Samsung Ubigate iBG1003 Bedienungsanleitung

This manual is proprietary to SAMSUNG Electronics Co., Ltd. and is protected by copyright.

No information contained herein may be copied, translated, transcribed or duplicated for any

commercial purposes or disclosed to third parties in any form without the prior written consent of

SAMSUNG Electronics Co., Ltd.

TRADEMARKS

Ubigate iBG1003 is a registered trademark of SAMSNUG Electronics.

All other company and product names may be trademarks of the respective companies with which

they are associated.

This manual should be read before the installation and operation, and the operator should

correctly install and operate the product by using this manual.

This manual may be changed for the system improvement, standardization and other technical reasons

without prior notice.

If you have a question for the content of manual or want to obtain further information on the updated

manual, please contact the homepage below.

Homepage: http://www.samsungdocs.com

Ubigate iBG1003 Installation Manual

GENERAL USER INFORMATION

Radio Frequency Interference

The Ubigate iBG1003 equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to FCC Part 15 Rules.

These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in

a residential area is likely to cause harmful interference in which case the user

will be required to correct the interference at his/her own risk.

GENERAL USER INFORMATION

II © SAMSUNG Electronics Co., Ltd.

FCC Requirements

The Ubigate iBG1003 equipment complies with FCC Part 68 Rules and

requirements adopted by Administrative Council for Terminal Attachment

(ATCA).

FCC Part 68

The FCC Part 68 label is located on the bottom of the chassis.

The label contains:

Product Identifier Number

FCC Registration Number

Ringer Equivalence Number (REN)

NOTE

If requested, this information must be provided to your telephone

company.

Unauthorized Modifications

Any change or modifications performed on this equipment that are not

expressly approved in writing by SAMSUNG ELECTRONICS, CO., LTD.

could cause non-compliance with the FCC rules and void the user’s authority

to operate the equipment.

Ubigate iBG1003 Installation Manual/Ed.04

Telephone Connection Requirement

A plug and jack is used to connect this equipment to the premises wiring and

telephone network must comply with the FCC Part 68 rules and requirements

adopted by the ACTA.

A compliant telephone cord and modular plug is provided with this product

which is designed to connect to a compatible Standard Modular jack.

Connection to the telephone network should be made by using standard

modular telephone jacks, type RJ-11C. The RJ-11C plug and/or jacks used

must comply with the FCC Part 68 rules.

CIRCUIT TYPE MODULE TYPE FACILITY INTERFACE

CODE

NETWORK

JACK

LOOP START

LINE FXO

T1E1 02LS2

04DU9.DN

04DU9.1KN

04DU9.1SN

04DU9.1SN (PRI)

RJ11C

RJ48C

DID LINE FXS

T1E1 02RV2.T

04DU9.BN RJ11C

RJ48C

E & M TIE LINE T1E1 04DU9.BN RJ48C

Ringer Equivalence Number

The REN is used to determine the number of devices to be connected to a

telephone line. If the total allowable REN load is exceeded, the phone circuit

may fail to ring. In most cases, the total REN for a telephone line should not

exceed Five (5).

Contact Local Telephone Company, to be certain about the number of devices

connected to a line, which is determined by the total REN.

For earlier products, the REN is separately shown on the label.

GENERAL USER INFORMATION

IV © SAMSUNG Electronics Co., Ltd.

Incidence of Harm

The telephone company will notify you in advance about the temporary

discontinuation of service, if the Ubigate iBG1003 equipment is causing harm

to the telephone network.

In case advance notification is not feasible, the telephone company will notify

the customer as soon as possible and you will also be advised about your right

to file a complaint with the FCC, if it is necessary.

Changes to Telephone Company Equipment or

Facilities

The telephone company may make changes in its facilities, equipment,

operations or procedures that could affect the operation of the equipment.

If this happens, the telephone company will provide advance notice in order

for you to make necessary modifications to maintain uninterrupted service.

Service Center

If you need assistance during troubleshooting, please contact out local office

SAMSUNG ELECTRONICS, CO., LTD. for repair or warranty information.

If the trouble is causing harm to the telephone network, the telephone

company may request you to remove the equipment from the network until the

problem is resolved.

Field Repairs

Only technicians certified on the Ubigate iBG1003 are authorized by

SAMSUNG ELECTRONICS, CO., LTD. to perform system repairs.

Certified technicians may replace modular parts of a system to repair or

diagnose trouble. Defective modular parts can be returned to SAMSUNG

ELECTRONICS, CO., LTD. for repair.

Ubigate iBG1003 Installation Manual/Ed.04

General

Connection to party line service is subject to state tariffs. Contact the State

Public Utility Commission, Public Service Commission or Corporation

Commission for information.

Direct Inward Dialing (‘DID’)

If the equipment is not operating as per the ProperAnswer Supervision

mentioned in FCC Part 68 rules, then it is a violation.

Rules of PROPER ANSWER SUPERVISION:

Always On the following DID calls, the Equipment returns Answer

Supervision to the Public Switched Telephone Network (PSTN)

Answered by the called station.

Answered by the attendant.

Routed to a recorded announcement that can be administered by the

Customer Premises Equipment (CPE) user.

