Samsung SmartThings ADT Carbon Monoxide Alarm Bedienungsanleitung

ADT Carbon

Monoxide Alarm

Setup Guide

PRINTER’S INSTRUCTIONS:

MANUAL,QUICK START,NOVA,CO - NORTEK P/N: 10015712B- INK: BLACK PLUS PMS 286C - MATERIAL: 105G COATED PAPER - SIZE: 105MM X 105MM - SCALE:

1-1 - BINDING: TRIM, FOLD AND SADDLE STITCHED - PAGE 1 OF 32

Setup

• Make sure that your ADT Security Hub is disarmed

before connecting a new device.

Take the ADT Carbon Monoxide Alarm to where you

intend to mount it after setup.

1. 2.

• Make sure you are within 350 feet from the

ADT Security Hub. (Exact range depends on

your home’s construction, the environment, the

position of the ADT Security Hub, and the position

and number of other connected devices.)

• Make sure that you only setup one new device

at a time.

• Do not remove the battery tab until you are ready

to set up the detector.

Setup Setup

• Make sure that your ADT Security Hub is disarmed

before connecting a new device.

Take the ADT Carbon Monoxide Alarm to where you

intend to mount it after setup.

2. Use the SmartThings app on your smartphone to

select the “My Home” tab. Select "Things", and then

“Add a Thing".

• Make sure you are within 350 feet from the

ADT Security Hub. (Exact range depends on

your home’s construction, the environment, the

position of the ADT Security Hub, and the position

and number of other connected devices.)

• Make sure that you only setup one new device

at a time.

3. Use the SmartThings app to scan the QR code on

the front of the alarm and then follow the on-screen

instructions to complete setup.

QR Code

Carbon Monoxide Alarm (Front)

• Do not remove the battery tab until you are ready

to set up the detector.

Install the ADT Carbon Monoxide Alarm in a place where

the alarm can be heard easily. Ideally, a carbon monoxide

alarm should be installed in:

WARNING: This product is intended for use in ordinary

indoor locations of family living units. It is not designed

to measure compliance with Occupational Safety and

Health Administration (OSHA) commercial or industrial

standards.

• Every room containing a fuel burning appliance.

• Within 10 feet of a sleeping area.

• On every oor of the building.

Setup

5. Remove the QR code from the front of the alarm and

attach it inside the ADT Security Hub User Guide for

future reference.

4. Remove the tab on the carbon monoxide alarm

marked “Pull This Tab”.

Carbon Monoxide Alarm (Back)

Battery Tab

Install the ADT Carbon Monoxide Alarm in a place where

the alarm can be heard easily. Ideally, a carbon monoxide

alarm should be installed in:

WARNING: This product is intended for use in ordinary

indoor locations of family living units. It is not designed

to measure compliance with Occupational Safety and

Health Administration (OSHA) commercial or industrial

standards.

• Every room containing a fuel burning appliance.

• Within 10 feet of a sleeping area.

• On every oor of the building.

Placement

Remove the QR code from the front of the alarm and

attach it inside the ADT Security Hub User Guide for

future reference.

Remove the tab on the carbon monoxide alarm

marked “Pull This Tab”.

Do not place the ADT Carbon Monoxide Alarm in any

of the following areas:

• In the immediate vicinity of a cooking appliance

(keep it at least 5 feet away from it).

• Outside the building.

• In an enclosed space, e. g. in or below a cupboard.

• In a damp or humid area.

• Directly above a sink or cooker.

• Next to a door, window, airvent, or anywhere it could

be affected by drafts.

• Next to an extractor fan.

Placement

Carbon monoxide alarm suggested Locations:

Attic

Bedroom

Kitchen

Basement Garage

Master Bedroom

Family Room

Hallway

Do not place the ADT Carbon Monoxide Alarm in any

of the following areas:

• In the immediate vicinity of a cooking appliance

(keep it at least 5 feet away from it).

• Outside the building.

• In an enclosed space, e. g. in or below a cupboard.

• In a damp or humid area.

• Directly above a sink or cooker.

• Next to a door, window, airvent, or anywhere it could

be affected by drafts.

• Next to an extractor fan.

Placement

Carbon monoxide alarm suggested Locations:

• If mounted on a wall, it should be located at a

height greater than the height of any door or window

but still be at least 5.9 inches from the ceiling.

If locating the ADT Carbon Monoxide Alarm in a room

with a fuel burning appliance:

• If mounted on the ceiling, it should be at least

12 inches from any wall or light tting.

• The alarm should be a horizontal distance of

between 3.28 and 9.84 feet from the potential

carbon monoxide source.

• In rooms with sloped ceilings, the alarm should be

located on the high side of the room.

• Near paint, thinners, solvent fumes, or air fresheners.

• Where dirt or dust could block the detector.

• In a bathroom or other areas where it may be exposed

to water splashes, dripping or condensation, e.g.

above an electric kettle.

• Where it would be obstructed, e.g. by curtains or

furniture.

• In an area where the temperature could be below

-50°F or above 104°F.

• Where it could be easily knocked or damaged, or

accidentally turned off or removed.

• Over heat sources such as radiators or hot air vents.

Placement

• If mounted on a wall, it should be located at a

height greater than the height of any door or window

but still be at least 5.9 inches from the ceiling.

If locating the ADT Carbon Monoxide Alarm in a room

with a fuel burning appliance:

• If mounted on the ceiling, it should be at least

12 inches from any wall or light tting.

• The alarm should be a horizontal distance of

between 3.28 and 9.84 feet from the potential

carbon monoxide source.

• In rooms with sloped ceilings, the alarm should be

located on the high side of the room.

• Near paint, thinners, solvent fumes, or air fresheners.

• Where dirt or dust could block the detector.

• In a bathroom or other areas where it may be exposed

to water splashes, dripping or condensation, e.g.

above an electric kettle.

• Where it would be obstructed, e.g. by curtains or

furniture.

• In an area where the temperature could be below

-50°F or above 104°F.

• Where it could be easily knocked or damaged, or

accidentally turned off or removed.

• Over heat sources such as radiators or hot air vents.

Placement

Carbon Monoxide Alarm Ceiling Placement:

If locating the ADT Carbon Monoxide Alarm in a bedroom

or in rooms remote from a fuel burning appliance:

• Mount the alarm within 10 feet of the occupants.

• Always make sure it is possible to view the three

light indicators when in the vicinity of the alarm.

Carbon Monoxide Alarms should face out in this position:

• If there is a partition in the room, the alarm should

be located on the same side of the partition as the

potential source.

Placement

Inhaltsverzeichnis

Andere Samsung Sicherheitssystem Handbücher

Samsung

Samsung SSC-21WEB Bedienungsanleitung

Samsung

Samsung SDH-P4041 Bedienungsanleitung

Samsung

Samsung SSA-M2000 Bedienungsanleitung

Samsung

Samsung SDS-P3042 Bedienungsanleitung

Samsung

Samsung SSA-C100 Bedienungsanleitung

Samsung

Samsung SME-2220N Betriebsanleitung

Samsung

Samsung SSA-S4000 Bedienungsanleitung

Samsung

Samsung SMO-152QN - Monitor + Camera 4 Bedienungsanleitung

Samsung

Samsung SEW-3037W Bedienungsanleitung

Samsung

Samsung SOD-14C4LN Bedienungsanleitung

Samsung

Samsung SSC17WEB Bedienungsanleitung

Samsung

Samsung SDH-P5080 Bedienungsanleitung

Samsung

Samsung SSC-17TQ Bedienungsanleitung

Samsung

Samsung SDE-5003 Bedienungsanleitung

Samsung

Samsung SDS-P3042 Bedienungsanleitung

Samsung

Samsung SSC17WEB Bedienungsanleitung

Samsung

Samsung SOD-14C4LN Bedienungsanleitung

Samsung

Samsung SDS-P5082 Bedienungsanleitung

Samsung

Samsung ADT Security Hub Bedienungsanleitung

Samsung

Samsung SSA-R1001 Bedienungsanleitung

Samsung

Samsung SDS-P4082 Bedienungsanleitung

Samsung

Samsung iPolis SNM-128S Bedienungsanleitung

Samsung

Samsung SDS-P4040 Bedienungsanleitung

Samsung

Samsung SDS-P3042 Bedienungsanleitung

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung

DSC

DSC PC 4010 Betriebsanleitung

UniPOS

UniPOS 6202L Bedienungsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Rondish

Rondish Nexus Bedienungsanleitung