Sangean DT-120 Bedienungsanleitung

Version 1

DT-120/DT-180

Controls

Display

POWER/BAND button

LCD display

DBB/‧STEP button

Mono/Stereo button

Volume button

Tuning jog wheel/Time setting button

Lock switch

Battery compartment

Strap holder

Earphone jack

Memory button

Selected band

Battery power indicator

Signal level indicator

FM stereo indicator

90 minutes auto shut off

Memory presets

Key lock function

DBB on

Frequency

Controls

Display

POWER/BAND button

LCD display

DBB/‧STEP button

Mono/Stereo button

Volume button

Tuning jog wheel/Time setting button

Lock switch

Battery compartment

Strap holder

Earphone jack

Memory button

Selected band

Battery power indicator

Signal level indicator

FM stereo indicator

90 minutes auto shut off

Memory presets

Key lock function

DBB on

Frequency

Battery cover is located on the back of

the unit. Slide the cover downwards to

gain access to the battery compartment.

Insert two AAA (UM-4) batteries into

the compartment. Make sure that the

battery is positioned in accordance with

the indicated diagram. Replace cover.

Battery Installation

Note:

You can always monitor the battery

power from LCD display battery icon.

When battery power becomes very

low and unable to operate the radio,

low battery indicator will flash

together with an “ E “ appears on the

LCD display. The radio will shut off.

Make sure to replace the batteries

within 3 minutes. This will prevent any

memory presets from being lost during

the battery replacement.

Press and hold Tuning jog wheel for 2

seconds. Hour will ash, turn the Tuning

jog wheel to choose your desired time

and then press in the Tuning jog wheel

to select the digit. After completion of

hour setting, minutes digit will then

flash, following above setting steps to

set minute.

Time setting

Insert the earphone into the earphone

jack. The cord connecting the earphone

to the receiver acts as an antenna

during FM audio reception and should

be extended as much as possible to

increase the sensitivity.

A built-in ferrite bar antenna is provided

for AM reception and it is only necessary

to rotate the radio for maximum signal

strength during AM listening.

Antenna/Earphone

Battery cover is located on the back of

the unit. Slide the cover downwards to

gain access to the battery compartment.

Insert two AAA (UM-4) batteries into

the compartment. Make sure that the

battery is positioned in accordance with

the indicated diagram. Replace cover.

Battery Installation

Note:

You can always monitor the battery

power from LCD display battery icon.

When battery power becomes very

low and unable to operate the radio,

low battery indicator will flash

together with an “ E “ appears on the

LCD display. The radio will shut off.

Make sure to replace the batteries

within 3 minutes. This will prevent any

memory presets from being lost during

the battery replacement.

Press and hold Tuning jog wheel for 2

seconds. Hour will ash, turn the Tuning

jog wheel to choose your desired time

and then press in the Tuning jog wheel

to select the digit. After completion of

hour setting, minutes digit will then

flash, following above setting steps to

set minute.

Time setting

Insert the earphone into the earphone

jack. The cord connecting the earphone

to the receiver acts as an antenna

during FM audio reception and should

be extended as much as possible to

increase the sensitivity.

A built-in ferrite bar antenna is provided

for AM reception and it is only necessary

to rotate the radio for maximum signal

strength during AM listening.

Antenna/Earphone

DT-120 522-1629 kHz

(9kHz)

DT-120 520-1710 kHz

(10 kHz)

Internal/rotate radio for

best reception

87.50-108 MHz

External/Make sure the

earphone in plugged into

earphone jack

Volume Control

Use the volume control knobs to adjust

volume level. Display will show the

changes when you operate the volume

control.

Tuning the radio

Band

Frequency

Antenna

Band

Frequency

Antenna

Turn on the radio, select required band

by pressing POWER/BAND button.

Press and hold down the Tuning jog

wheel for more than half a second and

release the button to commence Scan

Tuning. The radio will scan and stop

automatically when a station is found.

90 Minutes auto shut off

device

For saving battery power, this radio is

designed to auto shut off after 90 minutes

operation, LCD display shows For

continuous listening if necessary,

pressing POWER/BAND button for more

than 2 seconds to turn on the radio.

Scan Tuning

Turn on the radio by pressing and

holding POWER/BAND button. Select

required band by pressing POWER/

BAND button. Tune to the desired

station using the Scan or Manual tuning

steps described above. When the

desired station is reached, press and

hold Memory button (1-5) for more than

2 seconds until display M x stop ashing

followed with a beep (via earphone). It

will replace previous memory station.

You may store 5 memory stations in

each band (AM, FMI, FMII).

Manual Tuning

Turn on the radio, select desired band

by pressing POWER/BAND button.

Desired station may be selected

by turning the Tuning jog wheel

intermittently until the desired station

is reached. Or turning and holding

the Tuning jog wheel until the desired

station is reached.

Memory Tuning (Station

preset)

The radio is designed to receive FM

stereo broadcastings. For weak FM

station, press MO./ST. button to switch

Stereo/Mono to Mono position. LCD

display Stereo icon will disappear.

Recall memory stations

Turn on the radio, select required band

then simply press and release Memory

station button. LCD display will show

Memory preset and radio frequency.

Stereo/Mono switch

Press and release DBB/‧STEP button

to activate the Deep Bass Boost function

to have stronger bass sound, display

will appear DBB symbol. Press again

will cancel the DBB.

Note: Suggest to activate the DBB when

using earphones.

DBB (Deep Bass Boost)

Setting FM frequency range

FM range is different from country. It is

necessary to adjust FM range to allow

the radio to work properly.

Press and hold DBB/．STEP button

when your radio is in power off mode,

the screen will show the software

version (e.g. A03)

Continuing pressing and holding the

DBB/．STEP button, now the screen

will show FM frequency range (e.g.

F00 (or F01-F03).

To choose different FM frequency

range, turn the Tuning jog wheel

up/down and then press the Tuning

jog wheel to select the option. The

frequency range option is available as

following:

F00: 76-90 MHZ

F01: 76-108 MHZ

F02: 87-108MHZ

F03: 64-108 MHZ

Andere Handbücher für DT-120

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sangean Tragbares Radio Handbücher

Sangean

Sangean DT-110 Bedienungsanleitung

Sangean

Sangean DT-200V Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean PR-D4VW Bedienungsanleitung

Sangean

Sangean DT-220A Bedienungsanleitung

Sangean

Sangean DT-110CL Bedienungsanleitung

Sangean

Sangean PR-D9W - Bedienungsanleitung

Sangean

Sangean SR-36 Bedienungsanleitung

Sangean

Sangean H201 Bedienungsanleitung

Sangean

Sangean DT-120 Bedienungsanleitung

Sangean

Sangean DT-120 Betriebsanleitung

Sangean

Sangean PR-D7 Bedienungsanleitung

Sangean

Sangean DT-220 Bedienungsanleitung

Sangean

Sangean PT 10 Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean WR-3 Bedienungsanleitung

Sangean

Sangean PR-D3L Bedienungsanleitung

Sangean

Sangean DT-120 Betriebsanleitung

Sangean

Sangean WFR-32 Bedienungsanleitung

Sangean

Sangean ATS-606AP Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean DT-110CL Bedienungsanleitung

Sangean

Sangean ATS-404 Bedienungsanleitung

Sangean

Sangean ProTravel PT-50 Bedienungsanleitung

Beliebte Tragbares Radio Handbücher anderer Marken

Telefunken

Telefunken P5 Bedienungsanleitung

Tait

Tait TP9300 Bedienungsanleitung

Lafayette

Lafayette Guardian 5500 Bedienungsanleitung

Sailor

Sailor SP3300 Bedienungsanleitung

Matra Nortel

Matra Nortel MC 6500 Bedienungsanleitung

Hytera

Hytera PD362i Bedienungsanleitung

Vertex Standard

Vertex Standard VX-P920 Series Bedienungsanleitung

Roberts

Roberts Ecologic 3 Bedienungsanleitung

LENCO

LENCO IPD-5100 Bedienungsanleitung

Baofeng

Baofeng BF-82 Bedienungsanleitung

Trevi

Trevi RA 764 Bedienungsanleitung

M/A-Com

M/A-Com P5100 Series Bedienungsanleitung

Elta

Elta 6699 Bedienungsanleitung

PURE

PURE ONE classic Series II Bedienungsanleitung

Teac

Teac PR130 Bedienungsanleitung

Philips

Philips AE6370 Bedienungsanleitung

Simoco

Simoco SRP9170 Bedienungsanleitung

Audiovox

Audiovox FR14 Bedienungsanleitung