Ruckus Wireless SmartZone 100 Bedienungsanleitung

Get to Know the Physical Features of the Controller

The following sections identify the physical features of the controller that are relevant to the installation and mounting

instructions that this guide provides. Before you begin the installation process, Ruckus Networks strongly recommends that you

become familiar with these physical features.

Front Panel

The following gure shows the controller’s front panel with the bezel installed. For descriptions of the numbered parts, refer to

the table below.

FIGURE 3 The front panel of the SmartZone 100 (SKU P01-S124-WW10)

TABLE 3 Front panel parts

Number Description

1 10G Ethernet link LED (see LEDs on the Front Panel on page 15)

2 10G Ethernet speed LED (see LEDs on the Front Panel on page 15)

3 Two 10GBASE-X (SFP+) ports (SKU P01-S124-WW10 only)

4 F/D (factory default) button. Press this button for at least 10 seconds to reset the controller to factory default

settings.

5 Status LED (see LEDs on the Front Panel on page 15)

6 1000BASE-T link LED (see LEDs on the Front Panel on page 15)

7 1000BASE-T status LED (see LEDs on the Front Panel on page 15 )

8 Four 1000BASE-T (RJ-45) ports

9 Console (RJ-45 serial) port. Use the supplied console cable (or any rollover cable, also known as Cisco

™

serial RJ-45

cable) to connect this port to another device.

10 Two USB ports

11 Power LED (see LEDs on the Front Panel on page 15)

12 HDD LED (see LEDs on the Front Panel on page 15)

Before You Begin

Ruckus SmartZone 100 Getting Started Guide

14 Part Number: 800-71960-001 Rev A

TABLE 3 Front panel parts (continued)

Number Description

13 Reset button. Press for 5 seconds to restart the SZ 100.

LEDs on the Front Panel

The table below describes the behavior of the LEDs on the front panel.

TABLE 4 LED behavior

LED Description

10G Ethernet link LED Green: Operational

Flashing: TX/RX data

O: Not operational

10G Ethernet speed LED Blue: Operating at 10Gbps

Yellow/Orange: Operating 1Gbps

O: Not operational

Status Green: System operational/no fault

Red: System fault

Blinking red: Starting up or shutting down

Slow ashing red: System shut down

1000BASE-T link LED Green: Operational

Flashing green: TX/RX data

O: Not operational

1000BASE-T speed LED Green: 1000Mbps

Amber: 100Mbps

O: 10Mbps

Power On: Power available

O: No power

HDD On: Disk I/O (usually blinking)

O: No disk I/O

Rear Panel

The gure below shows the rear panel of the SmartZone 100. For descriptions of the numbered parts, refer to the table below.

Before You Begin

Ruckus SmartZone 100 Getting Started Guide

Part Number: 800-71960-001 Rev A 15

Andere Handbücher für SmartZone 100

Dieses Handbuch passt für folgende Modelle

Andere Ruckus Wireless Netzwerk-Router Handbücher

Ruckus Wireless

Ruckus Wireless Ruckus ICX 7150 Series Handbuch

Ruckus Wireless

Ruckus Wireless SmartZone 100 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless ZoneFlex P300 Installationsanleitung

Ruckus Wireless

Ruckus Wireless 2825 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless ZoneDirector 1200 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless ICX Series Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless ICX 7150-C12P Handbuch

Ruckus Wireless

Ruckus Wireless ZoneFlex 7731 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless SmartZone 100 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless MediaFlex NG Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless MF2900 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless ZoneDirector Series Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless SmartZone 100 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless 2825 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless SmartZone 3.2 Bedienungsanleitung

Ruckus Wireless

Ruckus Wireless MediaFlex 2111 Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Korenix

Korenix JetNet 5710G Series Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise