Roland GX-24 Bedienungsanleitung
GX-24 Control Panel Flow Chart 8/18/2009
GX-24 Control Panel Flow Chart
Visual Representation of the GX-24 Control Panel
This guide is a visual representation of the GX-24 menu structure with descriptions. Clicking on the menu in
the flow chart will bring you to the description page.
Menu Flow Chart
Menu Flow Chart
To view the description of each menu, click the corresponding menu in the figure.
The description of each menu is given in the following format.
Stored in Memory: If Yes is indicated, the setting is stored even when the power is turned off.
Factory Default: Indicates the factory default setting.
Setting Range (or Selection
Choices): Indicates the range in which the settings can be specified or the possible choices.
Description: Provides an explanation of functions and matters that require caution.
●Display Menu
●Cutting Force Setup Menu
●Origin Setup Menu
●Pause Menu
●Language Selection Menu
[Back/Next]
Menu Flow Chart
Menu Flow Chart
Display Menu
Menu Flow Chart
[Back/Next]
Menu Flow Chart
Menu Flow Chart
Cutting Force Setup Menu
Origin Setup Menu
Pause Menu
Language Selection Menu
SELECT SHEET
Menu Description
SELECT SHEET
Stored in Memory No
Factory Default ROLL
Selection Choices ROLL, PIECE, or EDGE
Description
•ROLL
Performs cutting using roll material.
•PIECE
Performs cutting using standard-size material or piece material.
•EDGE
When using roll material, cutting is performed from the front-left edge of the material.
* When the setting for ROTATE on the display menu is 90deg, cutting is performed from the front-right edge.
UNSETUP
Menu Description
UNSETUP
Stored in Memory No
Description
Releases the setup condition when executed.
AREA
Menu Description
AREA
Stored in Memory Yes
Factory Default 1.0 m
Setting Range 24.9 m to -24.9 m (0.1 m
steps)
Description
This is used when cutting roll material or long, flat material that exceeds 1.6 m in length. This ensures that the
material will not come loose during cutting by feeding out the length of material to be cut before actually
performing cutting.
When performing continuous cutting on the same material, this can also be used to make sure that there is enough
remaining material to cut the data that will be sent.
SPEED
Menu Description
SPEED
Stored in Memory Yes
Factory Default 20 cm/s
Setting Range 1 to 50 cm/s (1 cm/s steps)
Description
Sets the speed used when cutting material.
Set this to a suitable value for the loaded material and installed blade.
SELECT SHEET
Menu Description
FORCE
Stored in Memory Yes
Factory Default 50 gf
Setting Range 30 to 250 gf (10 gf steps)
Description
Sets the blade force used when cutting material.
Perform a cutting test and set the conditions to match the loaded material and the installed blade.
Andere Handbücher für GX-24
1
Inhaltsverzeichnis
Andere Roland Bedienfeld Handbücher
