SafeDial Wireless GL45-3G - GL V1.0 / PM V3
Page5
.
You must be a registered user of SafeDial Toolbox. Globe
administration will register you as a user at the time of your first
hardware purchase.
Before powering up, the unit must be activated via the web
using the SafeDial Toolbox App on your smartphone, PC or
tablet. Go to www.safedialtoolbox.com.au to activate your unit.
NOTE: Refer to the SafeDial Toolbox Quick Start Guide or Page 22 – “Activating a GL45-3G” in this manual.
Before applying power, the GL45-3G must be activated using SafeDial Toolbox.
This unit will not operate unless it has been correctly activated.
Find a location within the Alarm Panel box where you would like to install the unit.
Route the antenna cable outside the box & place the antenna on top of the metal Alarm Panel
enclosure, or use the provided ground plate.
Connect power to the power terminals. Power is normally obtained from the Alarm Panel.
If you are using an independent power supply make sure that you have a common negative.
A four wire connection is required between the Alarm Panel dialler and the GL45-3G.
‘Ring” (R) (Red) & ‘Tip’ (T) (Green) as the input and ‘R1’ (Black) & ‘T1’ (Yellow) are the return line.
If the return line is not connected the “CID” LED will be [RED – On] indicating a fault. This lead is also
used to monitor the interconnectivity between the Alarm Panel dialler and the GL45-3G. If the lead is
removed a “Dialler Lead Interface Fail” event will be sent to the Control Room. This indicates that the
panel has lost connectivity with the GL45-3G. (Refer to Page 7 of this manual for Connection Guide)
If you are using the Ethernet Port, connect a CAT5 cable between the GL45-3G and the local router or
network port.
The GL45-3G will automatically obtain an IP address if it is set to DHCP (default).
Connection to the internet is indicated by the “IP” LED [GREEN – Steady On].
The “HB” LED indicates signal strength and if the microprocessor is operating
(Refer to Page 7 of this manual for the Full LED Status Indicators)
Good Signal = [GREEN – Blinking]
Low Signal = [RED – Blinking].
The unit can take up to 3 minutes to register onto the cellular network.
Connection to the cellular network is indicated by the “MOBILE” LED = [GREEN – Steady On].
If the signal strength is low you need to reposition the unit or make use of a high gain antenna.
The unit needs to be power cycled to refresh the signal strength indictors when repositioned. Signal
strength must be better than -88dBm for reliable communications.
GL45-3G Activation Tools
Installation and Commissioning Procedure
