SECOMP 12.99.1105 Bedienungsanleitung
USB 3.2 Gen 1 to
Gigabit Ethernet Converter
12.99.1105
User Manual
DEAR CUSTOMER
Thank you for purchasing this product. For optimum performance and safety,
please read these instructions carefully before connecting, operating or adjusting
this product. Please keep this manual for future reference.
1.0 INTRODUCTION
The USB 3.0 to Gigabit Ethernet Adapter is a high performance and low-cost
solution. It enables Gigabit Ethernet network connection capability for desktops,
ultra book with standard USB port. It resolves the trouble of the computer without
Ethernet port that you can also connect computer to Ethernet through USB 3.0
port easily.
2.0 FEATURES
Single chip USB 3.0 to 10/100/1000M Gigabit Ethernet controller with Energy
Efficient Ethernet (EEE). Features as below:
Integrates on-chip USB 3.0 PHY and controller compliant to USB Spec 3.0,
2.0 and 1.1
Supports all USB 3.0 power saving modes (U0, U1, U2, and U3)
Supports USB Super/High/Full Speed modes with Bus-power or Self-power
device auto-detect capability
Supports IEEE 802.3az (Energy Efficient Ethernet)
Supports parallel detection and automatic polarity correction
Supports IPv4/IPv6 packet Checksum Offload Engine (COE) to reduce CPU
loading
USB3.0 to Gigabit Ethernet Adapter
１
Supports TCP Large Send Offload V1
Supports full duplex operation with IEEE 802.3x flow control and half duplex
operation with back-pressure flow control
Supports IEEE 802.1P Layer 2 Priority Encoding and Decoding
Supports Jumbo frame
PHY loop-back diagnostic capability
Support Wake-on-LAN Function
Supports suspend mode and remote wakeup via link-change, Magic Packet,
Microsoft Wakeup Frame and external wakeup pin
Support windows 8, windows 7, windows vista, Apple 10.6 and Apple 10.8
2.0 SPECIFICATIONS
C
onnector
s
USB 3.0
USB Male
Ethernet
RJ45
Female
Power Requirement
External Power Supply No
Power consumption (Max) 0.5W
Note: Specifications are subject to change without notice.
3.0 PACKAGE CONTENTS
Before attempting to use this unit, please check the packing and make sure the
following items are contained in the shipping carton:
Main unit x1
User's Manual x1
CD driver x1
4.0 PANEL DESCRIPTIONS
1. USB3.0
Connect the port to the PC Host.
2. RJ45
Connect the port to the Ethernet Router or Networking by a Networking cable.
USB3.0 to Gigabit Ethernet Adapter
２
5.0 CONNECTION AND OPERATION
1) Driver installation
Drive specific installation process please refer to the CD Manual.
2) Connection
① Connect computer to USB 3.0 port of this product
② Connect RJ45 of this product to Ethernet Router by Ethernet cable
③ automatically or manually set IP address of computer.
5.1 CONNECTION DIAGRAM
Inhaltsverzeichnis
Andere SECOMP Medienkonverter Handbücher
