SainSonic AX-05B Bedienungsanleitung
AX-05B User Manual
1. Electrical parameters:
Working Voltage：DC 9V~14V
Operating Current：＜0.2A；
RF Frequency Range：88.1~107.9MHz
RF Power：<43dBuV@3m
Modulation: WFM
Frequency Deviation: +/-75KHz
SNR: <-60db
Pre-emphasis Delay：75us；
Separation：40dB；
Input Level：-13dBV；
Applicable Microphone: Electret Microphone.
Dimensions：114mm（L）×88mm（W）×38.5mm（H）
2．Operation Brief
a. Operation Steps: connect power connect audio
connect microphone press the power button to switch
on into normal working condition
.
2．Boot
Press button in the front panel , fm transmitter will be
in to normal working status.
3．Frequency Adjustment
Press button to adjust the needed working frequency of
the machine. Long press the button, it can into quickly adjustment
state.
4．LINE Volume Adjustment
By "LINE LEVEL" knob, you can adjust the input volume. The clockwise is to
increase, counterclockwise is to decrease. .
5．MIC Volume Adjustment
By "MIC LEVEL" knob, you can adjust the input volume. The clockwise is to
increase, counterclockwise is to decrease.
3．Precautions:
1. When used, the antenna should be in good contact, the antenna is rotated
counter-threaded screw counterclockwise to tighten clockwise to unscrew
2. audio cable must use shielded cable.
3. optional power adapter output DC voltage clean as possible, so as not to cause
interference on the transmitter.
4. Avoid working in extremely hot or humid environment.
5. Try to place the machine in an open environment, in order to achieve good
emission results.
6. Adjust the volume on moderate, so that the sound will not be too small or too
large can not be adjusted due to over-modulation distortion.
7. Should avoid local FM radio frequency.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy
and, if not installed and used in accordance with the instructions, may cause
harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Inhaltsverzeichnis
Andere SainSonic Sender Handbücher
Beliebte Sender Handbücher anderer Marken
Dejero
Dejero EnGo 3x Bedienungsanleitung
Rosemount
Rosemount 4600 Bedienungsanleitung
Speaka Professional
Speaka Professional 2342740 Bedienungsanleitung
trubomat
trubomat GAB 1000 Bedienungsanleitung
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Bedienungsanleitung
Rondish
Rondish UT-11 Bedienungsanleitung
