Rollei Actioncam 560 Touch Bedienungsanleitung
EN
1. Key features
Video Resolution: 4K@60FPS, 4K@30FPS, 1440P@30FPS, 1080P@120FPS,
1080P@60FPS, 720P@240FPS, 720P@120FPS
Image Resolution: 20MP
2’’ TFT touch screen
3.8V/1100mAh removable Lithium-ion battery
Support Wi-Fi connection
Support 2.4G RF Remote Controller
Support MicroSD Card up to 64 GB
EN
2. Camera description
EN
EN
3.2 Insert a Memory Card
Insert a MicroSD card into the SD card slot.
NOTE:
1. We suggest to use Class 10 (or higher) Micro SD cards for s smooth recording.
Lower Class of the Micro SD Cards may cause the video blur or frame drops.
2. There is only one correct direction to insert the SD Card into the slot. Do not
force the card into the card slot as it may damage both the SD Card and camera.
3. A new Micro SD Card should be formatted before using.
3.3 Charge the battery
Before using the AC 560 TOUCH for the first time, please fully charge the battery.
1. Connect the AC 560 TOUCH with an USB-charger or USB-device by Mini USB
cable.
2. Charging Indicator B turns red during charging.
3. A complete empty battery takes approximately 2.5 hours to get fully charged.
The red indicator turns off after the battery is fully charged.
4. When the battery is going to run empty, the red indicator B blinks twice a second.
5. Some functions, such as Wi-Fi, are unavailable if the battery is in lower condition.
3.4 Insert camera into the waterproof case
1. Ensure the case is dry and clean.
2. Insert the camera and make sure the lens fits neatly in the lens cavity.
3. Close the locking clamps.
4. The waterproof case can be mounted, using the accessories in the box.
3.5 Record a video
Press Shutter button (B) when powered on, LED B turns green and keep blinking
twice a second; Press Shutter button (B) again to stop, and the LED B light turns off.
EN
3.6 Shoot a single picture
Press Shutter button (B) once to shoot a single picture, LED B flashes green.
3.7 Mode Shift
1. Main mode shift (A)
When powered on, short press on button A to shift among Video Recording - Photo
Shot - Playback- Setting, pause to confirm on current mode.
You can easily access this menu with touch operation by touch the left arrow.
2. Main mode shift (B)
When powered on, long press on button B for 3 seconds to enter Setup menu: Video
- Photo - Effect - General.
4. Setup your camera
Long press on Button B to enter Setup ”Video - Photo - Effect - General”, press
Button A to navigate and press Button B to confirm. Long press on Button B again to
exit.
EN
4.1 Video SETUP
Press Power Button (A) once to navigate, press Shutter Button (B) to Enter/Confirm
selection.
Video Resolution
To set the video resolution.
Image Stabilization
To activate/deactivate the digital image stabilization. Image stabilization can’t be
activated on 4K@60fps, 1080p@120fps, 720p@240fps, 720p@120fps.
Loop Recording
This allows to record continuously using footage intervals. The camera will delete the
oldest loop recording file and replace with the latest recording when the MicroSD
card is full.
Time Lapse Interval
This allows to record one frame at the set time interval of Off/0.5 Sec/1 Sec/3 Sec/5
Sec/10 Sec/30 Sec/60 Sec. The final video file will be stored.
Time Lapse Duration
To determine the video Timelapse duration of “Unlimited/5 Min/ 10 Min/ 15 Min/ 20
Min/ 30 Min/ 60 Min, only available when Time Lapse Photo Interval activate.
EN
Slow Motion Movie
This allows to record the action at a faster rate than usual or replayed at a slower
rate than usual. This feature is only available on 1280x 720p@120fps.
Fast Motion Movie
This allows to record the action at a slower rate than usual or replayed with a faster
rate than usual. This feature is not available when Time lapse is activated.
Wind Noise Reduction
To reduce the wind noise during video recording.
Scene Mode
To set different scene modes: Manual, Water, Riding, Winter, Diving, Night.
You can easily access this mode with touch operation by touching the right arrow.
Date Stamp
To define if the Date/Time mark is displayed on top of the videos.
Auto Low Light
To use for recording in low light condition.
4.2 Photo Setting
Press Power Button (A) once to navigate, press Shutter Button (B) to Enter/Confirm
selection.
EN
Resolution
To set the image resolution.
Time Lapse Interval
This allows you to shoot a continuous sequence of photos with the following intervals
Off/0.5 Sec/1 Sec/3 Sec/5 Sec/10 Sec/30 Sec/60 Sec.
Time Lapse Duration
To determine the photo Time lapse duration of “Unlimited/5 Min/ 10 Min/ 15 Min/ 20
Min/ 30 Min/ 60 Min (only available when Time Lapse Photo Interval activated).
Photo Burst
This allows you to take 3 shots/1s, 7 shots/2s, 15 shots/4s, 30 shots/8s.
Timer
When this mode is enabled, it lets you set intervals of 3 Sec, 5 Sec, 10 Sec when a
single photo is taken after clicking the Record button.
Date Stamp
To define if the Date/Time mark is displayed at the top of the photos.
Scene Mode
To set different scene modes: Manual, Outdoor, Indoor, Portrait, Landscape, Night.
EN
Inhaltsverzeichnis
Andere Rollei Action-Kamera Handbücher
Rollei
Rollei 410 Bedienungsanleitung
Rollei
Rollei 40s Pro Bedienungsanleitung
Rollei
Rollei D2Pro Bedienungsanleitung
Rollei
Rollei Actioncam 330 Bedienungsanleitung
Rollei
Rollei Actioncam 5s Plus Bedienungsanleitung
Rollei
Rollei Actioncam 372 Bedienungsanleitung
Rollei
Rollei Actioncam 550 Touch Bedienungsanleitung
Rollei
Rollei Actioncam 7s Plus Bedienungsanleitung
Rollei
Rollei AC 420 Bedienungsanleitung
Rollei
Rollei Action Camera 230 Bedienungsanleitung
Rollei
Rollei ACTIONCAM 425 Bedienungsanleitung
Rollei
Rollei 4s Plus Bedienungsanleitung
Rollei
Rollei Actioncam 11s Plus Bedienungsanleitung
Rollei
Rollei D6Pro Bedienungsanleitung
Rollei
Rollei Actioncam 9s Plus Bedienungsanleitung
Rollei
Rollei Actioncam 9s Plus Bedienungsanleitung
Rollei
Rollei Actioncam 8s Plus Bedienungsanleitung
Rollei
Rollei Actioncam 9s Plus Bedienungsanleitung
Rollei
Rollei Actioncam S-30 WiFi Bedienungsanleitung
Rollei
Rollei 410 Bedienungsanleitung
