RuggedCom WiN52 Series Montage- und Bedienungsanleitung

User’s Manual & Installation Guide for:

WiN52XX/WiN51XX Series Outdoor CPE

Dissemination or reproduction of this document, or evaluation and communication of its contents, is not authorized except where

registration.

This document contains proprietary information, which is protected by copyright. All rights are reserved. No part of this document may be

photocopied, reproduced or translated to another language without prior written consent of RuggedCom Inc.

Disclaimer Of Liability

We have checked the contents of this manual against the hardware and software described. However, deviations from the description

cannot be completely ruled out.

RuggedCom shall not be liable for any errors or omissions contained herein or for consequential damages in connection with the

furnishing, performance, or use of this material.

The information given in this document is reviewed regularly and any necessary corrections will be included in subsequent editions. We

appreciate any suggested improvements. We reserve the right to make technical improvements without notice.

Registered Trademarks

RuggedMAX-BST™, RuggedServer™, RuggedWireless™, RuggedCom Discovery Protocol™ (RCDP™), RuggedExplorer™, Enhanced

Rapid Scanning Tree Protocol™ (eRSTP™), are trademarks of RuggedCom Inc. Rugged Operating System® (ROS®) and

RuggedSwitch® are registered trademarks of RuggedCom Inc. Other designations in this manual might be trademarks whose use by

third parties for their own purposes would infringe the rights of the owner.

Warranty

Five (5) years from date of purchase, return to factory. For warranty details, visit www.ruggedcom.com or contact your customer service

representative.

Contacting RuggedCom

Corporate Headquarters US Headquarters Europe Headquarters

RuggedCom Inc

30 Whitmore Road

Woodbridge, Ontario

Canada, L4L 7Z4

Tel: (905) 856-5288

Fax: (905) 856-1995

Toll-free: 1 (888) 264-0006

RuggedCom

1930 Harrison St., Suite 209

Hollywood, Florida

USA, 33020

Tel: (954) 922-7938x103

Fax: (954) 922-7984

Toll-free: 1 (888) 264-0006

RuggedCom

Unit 41, Aztec Centre,

Aztec West, Almondsbury, Bristol

United Kingdom BS32 4TD

Tel: +44 1454 203 404

Fax: +44 1454 203 404

Toll-free: 1 (888) 264-0006

Email: [email protected]

WiN5200 Table of Contents | 3

Table of Contents

Introduction............................................................................................................6

1.1 About this Manual......................................................................................................................7

1.2 General Description..................................................................................................................7

1.2.1 Features ..........................................................................................................................8

1.3 Package Components and Unpacking.................................................................................8

1.4 Safety Information.....................................................................................................................8

Product Description............................................................................................11

2.1 Introduction...............................................................................................................................12

2.2 IEEE 802.16e Mobile WiMAX Compliance........................................................................13

2.3 Block Diagram..........................................................................................................................14

2.4 Features ....................................................................................................................................15

2.4.1 Mobile WiMAX Wave 2 MIMO Features................................................................15

2.4.2 Security..........................................................................................................................17

2.4.3 Time Division Duplexing (TDD)................................................................................20

2.4.4 Coding Rate..................................................................................................................20

2.4.5 Modulation....................................................................................................................20

2.4.6 Convolution Coding Error Correction......................................................................21

2.5 Deployment Models................................................................................................................21

2.5.1 PTP Deployment.........................................................................................................21

2.5.2 PMP Deployment........................................................................................................21

2.5.3 Non Line-of-Sight ........................................................................................................21

2.5.4 Channelization .............................................................................................................21

2.6 Service Flows...........................................................................................................................22

2.6.1 Service Flow Classification.......................................................................................22

2.6.2 Dynamic Service Addition .........................................................................................22

2.6.3 Default Service Flows.................................................................................................23

WiN5200 Table of Contents | 4

2.6.4 Scheduling ....................................................................................................................23

2.7 Physical Description...............................................................................................................24

2.7.1 Physical Interfaces Description................................................................................24

2.7.2 LED Indication Description........................................................................................25

Mounting ..............................................................................................................27

3.1 General......................................................................................................................................28

3.2 Site Survey................................................................................................................................28

3.3 Pole Mounting..........................................................................................................................29

3.4 Wall Mounting..........................................................................................................................29

Installation Procedure ........................................................................................30

4.1 Safety Hazards ........................................................................................................................31

4.2 Tools and Cables Required for the Installation ................................................................31

4.3 Installing the WiN5200...........................................................................................................31

4.3.1 Pole Mounting..............................................................................................................32

4.3.2 Wall Mount....................................................................................................................33

4.4 Cable Connections..................................................................................................................35

4.4.1 Installing the WiN1010 data adapter for WiN5200 ..............................................35

Equipment Configuration and Monitoring........................................................38

5.1 Configuring WiN5200 Basic Parameters...........................................................................39

5.2 Aligning the CPE Antenna.....................................................................................................41

5.2.1 CPE Antenna Alignment Procedure........................................................................42

5.2.2 Link Indication..............................................................................................................43

Management.........................................................................................................44

6.1 General......................................................................................................................................45

6.2 SW Download/Upgrade .........................................................................................................45

6.3 Web-page Management........................................................................................................46

6.4 SNMP Management...............................................................................................................50

WiN5200 Table of Contents | 5

Appendix A –Product Specification.................................................................51

Appendix B –IDU to ODU Cable Specifications..............................................52

List of Acronyms.................................................................................................54

WiN5200 Introduction | 6

Introduction

WiN5200 Introduction | 7

1.1 About this Manual

This manual describes the installation procedures of WiN51XX/WiN52XX Outdoor CPE with

Ethernet interfaceand is written for the installers and operators.

