HOLD YOUR PDA ON THE MULTI-FUNCTION MOUNT KIT
How to hold your PDA on the Multi-Function Mount Kit?
Step 1: Release the holding arms by pushing the “Arm Release Button” on the right side of the cradle.
Step 2: After the holding arms opened, put the PDA in the center of the cradle.
Step 3: Push the holding arms towards the PDA until they can hold the PDA firmly.
If you are using an iPAQ with expansion pack, we recommend you to use the Long Arm version of the Multi-
Function Mount Kit.
If the cradle feet block any port on your PDA, unscrew the cradle feet so the port can be used.
5
USE THE MOUNT KIT TO CHARGE YOUR PDA
6
How to use the Multi-function Mount Kit to charge your PDA?
Step 1: Place your PDA in the cradle. (Please refer to Page 5 of this user guide)
Step 2: Plug the Cigarette Lighter Connector from the Mount Kit to the Cigarette Lighter Port in your car to get
power from the car to operate the Mount Kit.
A red LED at the bottom of the cradle will turn on when the Multi-Function Mount Kit receives power.
Step 3: Connect the PDA Charging Cable to the PDA Charging USB port, which located on the right side of
bottom of the Cradle.
Step 4: Connect the other end of the PDA Charging Cable to the PDA’s charging port. The PDA should show
charging at this time.
Different PDA may require a different PDA Charging Cable. Additional cable available at Seidio.com.
The output power from the PDA charging port is 5V and 1.2Amp.
