Safety Track ST-50 Bedienungsanleitung
ST-50 Battery GPS Tracker
How To: Hard Reset and Battery
Replacement
!
2017 JAN V 1.1
Introduction
This How To Guide will show you how to either do a hard reset on the unit if we
have requested it or replace your battery. If you are replacing the battery, perform
section A, page 3 “Taking apart the device” then skip to section C, page 5 “Battery
Replacement”. This way there won’t be any confusion.
If there are any questions about this how to guide please contact your sales rep or
our support team at 734-699-7633 Thank you very much.
Table of Contents
A. Taking Apart The Device…………………………………………………3
B. Hard Reset…………………………………………………..….…….…4-5
C. Battery Replacement..…..………………………………………………5-6
D. Closing Up The Device..………………….……………………………….7!
!
A. Taking apart the device
!3
STEP 1:
Using a screwdriver or a drill, remove the 4
screws concealing the device’s battery and
motherboard.
STEP 2:
Once you have removed the 4 screws, pull
apart the two pieces SLOWLY and GENTLY!
STEP 3:
You should start to reveal the battery and see
a RED and BLACK wire. These wires
connect the motherboard to the battery.
B. Hard Reset
!4
STEP 1:
Notice the WHITE connector piece that
connects the battery to the motherboard. Pull
this apart, disconnecting the two.
STEP 2:
With the two disconnected, wait for a period
of 1-2 Minutes. Once the time has elapsed,
plug the two back together.
STEP 3:
Follow the steps in Section D, Page 7
“Putting it all back together”. To close the unit
back up and you are done with the Hard
Reset.
C. Battery Replacement
!5
STEP 2:
Once you have disconnected the
motherboard from the battery, pull off the end
piece.
STEP 1:
Notice the WHITE connector piece that
connects the battery to the motherboard. Pull
this apart, disconnecting the two.
STEP 3:
Next, pull/slide out the battery AND the
motherboard together to avoid damaging the
connecting wires.
!6
STEP 4:
Now that everything is out in the open,
replace the old battery with the new one.
FIG 2
FIG 1
STEP 5:
Connect the battery back to the motherboard
and start to slide the battery and
motherboard back into the body of the
device. You will notice in FIG 1, that the black
resistors on the motherboard are facing
down toward the battery. In FIG 2, take
notice at the groves that the motherboard
slides in on both sides of the body.
STEP 6:
With everything lined up and wires re-
connected, slide the battery and
motherboard back into the body of the
device.
D. Closing up the Device
!7
STEP 7:
Once everything is slid back in, try the best
you can to tuck any excess wires back in the
device. Replace the end piece. From this
point on, follow the Steps in Section D
“Close up the device”.
STEP 1:
Now that you have either done a hard reset
or replaced the battery, you now want to
properly seal up and close the device. The
most important part here is to make sure the
watertight seal/gasket is lined up. Insert the
screws, line up with the holes and seal up
the device.
STEP 2:
Once you have the screws in and snugged
up. Your device should appear like the one to
the left. You should see a very small gap if
any at all to ensure a proper watertight seal.
YOU’RE DONE!
Safety Track - 249 Main St. Belleville MI 48111 - 734-699-7633
Inhaltsverzeichnis
Andere Safety Track GPS Handbücher
