Scotsman TC 180 Handbuch

AC/EC Self Contained

Cuber

Cleaning & Sanitizing Procedure

Hubbard Systems –01473 350045

Revision - 29/5/2015

Note - This document is to give the preferred instruction as to how cleaning and sanitising of the self contained

ice machine is completed. This does not replace the instruction given within the full service manual, but to

assist and supplement it.

Cleaning should only be undertaken by competent or trained personnel.

Note - Good hygiene working practice should be undertaken before and during any cleaning regime.

Cleaning Schedule

WARNING; Before carrying out any cleaning operation, please ensure that the ice maker is

disconnected from the electrical supply.

NOTE –If external stainless steel panels are not cleaned regularly, brown stains could begin to show.

It is important to prevent these brown stains forming on these stainless steel surfaces otherwise

there is a risk of a chemical reaction which could penetrate the chromium oxide film, this could

result in a ‘rust’ and ‘pitting’ of the panels.

Do not use abrasive products, such as steel wool pads, acids etc. Since these could damage the

various surfaces. In case of persistent stains, normal abrasive detergents or products specific for

stainless steel are readily available on the market.

Suggested Weekly Cleaning.

Pull out the removable condenser air filter on the front of the machine, vacuum to clean or wash in

clean water and dry, refit it in to the runner moulding once complete.

Wipe all external stainless steel panels & front panel assembly with a soft cloth and suitable

sanitising solution (Or pre-impregnated sanitizing wipes specific to the task).

Empty/Scoop out all the ice cubes stored into the bin in order to prevent them from being

contaminated with the cleaning solution used.

Wipe clean and rinse the inner surfaces of the storage bin using an appropriate sanitising product

along with the cleaning of the ice level sensor lenses on the inside of the unit storage bin.

Suggested Monthly Cleaning Procedure:

Follow the above procedure for ‘Weekly cleaning’ and also include the following……………

4. Remove the plastic cap & spring located on the bottom of sump/freezing chamber to drain out all

water and scale deposits. (On the AC/EC 206 & 226 remove the plastic sump cap in the storage bin)

5. Lift up and remove the curtain. (No curtain is fitted on the AC/EC 206 & 226)

AC/EC 46 through 176 AC/EC206 & 226

6. Lift up the entire spray platen from its bottom seat/spigot and take out to clean it separately.

7. Pour fresh water into the bottom of the sump/freezing chamber to clean out any build up of scale

deposit present.

8. Following removal & cleaning, soak all components in a mix of sanitising solution in a suitable

container to hold all items. Rinse thoroughly after ten minutes.

9. Install again the spray platen, the curtain, as well as the bottom plastic cap.

If the water system is to be sanitised, it is to be completed as per the preferred instruction further

down this document (Page 6)

Quarterly & Bi-Annual - Cleaning/Sanitising Procedure.

CLEANING/SANITISING INSTRUCTIONS OF WATER SYSTEM

Clean/Sanitise the water system, evaporator, bin and spray jets using a solution of a suitable

Ice Machine Cleaner/Sanitiser.

NOTE. Cleaning requirements vary according to the local water conditions and individual

user operation. Continuous check of the clarity of ice cubes and visual inspection of the water

spraying parts before and after cleaning will indicate frequency and procedure to be followed in

local areas.

1. Remove the front and top unit panels to gain access to both the control box and the evaporator

section.

2. Make sure that all ice cubes have been released from their cups after a harvest, then switch OFF

the machine at the front master button switch (green) visible through the front panel.

3. Empty/Scoop out all the ice cubes stored in the bin of the unit.

4. Remove the plastic cap & spring located on the bottom of sump/freezing chamber to drain out all

water and scale deposits. (On the AC/EC 206 & 226 remove the plastic sump cap in the storage bin)

5. Lift up and remove the curtain (No curtain is fitted on the AC/EC 206 & 226)

AC/EC 46 through 176 AC/EC206 & 226

6. Lift up the entire spray platen from its bottom seat and take it out to clean it separately. The spray

bar on the 206/226 is located onto a spigot in the sump area.

7. Pour fresh water into the bottom of the sump/freezing chamber to clean out any build up of scale

deposit present.

8. Install again the spray platen/spray bar and the curtain as well as the bottom plastic cap.

Cleaning

9. Prepare the cleaning (descaling) solution by diluting into a container, warm water (hand hot !!)

with a quantity of Ice Machine Cleaner based on 10% dilution rate (ie –5 litres of water, 500ml

descaling acid).

WARNING. The Ice Machine Cleaner/Sanitiser contain harmful fluids.

Please refer to any supplied MSDS document issued for handling of fluids.

KEEP OUT OF THE REACH OF CHILDREN.

10. Remove the plastic evaporator cover slowly pour onto the evaporator platen the cleaning

solution. With the help of a brush, dissolve the most resistant and remote scale deposits in the

platen.

11. Switch ON again the machine at the front master button switch, push the PC BOARD PUSH

BUTTON for more than 2" and less than 5" to put the machine in cleaning mode. ALL LED’s should

begin flashing to indicate the clean mode.

NOTE. With the system in CLEANING/RINSING mode, the water pump is the only component in

operation to circulate the cleaning solution in the entire water system while the three leds of the PC

Board are blinking.

12. Let the unit remain in the CLEANING mode for about 20 minutes then turn off/unplug again the

machine.

NOTE. The amount of Cleaner and the time needed for the cleaning of water system depends on the

water conditions locally.

13. Ensuring that the unit is isolated at the master button switch, flush out the cleaning solution

from the sump reservoir by taking off the sump plastic cup. Once flushed out, install again the sump

plastic cap.

14. Pour over the evaporator two or three litres of clean potable water to rinse the mold cups

and the evaporator platen.

15. Switch ON again the electrical supply to the machine. With the machine in ‘clean mode’ the

water pump is again in operation to circulate the water in order to then rinse the entire water

system. Repeat this operation as per steps 13 and 14 twice more so to be sure no traces of descaling

solution remain into the water sump area.

Sanitising

NOTE. Sanitising of the water system is recommended to be done once a month.

1. Prepare in a plastic container the preferred sanitation solution as per manufacturer dilution using

warm water (hand hot !!!) –approx a 10% ratio is suggested.

NOTE. Never mix the descaling solution with the sanitising solution.

2. Follow the procedures as per cleaning (from item 10 to item 14) just shortening the operation of

the water pump ‘clean/rinse mode’ to 10 minutes for sanitising.

3. Place again the evaporator cover and the unit service panels.

4. At completion of the freezing and harvest cycle make sure of proper texture and clearness of the

ice cubes and that, they do not have any acidic taste. Allow the unit to make 2 further batches of ice

to then discard…………

ATTENTION. In case the ice cubes are cloudy-white and have an acidic taste, melt them

immediately by pouring on them some warm water. This to prevent that somebody could use

them.

5. Wipe clean and rinse the inner surfaces of the storage bin along with the cleaning of the ice level

sensor on the inside of the unit storage bin before resuming normal ice making operation.

Hubbard Systems offers suitable product for the use for cleaning & sanitizing of all ice

dispensers, please call 01473 350045 for further detail and the appropriate MSDS data

sheets.

Andere Handbücher für TC 180

Inhaltsverzeichnis

Andere Scotsman Eiswürfelbereiter Handbücher

Scotsman

Scotsman TC 180 Bedienungsanleitung

Scotsman

Scotsman CME506 Bedienungsanleitung

Scotsman

Scotsman MDT5N25 Bedienungsanleitung

Scotsman

Scotsman CS55 Bedienungsanleitung

Scotsman

Scotsman F1322L Bedienungsanleitung

Scotsman

Scotsman TouchFree MDT5N40 Bedienungsanleitung

Scotsman

Scotsman SCCG50 Enodis Bedienungsanleitung

Scotsman

Scotsman CMS1402 Bedienungsanleitung

Scotsman

Scotsman Self Contained Cuber CU1526 Bedienungsanleitung

Scotsman

Scotsman DC33 Bedienungsanleitung

Scotsman

Scotsman Self Contained Cuber CU1526 Bedienungsanleitung

Scotsman

Scotsman Prodigy Plus A Series Bedienungsanleitung

Scotsman

Scotsman TC 180 Handbuch

Scotsman

Scotsman Prodigy Plus C0830 Bedienungsanleitung

Scotsman

Scotsman NM1250R Bedienungsanleitung

Scotsman

Scotsman MV 426 Betriebsanleitung

Scotsman

Scotsman iceValet HD22 Bedienungsanleitung

Scotsman

Scotsman NME1250R Bedienungsanleitung

Scotsman

Scotsman AFE325 Installationsanleitung

Scotsman

Scotsman HID312 Bedienungsanleitung

Scotsman

Scotsman Residential Ice Machines SCC50 Merkblatt

Scotsman

Scotsman MDT3F Bedienungsanleitung

Scotsman

Scotsman NM1852 Bedienungsanleitung

Scotsman

Scotsman CS60 Bedienungsanleitung

Beliebte Eiswürfelbereiter Handbücher anderer Marken

Hoshizaki

Hoshizaki KMD-460MWJ Bedienungsanleitung

Sub-Zero

Sub-Zero 315I Gebrauchsanweisung

Unold

Unold 48945 Bedienungsanleitung

Kenmore

Kenmore 2217402A Bedienungsanleitung

Cornelius

Cornelius WM600 Betriebsanleitung

GE XPIO43SCSS Bedienungsanleitung

Hoshizaki

Hoshizaki KMD-901MAH Bedienungsanleitung

Whynter

Whynter FIM-450HA Bedienungsanleitung

U-Line

U-Line UMCR014-SC01A Installationshandbuch

Andrew James

Andrew James AJ000522 Bedienungsanleitung

Kärcher

Kärcher IP 120 Bedienungsanleitung

U-Line

U-Line SS1095 Bedienungsanleitung

Maytag

Maytag MIM1554WRS - Ice Maker Bedienungsanleitung

Hoshizaki

Hoshizaki KM-630MAH Bedienungsanleitung

Princess

Princess Yonanas Bedienungsanleitung

Unold

Unold 48946 Bedienungsanleitung

Electrolux

Electrolux E15IM60GP Bedienungsanleitung

Cornelius

Cornelius UC150 ICE ONLY Bedienungsanleitung