Security Brands SECUREPASS CR1 40-100 Bedienungsanleitung
1 of 2
Model 40-100
1
A2
A6
A3 A4
A5 A7
IMPORTANT
rr
Unpack box and make sure you have all items shown here.
(Hex nuts and screws for faceplate mounting included with faceplate)
Attach included Adhesive Template to
mounting surface where required.
Drill mounting and pass-through holes
per Template. Mounting holes are not
required if not using Wall Anchors.
Gently tap in Wall Anchors (if using)
with a hammer, and then attach
Reader Base with Mounting Screws.
Feed Reader cable through pass-
through hole, and connect Reader to
Wiegand controller (not included).
Reader
Mounting Screw
( 2x )
Hang Reader on Reader Base, ease into
place, and install Set Screw using
included L Key.
Power up Wiegand controller, and
make sure Reader is working correctly
by scanning a valid card (not included).
Wall Anchor
( 2x )
Adhesive
Template
If mounting the proximity card reader to a
surface like a wall or door frame, proceed to
Step A2 on this page.
If mounting the proximity card reader to a
controller faceplate, remove the cover plate or
existing card reader, keep the hex nuts and
screws handy, and proceed to Step B2 on the
next page.
Use 7/16" (6 mm) bit
for mounting holes
and drill to a depth of
1-1/8" (30 mm).
Use 3/8" (10 mm) bit
for pass-through hole.
Install GUIDE
Remove Set Screw
from Reader using
included L Key to
separate Reader from
Reader Base.
Set Reader aside.
L Key
© 2024 Security Brands, Inc. All rights reserved.
2 of 2
IG-40100-EN Rev. A (1/2024)
Model 40-100
Call (972) 474-6390
Email [email protected]
We are available Mon–Fri / 8am–5pm Central
CB2
B3
B4 WARNING
Attach Reader Base to faceplate using
existing hardware, feed Reader cable,
and wire to controller (see Section C).
Hang Reader on Reader Base, ease into
place, and install Set Screw using
included L Key.
Power up Wiegand controller, and
make sure Reader is working correctly
by scanning a valid card (not included).
Typical Wiring
(For many Wiegand controllers including Security Brands controllers)
IMPORTANT! Refer to your Wiegand controller manual/instructions for wiring details.
Reader Wire Harness Guide
Wiegand Controller
Edge (27-210) “Wiegand 1” Terminals Shown
Red +12 VDC
Black Ground (GND)
Green Data 0
White Data 1
Brown Green LED
Yellow Beeper
CAUTION! Do NOT exceed 13.2 VDC! Overpowering Reader may cause permanent damage!
From SecurePass CR1 Reader
+12V
GND
LED 1
LED 2
DATA 0
DATA 1
Reader is designed to attach to and connect with
Edge E1, E2, E3, and Ascent K2 units (not included).
These units come with their own mounting hardware.
AUTOMATIC GATES CAN CAUSE SERIOUS
INJURY OR DEATH!
ALWAYS CHECK THAT THE GATE PATH IS
CLEAR BEFORE OPERATING!
REVERSING OR OTHER SAFETY DEVICES
SHOULD ALWAYS BE USED!
Install GUIDE
Andere Security Brands Steuerungssystem Handbücher
