8DO NOT operate the mixer if any parts are missing or the mixer is damaged as this may cause failure and/or possible injury.
8DO NOT operate the mixer when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8DO NOT carry the mixer with your finger on the power switch, or carry by the power cord, or leave the mixer running whilst
unattended.
9When not in use switch mixer off, remove plug from power supply, clean the mixer and store in safe, dry, child proof area.
2. INTRODUCTION
Powerful 110V electric mixer built into heavy-duty composite casing with rubber grips for added comfort. Mixing volume of up
to 120ltr. Six speed settings and soft start allow for greater control when mixing a variety of materials. Supplied with two
mixing paddles capable of mixing paint, varnish, tile adhesive, cement, plaster, mortar as well as a number of other liquid and
dense materials. Lightweight design and over 2mtr of cable make this mixer easy to use.
3. SPECIFICATION
Model No...................................................PM120L110V
Motor power ........................................................1400W
Supply.................................................................... 110V
No Load Speed ...............................................0-800rpm
Mixing Capacity..................................................... 120ltr
Paddle Size.................................................... Ø140mm.
Thread..................................................................... M14
Weight................................................................... 7.5kg
4. OPERATION
4.1. Ensure that the tool is switched off and the power
supply removed.
4.2. Screw mixing paddle E1 on to shaft E2, tighten
with spanners G.
4.3. Screw mixing paddle assembly into mixer D.
4.4. Connect plug to power supply and switch on.
4.5. Ensure the mixing container is securly positioned
on the oor.
4.6. Dip the mixing paddle into the substance to be mixed.
4.7. Set wheel C (Speed control) to low speed. Always
hold the mixer with two hands.
4.8. Switch on the tool.
4.9. Gradually increase the mixing speed by turning wheel C to the desired maximum speed (so that the substance will not splash
around and the tool will not be overloaded).
4.10. When mixing is complete switch off mixer before removing from substance.
4.11. Remove power supply and clean off paddle.
5. MAINTENANCE
5.1. Disconnect the plug before cleaning.
5.2. Always keep tool and cord clean (especially the ventilation slots).
5.3. Always clean the mixer and functional parts after your mixing work.
5.4. Clean the tool with a dry, soft cloth (do not use cleaning agents or solvents).
5.5. Clean ventilation slots F regularly with a brush or compressed air.
N.B.When not in use switch mixer off, remove plug from power supply, clean the mixer and store in safe, dry, child proof area
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
g.1
PM120L110V | Issue 2 (3) 17/05/18
