Samsung SNO-6095RH Bedienungsanleitung
2 mega network high speed vehicle
number identification & remote
distance surveillance camera
User Manual SNO-6095RH
PT01-004490A-SNO-6095RH-ENGLISH.indd 1 2016-03-28 오후 4:05:46
Copyright
©2015 Hanwha Techwin Co., Ltd. All rights reserved.
Trademark
Each of trademarks herein is registered. The name of this product and other trademarks mentioned in this manual are
the registered trademark of their respective company.
Restriction
Copyright of this document is reserved. Under no circumstances, this document shall be reproduced, distributed or
changed, partially or wholly, without formal authorization.
Disclaimer
Samsung makes the best to verify the integrity and correctness of the contents in this document, but no formal
guarantee shall be provided. Use of this document and the subsequent results shall be entirely on the user’s own
responsibility. Samsung reserves the right to change the contents of this document without prior notice.
Design and specifications are subject to change without prior notice.
The initial administrator ID is “admin” and the password should be set when logging in for the first time.
Please change your password every three months to safely protect personal information and to prevent
the damage of the information theft.
Please, take note that it’s a user’s responsibility for the security and any other problems caused by
mismanaging a password.
2 mega network high speed vehicle
number identification & remote
distance surveillance camera
User Manual
PT01-004490A-SNO-6095RH-ENGLISH.indd 2 2016-03-28 오후 4:05:46
English _3
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings, Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided for
your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/ accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by
the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during lighting storms or when unused for
long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate normally, or has been dropped.
15. This product is intended to be supplied by a Listed Power Supply Unit marked “Class 2”
and rated from 24 Vac (50/60 Hz) min 0.4 A or 12 Vdc, min 0.4 A.
16. Install the power supply in a place with a circuit breaker connected to the interior wiring.
overview
PT01-004490A-SNO-6095RH-ENGLISH.indd 3 2016-03-28 오후 4:05:46
overview
4_ overview
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS PRODUCT TO RAIN OR MOISTURE. DO NOT INSERT ANY METALLIC
OBJECT THROUGH THE VENTILATION GRILLS OR OTHER OPENNINGS
ON THE EQUIPMENT.
Apparatus shall not be exposed to dripping or splashing and that no objects
filled with liquids, such as vases, shall be placed on the apparatus.
To prevent injury, this apparatus must be securely attached to the Wall/ceiling
in accordance with the installation instructions.
WARNING
Hazardous moving parts
Keep away from moving fan blades
CAUTION
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
EXPLANATION OF GRAPHICAL SYMBOLS
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating
and maintenance (servicing) instructions in the literature
accompanying the product.
PT01-004490A-SNO-6095RH-ENGLISH.indd 4 2016-03-28 오후 4:05:46
English _5
Class construction
An apparatus with CLASS construction shall be connected to a MAINS
socket outlet with a protective earthing connection.
Battery
Batteries(battery pack or batteries installed) shall not be exposed to excessive
heat such as sunshine, fire or the like.
Disconnection Device
Disconnect the main plug from the apparatus, if it’s defected. And please call
a repair man in your location.
When used outside of the U.S., it may be used HAR code with fittings of
an approved agency is employed.
CAUTION
yThe product must be installed by an authorized technician. Installation by
unqualified personnel is strictly prohibited.
As installation requires a certain level of technical skill, installing the
product yourself may create the risk of fire of electrical shock. Please
contact your dealer regarding installation.
yIf you notice smoke or abnormal heat coming from the inside of the
housing, stop using it immediately. Continued use may cause a fire.
yDo not install the product in a location with excessive humidity or that is
exposed to oil or gas. Do not install wires with wet hands. This may cause
failure of the product, electrical shock or fire.
yDo not install the product in a location with insufficient strength.This may
cause the risk of the product falling.
yDo not allow a non-professional to disassemble the product. Furthermore,
do not allow any foreign substances to enter the product. This may cause
a failure, electrical shock or fire.
yDo not install the product in a location with a high or low ambient
temperature (the product may not work properly).
yDo not drop the product, or apply severe impact or vibration to it, as this
may cause a failure.
PT01-004490A-SNO-6095RH-ENGLISH.indd 5 2016-03-28 오후 4:05:46
overview
6_ overview
yDo not allow the camera to face the sunlight or intense light.
(This may cause serious damage to the CMOS element or internal circuit.)
yDo not touch the front window (be careful not to leave any fingerprints or
scratches).
yThe product is configured to specific settings to enable the recognition of
number plates. (If a problem occurs, do not operate it arbitrarily - contact
our customer service.)
The ITE is to be connected only to PoE networks without routing to the
outside plant.
Please read the following recommended safety precautions carefully.
yDo not place this apparatus on an uneven surface.
yDo not install on a surface where it is exposed to direct sunlight, near
heating equipment or heavy cold area.
yDo not place this apparatus near conductive material.
yDo not attempt to service this apparatus yourself.
yDo not place a glass of water on the product.
yDo not install near any magnetic sources.
yDo not block any ventilation openings.
yDo not place heavy items on the product.
