Sangean WR-3 Bedienungsanleitung

WR-3

User Manual

Important safety instructions

1. Read and understand all safety and operating instructions

before the radio is operated.

2. Retain instruction: The safety and operating instructions should

be retained for future reference.

3. Heed warnings.All warnings on the appliance and operating

instructions should be followed.

4. Follow all operations and use instructions.

5. Water and moisture: The appliance should not be used near

water. Do not use near a bathtub, washbowl, laundry tub,

kitchen sink, wet basement, swimming pool, etc.

6. Unplug the radio from theAC power outlet before cleaning.

Use only a damp cloth for cleaning the exterior of the radio.

7. Do not place the radio on an unstable cart, stand, bracket or

table. The radio may fall, causing serious personal injury and

damage to the radio.

8. Ventilation: This radio should be situated so that its location

or position does not interfere with its proper ventilation. For

example, the radio should not be used on a bed, sofa, rug or

other soft surfaces that may block the ventilation openings.

It should not be placed in a built-in situation like a cabinet that

may reduce air flow through the ventilation openings.

9. Power sources: The radio should be operated only from the type

of power source indicated on the marking label. If you are not

sure of the type of power supply to your home, consult your

radio dealer or power company.

10. Power cords: The power cord should be positioned so it is not

walked on, pinched, or items placed on top of it. Pay particular

attention to cords at plugs, convenience receptacles, and the

point where they exit from the unit. Unplug the power cord by

gripping the power plug, not the cord. Operate the radio using

only the current type of power source indicated. If you are not

sure of the type of power supply to your home, consult your

dealer or local power company.

11. Do not overload wall outlets or extension cords. This can result

in a risk of fire or electrical shock. Never insert objects of any

kind into the radio through opening. The objects may touch

dangerous voltage points or short out parts. This could cause

a fire or electrical shock.

12. If the radio is left attended and unused for long periods of time,

unplug it form the wall outlet. This will prevent damage caused

by lightning or power line surges.

13. If the radio is left unattended and unused for a long period of

time, remove the batteries. The batteries may leak and damage

furniture of your radio.

14. Do not attempt to service the receiver yourself. Removing the

cover may expose you to dangerous voltage, and will void the

warranty. Refer all servicing to authorized service personnel.

15. Object and Liquid Entry-Never push objects of any kind into this

radio through opening as they may touch dangerous voltage

points or short-out parts that could result in a fire or electric

shock. Never spill liquid of any kind of product.

16. The appliance should be serviced by qualified service personnel

when:

The power supply cord or the plug has been damaged.

Objects have fallen or liquid had been spilled into the radio.

The radio has been exposed to rain or water.

The radio does not appear to operate normally or exhibits

a marked change in performance.

The radio has been dropped, or the enclosure damaged.

Controls

LCD display

Remote control sensor

On/Off/Volume control knob

CD slot

CD Eject button

SD card slot

USB device slot

Telescopic antenna

3D Sound switch

Auxiliary in socket

Record Out (Line Out) socket

Headphone socket

Mains input socket

Remote control

On/Off button

PLAY MODE button

SLEEP button

MUTE button

VOLUME UP and Down buttons

0/10 button

EQUALIZER button

TIME SET UP and DOWN buttons

Alarm ON/OFF button

ALARM SET button

SNOOZE button

MODE button

SEARCH button

CT (auto clock time) button

TUNE/MP3 UP button

TUNE/MP3 DOWN button

SEEK/TRACK DOWN button

SEEK/TRACK UP button

PAUSE/PLAY button

STOP button

KEYPAD buttons

MEMORY button

AUX/SD/USB button

Radio button

ST/MO button

CD button

Remote battery replacement

1. Pull and hold the tab of the battery tray in the direction shown.

And slide the holder out.

2. Remove battery from holder.

3. Replace battery (CR2025 or equivalent) ensuring that the

positive side of the battery faces you with holder positioned

as shown.

4. Put the battery holder back into the remote control.

Clock setting

You will need to set the clock before the alarm function can be set.

1. Press and hold the TIME SET button (either UP or Down), until

the minute digits on the display flash, then release the button.

2. When the minute digits are still flashing, press the TIME SET UP

or DOWN button to the desired time is set.

* Press TIME SET button once for 1 minute, press and hold to

make the adjustment run faster to change the hour digits.

3. Without touching the buttons for 7 seconds, the time will be set

and the time digits will stop flashing.

Radio Operation

FM/MW (AM) operation

1. Switch on your radio by pressing the On/Off button on the

remote control or by pressing the Control knob on the radio.

2. Press and release the RADIO button until “FM” or “MW” (AM)

shows on the display and the radio will enter the FM or

MW (AM) mode.

3. Press the SEEK UP or DOWN button and the radio will

scan for the next active frequency. Or, press the TUNE UP or

DOWN button to select a higher or lower a step of

frequency, until the active frequency is found.

* 1 FM step = 50 kHz or 100 kHz

1 MW (AM) step = 9 kHz or 10 kHz

4.Adjust the Volume by pressing VOLUME UP or DOWNbutton on

the remote control, or by rotating the control knob on the radio.

5.Adjust 3D Sound switch to the required settings.

(on the back panel)

6. To switch off your radio press the On/Off button.

Volume control

Press VOLUME UP/Down or rotate the Control knob on the

radio. There are 40 levels of volume.

Presetting stations

There are 10 memory presets on each of the MW and

FM wavebands.

1. Press the On/Off button to switch on your radio.

2. Tune to the station you would like to preset (tune as

previously described).

3. Press MEMORY button . “MEM” will be shown on the display.

4. Press the required Preset button (1 to 10).

5. Press MEMORY button again and the preset will be stored,

and “MEM” will disappear from the display.

6. Repeat this procedure for the remaining presets.

7. Stations stored in preset memories may be overwritten.

Recalling a preset station

1. When the radio is on, select FM or MW (AM) by pressing the

RADIO button.

2. Press the required Preset button (1-10), your radio will tune to

the station stored in preset memory.

FM RDS

The Radio Data System (RDS) is a system in which inaudible

digital information in addition to the normal FM radio program is

transmitted. Under FM band, it provides functions such as

Clock Time, Music Type Search and Information Mode:

* The information display is only available when the station

provides R.D.S service.

Clock Time:

Press the R.D.S CT button and the display will show the time.

Music Type:

1. Press the R.D.S SEARCH button repeatedly until the display

shows the type of radio stations you would like to search.

2. Then press the SEEK UP/Down to search for radio stations

of selected type.

3. If there is no station for the selected type, the display will show

“No MATCH” for 2 second.

Information Mode:

Press R.D.S MODE button to cycle through the various modes.

The order of the modes is

Frequency PS PTY RT Frequency

1. Frequency:Displays frequency of the station.

2. PS: Program Service- Displays name of station.

3. PTY: Program Type- Displays the program type.

4. RT: Radio Text- Displays ratio text messages such as news

items etc.

Andere Handbücher für WR-3

Inhaltsverzeichnis

Sprachen:

Andere Sangean Tragbares Radio Handbücher

Sangean

Sangean DT-120CL Bedienungsanleitung

Sangean

Sangean PT 10 Bedienungsanleitung

Sangean

Sangean DT-220 Bedienungsanleitung

Sangean

Sangean DT-120 Bedienungsanleitung

Sangean

Sangean DT-120 Betriebsanleitung

Sangean

Sangean DT-110CL Bedienungsanleitung

Sangean

Sangean DT-110 Bedienungsanleitung

Sangean

Sangean DT-120CL Bedienungsanleitung

Sangean

Sangean ATS-606AP Betriebsanleitung

Sangean

Sangean ATS-606AP Bedienungsanleitung

Sangean

Sangean WR-1 Bedienungsanleitung

Sangean

Sangean ATS-505P Bedienungsanleitung

Sangean

Sangean PR-D7 Bedienungsanleitung

Sangean

Sangean DT-180 Bedienungsanleitung

Sangean

Sangean MMR-99DAB Bedienungsanleitung

Sangean

Sangean DT-300 Bedienungsanleitung

Sangean

Sangean DT-210 Bedienungsanleitung

Sangean

Sangean PR-D14USB Bedienungsanleitung

Sangean

Sangean PR-D4VW Bedienungsanleitung

Sangean

Sangean DT-200X Bedienungsanleitung

Sangean

Sangean DT-120 Bedienungsanleitung

Sangean

Sangean PR-D8 Bedienungsanleitung

Sangean

Sangean PR-D5CL Bedienungsanleitung

Sangean

Sangean U4 DBT+ Bedienungsanleitung

Beliebte Tragbares Radio Handbücher anderer Marken

Telefunken

Telefunken P5 Bedienungsanleitung

Tait

Tait TP9300 Bedienungsanleitung

Lafayette

Lafayette Guardian 5500 Bedienungsanleitung

Sailor

Sailor SP3300 Bedienungsanleitung

Matra Nortel

Matra Nortel MC 6500 Bedienungsanleitung

Hytera

Hytera PD362i Bedienungsanleitung

Vertex Standard

Vertex Standard VX-P920 Series Bedienungsanleitung

Roberts

Roberts Ecologic 3 Bedienungsanleitung

LENCO

LENCO IPD-5100 Bedienungsanleitung

Baofeng

Baofeng BF-82 Bedienungsanleitung

Trevi

Trevi RA 764 Bedienungsanleitung

M/A-Com

M/A-Com P5100 Series Bedienungsanleitung

Elta

Elta 6699 Bedienungsanleitung

PURE

PURE ONE classic Series II Bedienungsanleitung

Teac

Teac PR130 Bedienungsanleitung

Philips

Philips AE6370 Bedienungsanleitung

Simoco

Simoco SRP9170 Bedienungsanleitung

Audiovox

Audiovox FR14 Bedienungsanleitung