Sanyo POA-SR-140 Bedienungsanleitung

MODEL POA-SR-140

Smoke Resistant Box

Owner's Manual

Before operating this Projector, read this manual thoroughly and operate the projector properly.

Provide appropriate space on the top, sides and rear of the Projector and Smoke Resistant Box for allowing

air circulation and cooling the Projector. Minimum clearance must be maintained. If the Projector is to be

built into a compartment or similarly enclosed, the minimum distances must be maintained. Do not cover the

ventilation slot on the Projector and Smoke Resistant Box. Heat buildup can reduce the service life of your

projector and Smoke Resistant Box, and can also be dangerous.

READ AND KEEP THIS OWNER'S MANUAL FOR LATER USE.

TO THE OWNER

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO

USER-SERVICEABLE PARTS INSIDE EXCEPT FILTER REPLACEMENT. REFER SERVICING TO

QUALIFIED SERVICE PERSONNEL.

WARNING :

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

THIS SYMBOL INDICATES THAT DANGER-

OUS VOLTAGE CONSTITUTING A RISK OF

ELECTRIC SHOCK IS PRESENT WITHIN

THIS UNIT.

THIS SYMBOL INDICATES THAT THERE

ARE IMPORTANT OPERATING AND MAIN-

TENANCE INSTRUCTIONS IN THE OWN-

ER'S MANUAL WITH THIS UNIT.

Federal Communication Commission Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15

of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such

changes or modifications should be made, you could be required to stop operation of the equipment.

CAUTION

This is a Class A equipment. This equipment can cause interference in residential areas; in this case, the operator

can be asked to take adequate countermeasures.

The CE Mark is a Directive conformity mark of the European Community (EC).

•The Smoke Resistant Box protects the projector

from dust and cigarette smoke by adopting a highly

efficient filter.

•Provide two powerful silent rotary fans, and cool

down the Projector efficiently.

•It has been designed for easy mounting.

FEATURES

FEATURES ················································································································ 3

PART NAMES············································································································ 4

INSTALLATION ········································································································· 5

OPERATION ·············································································································· 7

FILTER REPLACEMENT···································································································· 8

FILTER TIME CHECK AND RESET··················································································· 10

APPENDIX·················································································································11

MAINTENANCE ················································································································· 11

TROUBLESHOOTING········································································································ 11

DIMENSIONS

SPECIFICATIONS

TABLE OF CONTENTS

PART NAMES

MOUNTING SCREWS

(provided on each corner)

(Screws are provided in the holes)

INDICATORS

CONNECTOR

FILTER

FILTER COVER

(AIR INTAKE VENTS)

REAR

FRONT

Please ensure that there is sufficient clearance around the unit at the time of installation, as shown in the

figure on the right.

Take out the Smoke Resistant Box from the

packaging and place it on a flat surface with the

projector.

Take off the connector cover from the Projector.

INSTALLATION

PRECAUTION BEFORE INSTALLATION

WARNING: DO NOT COVER INTAKE

VENTS.

If the Air Intake is covered, there will be in-

sufficient cooling which may result in failure

or fire.

CAUTION:UNPLUG THE PROJECTOR FROM THE AC OUTLET WHEN INSTALLING THE

SMOKE RESISTANT BOX.

ATTACHING THE SMOKE RESISTANT BOX WHILE THE PROJECTOR IS CONNECTED TO

ELECTRICITY MAY DAMAGE THE BOX OR CAUSE IT TO MALFUNCTION.

AIR INTAKE VENTS

At least 20'' (50cm)

30''

(75cm)

At least

40''

(100cm)

FRONT

PROCEDURE OF INSTALLATION

CONNECTOR COVER

RETAIN THE CONNECTOR COVER.

WHEN THE SMOKE RESISTANT BOX IS NOT

BEING USED, REATTACH THE CONNECTOR

COVER TO THE PROJECTOR TO PROTECT

THE CONNECTOR.

Align the connector of the Projector with the

connector pins of the Smoke Resistant Box.

Hold the Smoke Resistant Box parallel to the

Projector and push it slowly towards the Projector.

Hold the Smoke Resistant Box with one hand and

use a Phillips-head screwdriver to tighten the four

fixed screws to fix the box in place.

Check that the Smoke Resistant Box is fixed in place with the four screws and no wide gap exists

between the projector body and the box.

INSTALLATION

CAUTION:

TAKE CARE NOT TO TOUCH

THE CONNECTOR OR APPLY SHOCK

THAT MAY DAMAGE THE CONNECTOR.

PINS

PHILLIPS-HEAD

SCREWDRIVER

THERE SHOULD BE NO WIDE GAP THERE SHOULD BE NO WIDE GAP

When the Projector is turned on, the POWER indicator lights in green.

*When the POWER indicator does not light and the WARNING FILTER indicator flashes, the filter is not

attached to the Smoke Resistant Box. In this case, the READY indicator on the Projector does not light

and the Projector can not be turned on.

INDICATORS OPERATION

WARNING FILTER. . . . Normally this does not light. Should the filter become clogged with dust particles

indicator flashes orenge. When the filter needs to be replaced, indicator lights in

orange. The filter should then be replaced immediately. When the filter is not

attached, the indicator will flash.

WARNING . . . . . . . . . . Normally this does not light. When the box's fan is operating abnormally, indicator

flashes red. When this occurs, turn off power immediately and request a

maintenance check. Do not leave the Smoke Resistant Box operational while the

indicator is flashing as it may become a fire and/or accident hazard.

When the Smoke Resistant Box is used for the first time, the initial set-up should be performed in the

following procedures. The Smoke Resistant Box cannot be operated or handled properly without this initial

set-up.

First, properly attach the Smoke Resistant Box to

the Projector.

Turn on the Projector and display some images.

Check that each indicator on the Smoke Resistant

Box lights normally.

Go to next page

OPERATION

INDICATORS

ORANGE

REDGREEN

OFFOFFON

INITIAL SET-UP BEFORE USE

Select [SPECIAL] in the Projector's menu. Then select [Filter].

Select [Option box] and then select [Reset] and then [ Yes].

A message [Please wait---] will appear.

When this message disappears initial set-up is complete. Close the menu.

When replacing the filter, replace with a specified filter. A replacement filter can be ordered through your

dealer. When ordering the filter, give the following information to the dealer.

• Replacement Filter type No. : POA-FIL-140

• Smoke Resistant Box type No. : POA-SR-140

Press the PUSH button on the filter cover.

OPERATION

FILTER REPLACEMENT

PUSH BUTTON

CAUTION:WHEN REPLACING THE FILTER, TURN OFF THE PROJECTOR.

Open the filter cover and take out the used filter.

Install the new filter.

Check that the filter is not tilted or warped and then

close the filter cover. This will lock it into place.

Reset the filter time.

Refer to "FILTER TIME CHECK AND RESET"

OPERATION

FILTER COVER

USED FILTER

CAUTION:

USE ONLY REPLACEMENT

FILTERS RECOMMENDED BY THE

MANUFACTURER. THE USE OF OTHER

FILTERS MAY CAUSE THE BOX TO

MALFUNCTION OR ACCIDENT MAY

RESULT.

CAUTION:TAKE CARE NOT TO DAMA-

GE THE FILTER DETECTION SWITCH

LOCATED INSIDE THE BOX WHEN IN-

SERTING THE FILTER.

NEW FILTER

FILTER DETECTION

SWITCH

The filter operation time can be checked in the

projector menu.

Open [INFORMATION] in the menu and check

[Option filter time] for the hour counter.

"Option filter time" menu will not exist when Smoke

Resistant Box is not attached on the projector.

Reset the filter time according to the following procedures:(Only reset the filter time when changing the filter.

The Smoke Resistant Box cannot be operated properly if it is reset other than filter change.)

Check that the Smoke Resistant Box is properly

attached to the projector.

Turn on the projector and display the screen.

Check all indicators on the Smoke Resistant Box

light normally.

Select [SPECIAL] in the projector's menu. Then

select [Filter].

Select [Option box] and then select [Reset] and then

[Yes].

A message [Please wait--] will appear. When it disappears Filter Time reset is completed. Close the

menu.

OPERATION

FILTER TIME CHECK AND RESET

FILTER TIME CHECK

RESETTING THE FILTER TIME

OFFOFFON

•

※

Andere Handbücher für POA-SR-140

Inhaltsverzeichnis

Andere Sanyo Projektorzubehör Handbücher

Sanyo

Sanyo MT-EDU102 Bedienungsanleitung

Sanyo

Sanyo POA-MD11DVI Stücklistenhandbuch

Sanyo

Sanyo LNS-S02Z Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo LNS-T02 Series Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo PJ-Net Organizer POA-PN01 Bedienungsanleitung

Sanyo

Sanyo LNS-S30 - Zoom Lens - 48.4 mm Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo PJ-Net Organizer Plus POA-PN02 Bedienungsanleitung

Sanyo

Sanyo LNS-T01 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo POA-FBOX130 Bedienungsanleitung

Sanyo

Sanyo POA-MD03VD2A - Projector Terminal Expansion... Stücklistenhandbuch

Sanyo

Sanyo POA-MD03VD2A Stücklistenhandbuch

Sanyo

Sanyo LNS-S03 - Zoom Lens - 97 mm Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo LNS-W10 - Wide-angle Zoom Lens Bedienungsanleitung

Sanyo

Sanyo POA-CH-EX06 Bedienungsanleitung

Sanyo

Sanyo LNS-W20 Bedienungsanleitung

Sanyo

Sanyo LNS-W32 - Wide-angle Lens - 22.3 mm Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo LNS-M01 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo PLC-LNS07 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo MLP-001 Bedienungsanleitung

Sanyo

Sanyo LNS-W10 - Wide-angle Zoom Lens Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo PLC-XU116 - 4500 Lumens Montageanleitung

Sanyo

Sanyo LNS-S02 Gebrauchs- und Pflegehandbuch

Sanyo

Sanyo PLC Bedienungsanleitung

Sanyo

Sanyo POA-MD18DVI Stücklistenhandbuch

Beliebte Projektorzubehör Handbücher anderer Marken

Optoma

Optoma BX-AL133B Bedienungsanleitung

PEERLESS

PEERLESS PE 1120 Leitfaden

Osram

Osram SIRIUS HRI Series Handbuch

Presentation Switchers

Presentation Switchers PS111 Bedienungsanleitung

Kramer

Kramer VIA GO Bedienungsanleitung

Yamaha

Yamaha PJL-112 Stücklistenhandbuch

Mitsubishi Electric

Mitsubishi Electric 236CB Betriebsanleitung

Epson

Epson BrightLink 475Wi Bedienungsanleitung

Acer

Acer WP100 Bedienungsanleitung

i3 i3board Bedienungsanleitung

CHIEF

CHIEF HB-43E Bedienungsanleitung

Biamp

Biamp Modena Hub Service-Handbuch

NEC

NEC MP10RX Bedienungsanleitung

Panamorph

Panamorph DCR-S3 Bedienungsanleitung

Exact solutions

Exact solutions FRAME-EVO-P10 Bedienungsanleitung

CHIEF

CHIEF VCM103S Bedienungsanleitung

InFocus

InFocus LP70+ Leitfaden

Sharp

Sharp AN-PH20EZ Bedienungsanleitung