Samsung SHP-3701H Bedienungsanleitung

Outdoor Housing

Installation Manual SHP-3701H

2_ SHP-3701H

OVERVIEW

The outdoor-type housing (SHP-3701H) is the housing used to install the smart dome

camera or network camera on a wall or ceiling outdoors.

CAUTIONS ON INSTALLATION

For the power supply of the housing, please use the AC24V (3A) adaptor.

Please select an installation site that can withstand quadruple the weight of the product.

When installing the unit in a place where the temperature is very low, such as a cold storage unit, the

cable piping connected to the housing needs to be sealed by silicone so that no external air gets into

the inner part of the housing.

If high-temperature and high-humidity air from the outside enters the inside of the housing through

the piping, moisture or water may be generated within the unit due to the difference in temperature

between the outer part and inner part of the product.

Please keep people away from the installation site during product installation, as there may be

a risk of falling. Please proceed with the installation after moving valuables to a safe place.

If the product is installed in a place with high humidity, moisture may occur on the dome cover of the housing.

Please open the dome cover prior to installation and remove moisture from the unit with a soft and dry cloth.

OPTIONAL PRODUCTS FOR INSTALLATION

Please install the outdoor housing by using the appropriate one of the following adaptors

according to the installation site.

When installing one of the adaptors listed below, please try to install the unit according to the installation manual.

①

CEILING MOUNT ADAPTOR (SBP-300CM): Please use this unit for installation on a ceiling.

②

WALL MOUNT ADAPTOR (SBP-300WM1): Please use this unit for installation on a wall.



SHP-3701H _3

●KOR

③

POLE MOUNT ADAPTOR (SBP-300PM): Please use this unit for installation on a pole.

At this time, please use the unit in combination with the wall mount adaptor

(SBP-300WM, SBP-300WM1).

④

CORNER MOUNT ADAPTOR (SBP-300KM): Please use this unit for installation on the

corner of a wall.

Please use in combination with the wall mount adaptor (SBP-300WM, SBP-300WM1).

⑤PARAPET MOUNT ADAPTOR (SBP-300LM):

Please use this unit when facing the camera outside by installing it onto the inner wall

of the building rooftop.

4_ SHP-3701H

INSTALLATION (SCP-3430 SERIES)

Please fasten the lower bracket by using the machine screw provided as an accessory

while referring to the ﬁgure below.

※The lower bracket is exclusively for use with the SCP-3430 Series/SNP-5300 Series.

Please install the camera adaptor onto the housing by using the tapping screw provided

as an accessory.

Please make sure that the guide holes of the camera adaptor are ﬁt by using two guide

pins on the lower bracket.

Guide Holes

Alignment

Directions

Alignment

Directions

SHP-3701H _5

●KOR

Please pull out the external cables to the outside through the inner part of

“pipe or mount.”

Please apply the Teﬂon taping around the screw part of the “housing.”

Install onto the pipe by turning the housing in a clockwise direction while referring to the

ﬁgure below.

Pipe or Mount

Housing

Pipe or Mount

1.5”PF (38.1mm)

Outer Cable

1.5”PF (38.1mm)

Teﬂon Tape

Housing

Pitch 0.091”(2.311mm)

Thread angle 55°

6_ SHP-3701H

As shown in the ﬁgure below, separate the Fan & Heater PCB power from the camera set power,

and then connect it to a separate power adaptor. (FAN: AC24V, 5W, HEATER: AV24V, 45W)

After inserting the external camera cable to the housing, connect to the corresponding

jack on the adaptor.

(For the details on the cable connection, please refer to the camera installation manual.)

Please install the camera onto the housing. Please conﬁrm that the adaptor hook is

properly ﬁxed on the camera.

PCB CABLE

ADAPTOR

SHP-3701H _7

●KOR

After conﬁrming that the unit has been installed properly, attach the housing cover

and tighten it ﬁrmly using 4 screws.

INSTALLATION (SCP-3370/SNP-5200 SERIES)

Using the machine screws provided, fasten 3 screw holes in the inside of the

housing and 3 holes on the camera adaptor, referring to the ﬁgure below.

Alignment

Directions

8_ SHP-3701H

Please pull out the external cables to the outside through the inner part of

“pipe or mount”. Please apply the Teﬂon taping around the screw part of the “housing.”

Install onto the pipe by turning the housing in a clockwise direction while referring to the

ﬁgure below.

Pipe or Mount

1.5”PF (38.1mm)

Outer Cable

1.5”PF (38.1mm)

Teﬂon Tape

Housing

Pipe or Mount

Housing

Pitch 0.091”(2.311mm)

Thread angle 55˚

SHP-3701H _9

●KOR

As shown in the ﬁgure below, separate the Fan & Heater PCB power from the camera set power,

and then connect to a separate power adaptor. (FAN: AC24V, 5W, HEATER: AV24V, 45W)

After connecting the camera adaptor and inner cable while referring to the installation

manual, install the camera onto the housing and check if the adaptor hook is fastened

properly onto the camera.

※Remove the dome cover of the camera and install it onto the housing.

After conﬁrming that the unit is installed properly, attach the housing cover and

fasten it ﬁrmly using 4 screws.

PCB CABLE

ADAPTOR

10_ SHP-3701H

INSTALLATION (SCP-3371/SNP-5300 SERIES)

Please fasten the lower bracket by using the machine screw provided as a part while

referring to the ﬁgure below.

※The lower bracket is exclusively for use with the SCP-3430 Series/SNP-5300 Series.

Please install the install base onto the housing by using the tapping screws provided as

an accessory.

Align the position mark on the lower bracket with the screw direction on the install base,

and assemble them.

Alignment

Directions

Install Base Screw

Alignment Guide

Marks of lower

bracket

Inhaltsverzeichnis

Andere Samsung Kamerazubehör Handbücher

Samsung

Samsung SHB-4300H1 Bedienungsanleitung

Samsung

Samsung 136S Bedienungsanleitung

Samsung

Samsung SHG-222 Bedienungsanleitung

Samsung

Samsung SHP-3700H Bedienungsanleitung

Samsung

Samsung SCU-9080 Bedienungsanleitung

Samsung

Samsung SHP-3701F Bedienungsanleitung

Samsung

Samsung SCC-101 Bedienungsanleitung

Samsung

Samsung SPD-3700T Bedienungsanleitung

Samsung

Samsung STH-560PE Bedienungsanleitung

Samsung

Samsung SCU-2370 Bedienungsanleitung

Samsung

Samsung SPD-3750T Bedienungsanleitung

Samsung

Samsung SHG-120 Bedienungsanleitung

Samsung

Samsung SCU-2370 Bedienungsanleitung

Samsung

Samsung SHB-4300H Bedienungsanleitung

Samsung

Samsung SHG-120 Bedienungsanleitung

Samsung

Samsung SCU-2370 Bedienungsanleitung

Samsung

Samsung SCX-300KM Bedienungsanleitung

Samsung

Samsung SHG-220 Bedienungsanleitung

Samsung

Samsung 16mm F2.4 Bedienungsanleitung

Samsung

Samsung SPH-20W/P Bedienungsanleitung

Samsung

Samsung SHD-3000F Bedienungsanleitung

Samsung

Samsung SHD-3000F Bedienungsanleitung

Samsung

Samsung STB-30PF Bedienungsanleitung

Samsung

Samsung SCX-RD100 Bedienungsanleitung

Beliebte Kamerazubehör Handbücher anderer Marken

Viltrox

Viltrox EF-NEX Montageanleitung

Calumet

Calumet 7100 Series CK7114 Bedienungsanleitung

Ropox

Ropox 4Single Series Bedienungsanleitung

Cambo

Cambo Wide DS Digital Series Betriebsanleitung

Ryobi

Ryobi BPL-1820 Bedienungsanleitung

Aegis

Aegis ABL-36020P Bedienungsanleitung

Fantasea

Fantasea EyeGrabber F Series Bedienungsanleitung

Honeywell

Honeywell HDZ20HD Bedienungsanleitung

EGO

EGO BA1400T Bedienungsanleitung

Sima

Sima SRW-62 Bedienungsanleitung

Shape

Shape A7SSMKIT Bedienungsanleitung

Slide Kamera

Slide Kamera HST-2 Bedienungsanleitung

Power works

Power works 2902613 Bedienungsanleitung

SES

SES SE-2047-2 Bedienungsanleitung

Starlite

Starlite OctoDome nxt Bedienungsanleitung

Custom Brackets

Custom Brackets Digital PRO-M Bedienungsanleitung

Vivo

Vivo MOUNT-LT01C Bedienungsanleitung

Sanyo

Sanyo UF-911 Bedienungsanleitung