User’s Manual is a guidance book for how to use the products.
The meaning of the symbols are shown below.
yReference : In case of providing information for helping of product’s usages
yNotice : If there’s any possibility to occur any damages for the goods and
human caused by not following the instruction
Please read this manual for the safety before using of goods and keep it in
the safe place.
PT01-004490A-SNO-6095RH-ENGLISH.indd 6 2016-03-28 오후 4:05:47
English _7
CONTENTS
OVERVIEW
3
3Important Safety Instructions
8Product Features
9What’s Included
10 At a Glance
INSTALLATION &
CONNECTION
13
13 How to install a camera for
vehicle number identification
14 How to connect the power supply
and network
WEB VIEWER
15
15 Connecting to the camera
SETUP SCREEN
16
16 Camera settings - for vehicle
number identification
17 Camera settings - for security
APPENDIX
18
18 Specification
22 Product Overview
PT01-004490A-SNO-6095RH-ENGLISH.indd 7 2016-03-28 오후 4:05:47
overview
8_ overview
PRODUCT FEATURES
•Camera-linked high efficiency lighting using a power-IR LED enables photography of the
number plate of an entering vehicle, even during nights with no illumination.
•The camera power supply and the driver are embedded in the camera.
•As the camera features a built-in circuit to charge a large capacity capacitor, the camera
and its lighting device do not work until charging is completed at the time of the initial
supply of power.
(The camera and the lighting device will work normally approximately 20 to 30 seconds
after the initial supply of power.)
•As the product is released with optimized settings, it is easy to install.
•As the ambient light sensor automatically changes between day and night mode
depending on the ambient lighting, the camera records images in color mode in the day
time and in monochrome mode at night to achieve optimized images.
•Thanks to the electronic shutter inter-operation, the camera consumes only a tenth of
the power and provides 10 times more brightness compared to a continuous illumination
control type camera.
•The camera can be installed in difficult external environments, and has outstanding
dustproof and waterproof functions certified for IP 66, which is the housing protection
grade according to KS C IEC 60529:2006.
•The camera can be operated both in vehicle number identification mode (120km/h travel
speed) and in security surveillance mode. While operating in surveillance (long distance)
mode, the camera can identify an object at a distance of up to 100 meters.
PT01-004490A-SNO-6095RH-ENGLISH.indd 8 2016-03-28 오후 4:05:47
English _9
WHAT’S INCLUDED
Please check if your camera and accessories are all included in the product package.
Appearance Item Name Quantity Description
Screw 2Product installation fixture
Washer spring 2Product installation fixture
Washer 2Product installation fixture
Monitor cable for testing 1Perform camera test by connecting to a
portable display
NETWORK CAMERA
Quick Guide SNB-6005
English
SNB-6005 Quick guide 1
Software CD 1
PT01-004490A-SNO-6095RH-ENGLISH.indd 9 2016-03-28 오후 4:05:48
overview
10_ overview
AT A GLANCE
Main body
Sun shield
Cover
FAN
Compressive fitting
for cable connection
Terminal for
power supply
connection
DC 12V 5A
adapter
Camera, Lens
Fixing latch
CONTROLLER
IR LEDFront glass
window
PT01-004490A-SNO-6095RH-ENGLISH.indd 10 2016-03-28 오후 4:05:49
Inhaltsverzeichnis
Andere Samsung Sicherheitskamera Handbücher
Samsung
Samsung SID-50 Bedienungsanleitung
Samsung
Samsung SNV-5080RN Bedienungsanleitung
Samsung
Samsung SPD-3300 Bedienungsanleitung
Samsung
Samsung SCD-5082 Series Bedienungsanleitung
Samsung
Samsung SCC-B5393 Bedienungsanleitung
Samsung
Samsung SCP-2273 Bedienungsanleitung
Samsung
Samsung SOC-920 Bedienungsanleitung
Samsung
Samsung HCD-E6070R Bedienungsanleitung
Samsung
Samsung SNP-6200 Bedienungsanleitung
Samsung
Samsung Z6806-0796-01A Service-Handbuch
Samsung
Samsung SNV-5010 Bedienungsanleitung
Samsung
Samsung WV SCP-2270H Bedienungsanleitung
Samsung
Samsung SNB-7004 Bedienungsanleitung
Samsung
Samsung SCV-2060 Bedienungsanleitung
Samsung
Samsung SMARTCAM SNH-1011N Bedienungsanleitung
Samsung
Samsung iPolis SNB-7002 Bedienungsanleitung
Samsung
Samsung SCP-3250 Bedienungsanleitung
Samsung
Samsung SCC-C6407 Bedienungsanleitung
Samsung
Samsung SCC-CC4333P Bedienungsanleitung
Samsung
Samsung SCC-C4305(P) Bedienungsanleitung
