3.5 Setting the door opening method
3 0 # Open the door by card.
3 1 # Open the door by card plus password.
3 2 # Default value, open the door by card or password.
3 3 # Open the door by password.
Example, set the card plus password to open the door: 3,1#.
3.6 Setting the door opening time
4 0 # Default value, the door opening time is 50 milliseconds.
4 (1-98) # the door opening time is 1-98 seconds.
4 99 # Set the machine to switch mode, that is, change the lock status every time the door
is opened.
For example, set the door opening time to 5 seconds: 4,5#.
Note: The 50-millisecond door opening time is suitable for the electric control lock or the
access control special power supply. The switch mode is suitable for the normally open
normally closed door.
3.7 Setting the electric lock mode
5 0 # The default value is set to the power-on unlock mode, such as electric lock, electric
lock, etc. The dedicated power supply for the access control should also be set to this mode.
5 1 # is set to power-off unlock mode, such as electric plug lock, magnetic lock, etc.
Example, set to use electric plug lock: 5,1#.
3.8 Setting the security mode
6 0 # Default value, set to normal mode
6 1 # Set to lock mode. When the invalid card, user password or administrator password is
continuously tried 10 times, the machine will be automatically locked for 10 minutes.
Example, set the security mode to lock mode: 6,1#.3.9 Exit from the programming mode
In the programming mode, press * key several times, until the indicator light is red(constantly).
3.10 Change user’s password
3.10.1 Change password by card
*， Swipe user card (Old user password) # (New password ) # (New password) #
Example, Change user password by card：*，Swipe user card 1234#123456#123456#
Note: When changing password by ID number, the old user’s password can be initial password
1234, but the new password can only be 6 digits.
