14. Care and Maintenance
Regularly check the product for signs of wear and tear. Replace the product if it is damaged.
TO REPLACE FLUORESCENT TUBES
1. Make sure the lantern is switched off (white switch in the central position).
2. Gently pull the clear plastic that covers the UV tube off the lantern.
3. Twist the tube gently so that the pins at each end are aligned with the gap in the
holder.
4. Gently pull the used tube and replace it with a tube of the same specification –see
below.
5. Replace the clear plastic cover with care so as not to snap off the two small tabs on
each side.
TO REPLACE TORCH BULB
1. Make sure the lantern is switched off (white switch in the central position).
2. Gently slide the black plastic piece off that surrounds the torch. This slides out –
there are no screws etc.
3. Taking care, twist out the used bulb and replace it with a bulb of the same
specification –see above. This is quite fiddly as the bulb is in a confined space. Do
not attempt to remove the circuitry around the bulb.
4. Replace the black plastic.
GENERAL INFORMATION
• Do not immerse in water
• Do not store in conditions of extreme heat
• Do not use in rain or damp conditions
• Do not attempt to access the inside of the product (other than to access batteries or
tubes/bulb)
• Carry using the attached strap
BATTERY CARE
Do not mix old/new batteries or different types of batteries.
Do not use rechargeable batteries.
Remove exhausted batteries as soon as possible.
The supply terminals are not to be short-circuited.
Do not dispose of batteries in fire.
Handle batteries with care.
15. Troubleshooting
Not applicable
Further copies of these instructions can be downloaded at www.rompa.com
We hope you find our instructions invaluable. If you have any suggestions for improving
them further your comments will be greatly received –please contact us at
UV Lantern with Torch 18888, September 2014
Copyright ROMPA®Ltd