Routed to a dial prompt.

Always this equipment returns answer supervision on all DID calls

forwarded to the PSTN.

Permissible exceptions are:

A call is unanswered.

A busy tone is received.

A reorder tone is received.

Equal Access Requirements

Through the use of access codes, this equipment is capable of providing user’s

access to interstate providers of operator services. Modification of this

equipment by call aggregators to block access dialing codes is a violation of

the Telephone Operator Consumers Act of 1990.

GENERAL USER INFORMATION

VI © SAMSUNG Electronics Co., Ltd.

Electrical Safety Advisory

Parties responsible for equipment requiringAC power should consider

including an advisory notice in their customer information suggesting them to

use a surge arrestor. Telephone companies report that electrical surges,

typically lightning transients, are very destructive to customer terminal

equipment connected to AC power sources. This has been identified as a major

nationwide problem.

Music on Hold Warning

In accordance with US copyright laws, a license may be required from

the American Society of Composers,Authors and Publishers

(ASCAP) or other similar organizations if copyright music is

transmitted through the Music on Hold feature.

SAMSUNG ELECTRONICS, CO., LTD. hereby disclaims any liability

arising out of failure to obtain such a license.

Direct Inward System Access (DISA) Warning

The lines used for the DISA feature must have the disconnected Supervision

option provided by the telephone company.

As it is impossible to control who may access your DISAline it is

suggested that you do not turn this feature on unless you intend to

use it. If you do use this feature, it is good practice to frequently

change pass codes and periodically review your telephone records for

unauthorized use.

Ubigate iBG1003 Installation Manual/Ed.04

Safety Warnings

High touch current earth connection is essential before making

telecommunication network connection.

Energy Hazard-careful treatment is needed.

Every wire for communication should be larger than 26 AWG.

Double pole/neutral fusing.

Underwriters Laboratories

The Ubigate iBG1003 system has been tested to comply with Safety Standards

in the United States and Canada. This system is listed with Underwriters

Laboratories. The cUL Mark is separately shown on the label.

GENERAL USER INFORMATION

VIII © SAMSUNG Electronics Co., Ltd.

Installation Safety Guidelines and Warnings

Safety Recommendations

The Safety Warnings that appear in this document (such as the one below)

indicate a procedure that can harm you if not done correctly.

Electric hazard exists. Verify the power is turned off. Do not work on

energized equipment. Working on energized equipment can result in

serious electrical shock.

To avoid electric shock, do not connect Safety Extra-Low Voltage

(SELV) circuits (found in LAN ports) to Telephone-Network Voltage

(TNV) circuits (found in WAN ports).

This equipment must be installed and maintained by properly trained

service personnel. Make sure the proper electrical service is available

before plugging the unit and turning it on. Disconnect the

telecommunication lines before unplugging the main power connector.

Cover Panels

Do not operate the Ubigate iBG1003 with missing blank faceplates and cover

panels. These covers prevent exposure to hazardous voltages and currents

inside the chassis. They are important to maintaining proper air flow through

the chassis. They also prevent electromagnetic interference (EMI) that might

disrupt other equipment.

Laser radiation and EMI are present when the router cover panel is

open.

Andere Handbücher für Ubigate iBG1003

Inhaltsverzeichnis

Andere Samsung Netzwerk-Router Handbücher

Samsung

Samsung Connect Home Pro ET-WV520 Bedienungsanleitung

Samsung

Samsung Connect Home Pro ET-WV533 Bedienungsanleitung

Samsung

Samsung iES4028F Programmierhandbuch

Samsung

Samsung MagicLAN SWL-2200U Bedienungsanleitung

Samsung

Samsung SmartThings Wifi ET-WV525 Bedienungsanleitung

Samsung

Samsung OFFICESERV 500 Series Bedienungsanleitung

Samsung

Samsung 5G CPE Bedienungsanleitung

Samsung

Samsung Connect Home Pro ET-WV532 Bedienungsanleitung

Samsung

Samsung Ubigate iBG2016 Programmierhandbuch

Samsung

Samsung DIR-518L Bedienungsanleitung

Samsung

Samsung Ubigate iBG1000 Bedienungsanleitung

Samsung

Samsung SmartThings Wifi ET-WV525 Bedienungsanleitung

Samsung

Samsung Techwin SPN-10050 Bedienungsanleitung

Samsung

Samsung Ubigate iBG2006 Bedienungsanleitung

Samsung

Samsung iES4028FP Bedienungsanleitung

Samsung

Samsung 5G CPE Bedienungsanleitung

Samsung

Samsung Connect Home Pro ET-WV531 Bedienungsanleitung

Samsung

Samsung SCC-RC130 Bedienungsanleitung

Samsung

Samsung DIR-640LA1 Bedienungsanleitung

Samsung

Samsung MWR-SH00N Bedienungsanleitung

Samsung

Samsung Connect Home Pro ET-WV530 Bedienungsanleitung

Samsung

Samsung AHT-E300 Bedienungsanleitung

Samsung

Samsung Ubigate iBG1000 Bedienungsanleitung

Samsung

Samsung iES4028FP Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise

LevelOne

LevelOne FBR-1416 Bedienungsanleitung