BEFORE INSTALLING THIS PRODUCT
When replacing the fuse, be sure to only use a fuse
of the rating specified on this product.
To avoid short-circuiting, cover any disconnected leads with insulating
tape. It is especially important to insulate any unused wires, which if left
uncovered may cause a short circuit. When connecting other devices to this
product, refer to the manual for the product to be connected. The black cable
is ground, make sure to connect the ground wire first.
could result in fire or malfunction.
Ensure that the ground cable is properly connected to metal parts of the
vehicles body frame or direct to the battery if your vehicle does not have a
grounded chassis frame The ground cable of this units power amp and a
second powered system must be connected to the frame separately with
different screws. If the screw for the ground wire loosens or falls out, it
To avoid potential shorts in the
electrical system, be sure to
disconnect the (–) battery cable before
installation. Use this unit with a 12-volt
battery and negative grounding only.
malfunction.
Failure to do so may result in a fire or
TOOLS NEEDED:
- Wrench and/or Pliers
- #2 Phillips screwdriver
- Crimp tool
- Handsaw / Jig Saw
- Electrical tape
GETTING TO KNOW YOUR
RF CONTROLLER
GETTING STARTED
1RF CONTROLLER
2POWER ON / OFF
3MODE UP
4AUTO DEMO
5SPEED UP
6BRIGHTNESS UP
7BRIGHTNESS DOWN
8MODE DOWN
9COLOR DOWN
10 COLOR UP
11 SPEED DOWN REPLACEMENT BATTERY - CR2025
1) RF controller range: Up to 25ft (LoS)
2) Do not obstruct the RF remote with metal
3) Always keep away from small children
4) Do not store in direct sunlight