WiN51XX/WiN52XX2 products will be referred in this manual as WiN5200 from now on.

The RuggedCom WiN5200 is a member of the Win-Max™ E family, a line of mobile WiMAX

broadband wireless access systems based on the 802.16e mobile WiMAX standard. The Win-

Max™ E family is detailed in the System Description manual ofRuggedCom.

This manual assumes that users have some experience with WiMAX technologies and

procedures.

While some safety precautions are reviewed here, this manual assumes that installers have

been trained in safe installation practices. Users, who are new to WiMAX technologies and

service procedures,should not rely on this manual for comprehensive guidance.

1.2 General Description

The RuggedCom WiN5200 ODU is a member of the Win-Max™ E family, a line of WiMAX

Broadband Wireless Access systems based on the 802.16e mobile WiMAX standard, specially

designed for quadruple-play applications.

WiN5200 is a high-performance outdoor unit that provides complete 802.16e mobile WiMAX

broadband wireless access functionality to a range of indoor multi-service gateways.

The WiN5200 enables the full scope of triple-play (including telephony, data, Video-on-Demand)

over the WiMAX network. In the home, triple play services are distributed to a single gateway

for a simple home-networking solution.

The WiN5200 is based on the IEEE 802.16e standards to effectively meet the unique requirements

of the wireless Metropolitan Area Network (MAN) environment and to deliver broadband

accessservicesto a wide range of customers. Specifically designed for point-to-multipoint

broadband wireless access applications, the WiN5200 provides efficient use of the wireless

spectrum, supporting a range of user environments. The access and bandwidth allocation

mechanisms accommodate hundreds of subscriber units per sector, supporting differentiated

services to a multiple of end-users.

WiN5200 Introduction | 8

1.2.1 Features

• Intelligent WiMAX subscriber unit for wireless triple-play service delivery

• Outdoor unit with ETH interface to indoor unit

• Automatic, self-configured, plug-n-play

• Supporting 1.X, 2.X and 3.X GHz bands

1.3 Package Components and Unpacking

Check that the package contains:

1. WiN52xx ODU with integrated flat antenna

2. Pole/wall mounting hardware

In case of damage, contact the shipping company.

1.4 Safety Information

RF Exposure

The WiN5200, an outdoor CPE, is compliant with the requirements set forth in CFR 47 section

1.1307, addressing RF Exposure from radio frequency devices as defined in OET Bulletin 65.

The outdoor CPE mobile unit should be positioned more than 0.6 feet (20 cm) from humans.

The outdoor CPE fixed unit should be positioned at least 7 feet (2m) from humans.

Lightning Protection

When WiN5200 is installed in an outdoor location, all indoor components (Ethernet, power

supply) should be connected through a lightning protector.

The purpose of the lightning protection is to protect people and equipment located indoors

from lightning that might strike the WiN5200 or its outdoor cables. Therefore, the lightning

protector device should be installed indoors, as close as possible to the point where the cables

enter the building. The lightning protector can also be installed outdoors, as long as the cables

that lead from it indoors are well protected from lightning between the box and the building

entrance.

Power Cord Protection

The WiN5200 should always be connected to the WiN1010 data adapter for both power

supply and data transfer purposes.

WiN5200 Introduction | 9

Any other type of connection/application of the WiN5200 and/or WiN1010 is not allowed.

Route all power supply cords so that people cannot walk on them, or place objects on or

against them. This can pinch or damage the cords.

Servicing

Do not open the cover of this product and perform corrective actions unless instructed to do

so in the operating instructions.

Outdoor Grounding System

Verify that the antenna or cable system is grounded (earthed).

Theantenna is an integral part of the CPE (Models WiN51XX)

The CPE (antenna) installation must be as per Article 810 of the NEC. Of particular note is the

requirement that the grounding conductor not be less than 10 AWG (Cu). The scheme should

be either in accordance with UL 96 and 96A. Lightning Protection Components and

Installation Requirements for Lightning Protection Systems, or tested in accordance with UL

50 and UL 497.

CAUTION

To reduce the risk of fire, use only No. 26AWG or larger telecommunication line cord

between the indoor and outdoor units.

WiN5200 Introduction | 10

NOTE: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates,uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Operation is subject to the following two conditions:

(1) This device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the

device

Changes or modifications to this equipment not expressly approved by the party

responsible for compliance (RuggedCom Inc.) could void the user’s authority to

operate the equipment.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere RuggedCom Drahtloser Zugangspunkt Handbücher

RuggedCom

RuggedCom RuggedWireless RS900W Family Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM2 Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung