.B Overdrive Dynamic Blues

Instruction Manual

This pedal is:

Your O.D.B - Overdrive Dynamic Blues™pedal has been tested and complies

with the following Standards and Directives as set forth by the European

Union:

Council Directive(s): 89/336/EEC Electromagnetic Compatibility

Standard(s): EN55013, EN50082-1

This means that this product has been designed to meet stringent guidelines

on how much RF energy it can emit, and that it should be immune from other

sources of interference when properly used. Improper use of this equipment

could result in increased RF emissions, which may or may not interfere with

other electronic products.

To insure against this possibility, always use good shielded cables for all

audio input and output connections. This will help insure compliance with the

Directive(s).

For more information about other Rocktron products, please see your local

dealer or one of our importers closest to you (listed on the Rocktron website

(www.rocktron.com).

Read all instructions contained in this manual.

Keep these instructions

Heed all warnings

Follow all instructions.

Do not use this apparatus near water.

Clean with dry cloth

Compliance

Do not block any ventilation openings (if applicable). Install in accordance

with the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat registers, stoves

or other apparatus (including ampliers) that produce heat.

This product is not equipped with a plug or cable. This pedal runs on a 9

Volt Battery, if a 9Volt DC adapter is the used please follow adapter manu-

facturer’s operation instructions.

Only used attachments/accessories specied by the manufacturer.

Do not use this product with any case, stand tripod, bracket or table that

is not specied by the manufacturer. Insure that the case, stand, tripod,

bracket etc. is properly adjusted and setup (follow all instructions). Extra

care and caution should be taken to avoid tip over and injury.

Unplug this apparatus during lightening storms or when unused during long

periods of time.

Refer all service to qualied service personnel. Servicing is required when

the apparatus has been damaged in any way, such as power supply or plug

is damaged, liquid has been spilled or objects have fallen into the apparatus

or if the apparatus has been exposed to rain or moisture, does not operate

normally or has been dropped.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. QUALIFIED

PERSONNEL SHOULD SERVICE THIS EQUIPMENT ONLY. DO

NOT MAKE ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO

THIS EQUIPMENT AT ANY TIME OR TAMPER WITH INTERNAL

ELECTRONIC COMPONENTS AT ANY TIME. FAILURE TO FOL-

LOW THESE INSTRUCTIONS MAY VOID THE WARRANTY OF THIS

EQUIPMENT AS WELL AS CAUSING A SHOCK HAZARD.

OPERATING TEMPERATURE

Do not expose this unit to excessive heat. This unit is designed to operate

between 32 F and 104 F (0 C and 40 C). This unit may not function prop-

erly under extreme temperatures.

Precautions

Introduction:

The O.D.B provides the best Blues tone and unparalleled dynamic

control you can get in one pedal. You get total control over the most

subtle nuances.

The O.D.B provides two Germanium clipping diodes that may be

independently assigned to provide soft knee clipping compression

applied to the to the positive cycle of the overdrive output, negative

cycle of the overdrive output or both! Thus providing the musician

total control of the overdrive characteristics providing even /odd

harmonic enhancement produced when Asymmetric clipping is

present.

SYMMETRICAL CLIPPING:

Assigning both + - diodes produces Symmetrical clipping (both

halves of the overdrive output waveform have equal volume).

ASYMMETRICAL CLIPPING:

Assigning only one of the diodes produces Asymmetrical clipping

(one half of the overdrive output waveform is larger than the other)

produces more harmonic overtones.

Germanium diodes are known for their magical soft clipping

properties.

The Drange Control determines how much Soft Knee Clipping is

applied.

Introduction continued....:

OUTPUT: Adjusts the nal Output Gain 0db to +3dBu

TONE: Adjusts nal High Frequency.

GERMANIUM DIODES:

+ When in applies clipping to the positive portion of

overdrive.

- When in applies clipping to the negative portion of

overdrive.

DRANGE: Determines how much soft knee clipping compression

is applied:

(Controls dynamic range [waveform excursion] of the assigned + or –

Germanium process)

DRIVE: Adjust the Overdrive gain (before Germanium diode

circuitry)

The footswitch on the O.D.B controls On/Off status (indicated by

the LED). This stomp box runs on a 9V Alkaline battery. You may

also use the Rocktron DC OnTap Universal Power Adaptor (sold

seperately).

Descriptions

Descriptions continued.........

OUTPUT & TONE Control - The larger outside knob

(Tone Control) controls the nal HIGH FREQUEN-

CY. The smaller inside knob (Output Control) adjusts

the nal output gain 0db to +3dBu.

GERMANIUM DIODES Switches - these two switch-

es turn ON and OFF the positive and negative portion

of the overdrive.

+ Applies clipping to the positive portion of overdrive.

- applies clipping to the negative portion of overdrive.

9VDC Input - This input jack provides 9VDC power

to the pedal from the Rocktron DC OnTap 9V power

supply (sold separately).

DRIVE & D-RANGE Control- The larger outside

knob (D-Range Control) Determines how much

soft knee clipping compression is applied. Controls

dynamic range (waveform excursion) of the assigned

+ or – Germanium process. The smaller inside knob

(Drive Control) adjusts the overdrive gain (before the

Germanium diode circuitry.

INPUT Jack - Using a standard 1/4” guitar cable, plug

your guitar into this jack.

Descriptions continued.........

ON/OFF Led - This LED shows if the pedal is on or

off. When the LED is light the pedal is on. When the

LED is not light the pedal is off.

OUTPUT Jack - This jack provides the summed out-

put of the effect. Use a 1/4” guitar cable to plug into

the next effect or into a guitar amplier.

FOOTSWITCH - Use this switch to turn on or off the

pedal. The On/Off Led will show you if the pedal is

on or off.

Typical Connection

Specications

Maximum Input

Maximum Output

Input Impedance

Output Impedance

Current Consumption

Power Requirements

Dimensions

Weight

2.2dBu

-0.64dBu

1MΩ

1Ω

15mA

9V Alkaline Battery or

Rocktron DC OnTap Uni-

versal Power Supply (sold

separately). Negative tip.

95mm x 120mm x 56mm

3.75” x 4.75” x 2.25”

410g

14.46 oz

Inhaltsverzeichnis

Andere Rocktron Musikpedal Handbücher

Rocktron

Rocktron BANSHEE Bedienungsanleitung

Rocktron

Rocktron SONIC GLORY Bedienungsanleitung

Rocktron

Rocktron Reaction Digital Delay Bedienungsanleitung

Rocktron

Rocktron Silver Dragon Bedienungsanleitung

Rocktron

Rocktron ZOMBIE Bedienungsanleitung

Rocktron

Rocktron TRUE BYPASS Tru-Loop Bedienungsanleitung

Rocktron

Rocktron Reaction Super Booster Bedienungsanleitung

Rocktron

Rocktron XTUNE Bedienungsanleitung

Rocktron

Rocktron CLASSIC WAH PEDAL Bedienungsanleitung

Rocktron

Rocktron Mega Booster Bedienungsanleitung

Rocktron

Rocktron DEEP BLUE Bedienungsanleitung

Rocktron

Rocktron HEX Bedienungsanleitung

Rocktron

Rocktron BIG CRUSH Bedienungsanleitung

Rocktron

Rocktron Reaction Distortion 1 Bedienungsanleitung

Rocktron

Rocktron Reaction Tremolo Bedienungsanleitung

Rocktron

Rocktron Valve Charger Bedienungsanleitung

Rocktron

Rocktron Third Angel Distortion Bedienungsanleitung

Rocktron

Rocktron VII Deadly Sins Bedienungsanleitung

Rocktron

Rocktron MULTVALVE Bedienungsanleitung

Rocktron

Rocktron MicroHUSH Bedienungsanleitung

Rocktron

Rocktron Reaction Compressor Bedienungsanleitung

Rocktron

Rocktron Reaction Phaser Bedienungsanleitung

Rocktron

Rocktron HUSH Bedienungsanleitung

Rocktron

Rocktron RAMPAGE Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung