screwfix Mendip Bedienungsanleitung
Mendip
You will need
Filter mixer
Barcode: 5059340229867
[01] x 1
[08] x 2
[04] x 1
[06] x 1
[05] x 1 [07] x 1
[09]
x 2
Contains parts which if these become loose could be a
choking hazard to small children. After installation please
check that the bar levers into the tap heads and the plug
lift rod are secure, if required please use low strength
thread lock to secure these parts.
Please pass these instructions back onto householder for
retention for future reference.
Caution
min.
80mm min.
15mm
max.
3Nm
NOTE!
Do not over bend the flexible hoses.
Please retain for future reference.
Before you start
This tap is suitable for use at water supply pressures of
0.5 bar (min.) to 5 bar (max.).
This product must be connected to the water supply in
accordance with the UK Building Regulations. If you are in
any doubt about these requirements，contact a qualified
plumber,your local Water Company, or the Water
Regulations Advisory Scheme(WRAS).
(a) Identify all components and check pack contents.
(b) Turn off mains water supply. The main stopcock is
usually situated where the supply enters the buiding
(c) It is also recommended that the water heating
arrangements are turned off.
(d) Drain the cold and hot water system. It is recommended
to ensure complete drainage,that all taps are opened.
There is no need to drain the heating system.
Ensure the tap is fully turned off after use.
To maintain the appearance of this fitting, ensure it is
cleaned only using a clean soft damp cloth. A solution of
warm water and mild liquid detergent may be used where
necessary and then rinsed thoroughly.
Abrasive cleaners or acidic cleaners MUST NOT BE USED
under any circumstances
Avoid contact with solvents.
After Care
This tap is guaranteed to be free from faults arising from
manufacturing defects for a period of 10 Years from the date
of purchase
Retain proof of purchase.
Manufacturer’s guarantee
UK Manufacturer:
Kingfisher International Products Limited,
3 Sheldon Square, London, W2 6PX,
United Kingdom
www.kingfisher.com/products
www.screwfix.com
EU Manufacturer:
Kingfisher International Products B.V.
Rapenburgerstraat 175E
1011 VM Amsterdam
The Netherlands
www.screwfix.ie
V10621 BX220IM
[02] x 1 [03] x 1
[10] x 1 [11] x 1 [12] x 1
[13] x 1
01 03
02
04
[05]x1
[04]x1
[06]x1
[07]x1
[08]x2
09
[09]x2
04
05
06
07
08
Please check sink thickness before installing.
No. (05) mounting seat is not needed if the
thickness is more than 35mm.
[02]x1
[03]x1
02
03
[11]x1
[13]x1
57mm
13
1 2
3 4
5
5~6mm
φ3.5mm
Not Included
[B] [C]
[A]
A. Filter B. Hot C. Cold
10
11
01
[10]x1
[01]x1
>35mm
m
m
5
3
90mm+
[B]
[C]
05
07 Filtration control
Press to filter the water
unfiltered
hot/cold
water
filtered
water
Regular water flow control
1.Pull the handle out to, turn on and to control
the flow.
2.Turn it on for cold water, turn forward 45
degrees for mixed water, and forward 90
degrees for hot water.
06
12
[12] x1
08 Filter replacement
1
2
A. Hot B. Cold
[C]
[D]
[D][C]
Replace filter every 6 months!
C. Inlet D. Outlet
[A]
[B]
Andere screwfix Küchen- und Badezimmerausstattung Handbücher
Beliebte Küchen- und Badezimmerausstattung Handbücher anderer Marken
Alpha Bidet
Alpha Bidet Alpha One Bedienungsanleitung
InSinkErator
InSinkErator H/HC3300 Installationshandbuch
Clou
Clou Xo type 1 Bedienungsanleitung
Kohler
Kohler Contra 26448T-4 Bedienungsanleitung
Grohe
Grohe Bridgeford 20 158 Bedienungsanleitung
Hans Grohe
Hans Grohe Croma Select S 180 Showerpipe EcoSmart... Bedienungsanleitung