Rocky Mountain COLORADO Bedienungsanleitung

Rocky Mountain Saunas

INSTRUCTIONS MANUAL

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

TABLE OF CONTENTS

INSTALLATION

ELECTRICAL REQUIREMENTS 3

UNPACKING YOUR SAUNA 5

COLORADO AND DURANGO INSTRUCTIONS 6-9

RIO GRANDE INSTRUCTIONS 10-13

BIG BEAR INSTRUCTIONS 14-17

HOW TO USE

CONTROL PANEL INSTRUCTIONS 18

FREQUENTLY ASKED QUESTIONS 19

DISCLAIMER 20

WARRANTY AND RETURN POLICY INFORMATION 21

SAFETY CERTIFICATIONS 22

Note:

The electric cord extends out from the center of the roof cap. The cord is approximately 9ft long. It is recommended that

the location of the outlet you are installing is accessible without moving the sauna.

Dedicated circuit requires that no other appliance should share outlet/circuit with sauna. Failure to comply with this

requirement may cause electrical interruption and diminished sauna performance.

It is recommended that a qualified electrician install your dedicated electrical wiring for proper sauna function and to avoid

any potential electrical hazards.

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

ELECTRICAL REQUIREMENTS

Colorado: 110-120volts/15amp dedicated circuit/outlet

NEMA 5-15R(required) NEMA 5-15P(included)

8 Heaters 1600-watts

Durango/Rio Grande: 110-120volts/20amp dedicated circuit/outlet

NEMA 5-20R(required) NEMA 5-20P(included)

9 Heaters 2150-watts

Big Bear: 220-240volts/20amp dedicated circuit/outlet

NEMA 6-20R(required) NEMA 6-20P(included)

15 Heaters 2850-watts

WARNING:

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

1) No plumbing or plumbing fixtures should be placed in the sauna.

2) Keep all liquids away from the heating panels

3) Install sauna on a completely level surface.

4) Flammable objects and corrosive chemical substances should be kept far away from the sauna.

Part A: Installation

Unpacking your Sauna

Please identify the 3 boxes (A/B/C) that arrived in your shipment. Place boxes in an open area. All 3 boxes are

labeled with the contents inside. It is recommended that a minimum of 2 people be present for unpacking and

assembly. Lay boxes flat on the ground with lettering facing up. Please make sure the area is clear of debris. Open

the boxes from smallest to largest to make for light, fast work.

The following steps will be divided into 3 sections.

First, we will start with the Colorado/Durango, next will be the Rio Grande and finally the Big Bear Sauna.

The tools required for assembly are a Phillips-Head Screwdriver (optional tools: Rubber mallet & small step ladder).

Note: All panels all labeled with white stickers. Please follow instructions carefully. If you should have any

questions, please do not hesitate to contact us at

1-888-358-1270 or info@rockymountainsaunas.com

Colorado & Durango

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

Colorado Durango

Step 1: Open Box C (Floor panel/Roof panel/Bench panel/Accessories box). Lay the floor panel

at your desired location. The floor heater is towards the front of the sauna.

Step 2: Open Box A (Front panel/Back panel). Install the Back panel first by sliding the panel

onto the metal brackets on the floor panel. Next install the Front panel by the same method

used for the Back panel. Please remove plastic wrap from Front panel but be careful so that the

glass door does not swing open. At this point, one person should secure both Front and Back

panels by holding them.

Moving Your Sauna after Assembly- RMS strongly recommends that you place sliders or ‘EZ Moves’

(Lowe’s or Home Depot) under the furniture feet or the perimeter corners of the Base Platform of the

Colorado 2 person sauna to allow for easy sliding of the sauna into its permanent location after

assembly. Place the EZ moves under the corners prior to beginning assembly. (On the Durango, Rio

Grande and Big Bear models, you may want to use a few mores ‘sliders’. Place sliders under the corners and

under the outside perimeter of the base platform.)

IMPORTANT NOTE: WHEN MOVING THE ASSEMBLED SAUNA:

1. DO NOT PUSH ON THE CABINET ITSELF AS YOU MAY “RACK” OR DAMAGE SAUNA !!

2. ALWAYS PUSH ON THE BASE PLATFORM TO MOVE SAUNA !!

3. SLIDERS MAY BE LEFT IN PLACE FOR EASING MOVING TO FACILITATE DUSTING, VACUUMING, ETC.

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

Step 3: Open Box B (Right Panel/Left Panel). Install Right and Left Panels by lining up the panels

to the Front and Back. Right Panel means Right facing the sauna Please semi-tighten installation

bolts (located in accessories box).

Step 4: Install Bench Support panel (located in Box C). Please make all 4 electrical connections to

the Back panel.

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

Step 5: Install Bench by guiding it between the Right and Left panels. There are 2 small pieces of

wood that may be used to prevent the back of the bench from sliding upward when user sits on

front of bench. They can be screwed to back wall directly above the bench. The pieces of wood

are included in the accessories box. When all 4 panels and the bench seat are securely in place,

please tighten all installation bolts.

Step 6: Install Roof panel. Guide the roof panel over the sauna and secure into position. Please

feed all the electrical connections that are on the Front/Back/Right/Left panels through the

holes in the roof panel.

Step 7: Once Roof Panel is securely in place, proceed up top to make all electrical connections.

Please note that there are 3 white ribbon connections (2pin-temp sensor/3pin-chromo/8pin-

power). Match the male/female black electrical cord heater connections. There are 2 in the front

and 2 in the back

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

Step 8: Install Top Cover. Feed the main power cord through the hole in the dust cover.

Step 9: Install Cup Holder(s), Magazine Rack, Towel Holder. These items may be installed in any

location that you desire. Mount Air Purifier to Back panel by using a wood screw (just like

hanging a picture). When installing the ionizer, cup holders, towel rack, etc., it is a good idea to

predrill a small hole prior to actually mounting the accessory. This will help to prevent any minor

splitting or chipping of the wood.

Step 10: Install Door Handle. If you have purchased the LCD Upgrade then you may connect it to

the 12volt Cig-adapter located on the ceiling, if not then cover the adapter with the wood knob

provided in your packaging.

Step 11: Once Installation is complete plug in sauna. Please make sure to read the “How to Use

Instructions” at the end of this booklet.

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

Rio Grande

Step 1: Open Box C (Floor panel/Roof panel/Bench panel/Accessories box). Lay the floor panel

at your desired location. The floor heater is towards the front of the sauna.

Moving Your Sauna after Assembly- RMS strongly recommends that you place sliders or ‘EZ Moves’

(Lowe’s or Home Depot) under the furniture feet or the perimeter corners of the Base Platform of the

Colorado 2person Sauna to allow for easy sliding of the sauna into its permanent location after

assembly. Place the EZ moves under the corners prior to beginning assembly. (On the Durango, Rio

Grande and Big Bear models, you may want to use a few mores ‘sliders’. Place sliders under the corners and

under the outside perimeter of the base platform.)

IMPORTANT NOTE: WHEN MOVING THE ASSEMBLED SAUNA:

4. DO NOT PUSH ON THE CABINET ITSELF AS YOU MAY “RACK” OR DAMAGE SAUNA !!

5. ALWAYS PUSH ON THE BASE PLATFORM TO MOVE SAUNA !!

6. SLIDERS MAY BE LEFT IN PLACE FOR EASING MOVING TO FACILITATE DUSTING, VACUUMING, ETC.

ROCKY MOUNTAIN SAUNAS INC.

7450-M W. 52ND AVE. PMB 123

1-888-358-1270

www.rockymountainsaunas.com

Step 2: Open Box A (Front panel/Right Front/Left Front). Install the Front panel first by sliding

the panel onto the metal brackets on the floor panel. Next install the Left Front panel by raising

it above Front panel and guiding it down into the metal brackets. Next install Right Front panel

by same method as Left Front panel. Please remove plastic wrap from Front panel but be careful

so that the glass door does not swing open. At this point, one person should secure both the

panels by holding them.

Step 3: Open Box B (Right Back panel/Left back Panel). Install Right back Panel by sliding panel

onto metal brackets on Floor panel. Semi-tighten Right Back panel to Right Front panel using

Installation bolts (accessories box). Install Left back panel to Right back panel and Left Front

panel (note there are no metal brackets on this side of the floor panel) Semi-tighten using

installation bolts.

Step 4: Install Bench Support panels (located in Box C). Please make all electrical connections to

the Back panel. Install Bench panels (3 pieces located in Box C). Once all panels and seats are

securely in place fully tighten all bolts.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Kohler

Kohler K-12183 Montageanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Kohler

Kohler Centerset K-15240 Montageanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

Kohler

Kohler Mira Eco Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema