3
Important!
CAUTION: This product cannot replace responsible adult supervision.
• This Baby Monitor is intended as an aid. Do not use it as a medical moni-
tor or a substitute for responsible and proper adult supervision.
• Make sure the Baby Unit and adaptor cable are always out of child‘s reach.
Do not place the Baby Unit inside the baby‘s crib or playpen!
• The antenna on the Parents and Baby Units are fixed, do not try to extend
them. Never attempt to modify the product. Avoid using the product near
water.
Parents & Baby Units Battery Installation
1. Locate the battery compartment door on the back of the Parents and Baby Units.
2. Open the battery compartment door.
3. Insert 3 pieces of supplied re-chargeable batteries into the Parents Unit and insert 3 AAA alkaline batteries into the
Baby Unit.
4. Replace battery compartment doors. Battery Tips:
• If the product is not in use for a long time, disconnect both units from the household electrical outlet. And remove the
batteries or the exhausted batteries from the units, otherwise battery leakage and corrosion can damage them.
• Dispose the batteries safely.
• Non-rechargeable battery is not to be recharged - Rechargeable batteries are only to be charged under adult supervi-
sion.
Only the batteries of the same and equivalent type as recommended in the “Battery Installation” instructions are to be
used.
Parents & Baby Unit Battery Charging
1. Use only the AC adaptors which are included in the package, Plug into any nearby standard household electrical outlet.
2. And connect them with the units.
3. It takes 8 hours to charge the re-chargeable batteries full at the first time.
Note:
• User can also install 3 alkaline AAA batteries instead of the supplied re-chargeable batteries.
• Or directly operated by the supplied adaptors.
• The power indicator will turn off when the power is out or in low battery. In this case, user needs to re-charge the sup-
plied re-chargeable batteries or change for new alkaline AAA batteries.
Testing Before First Time Usage
Test the Baby Unit transmission and the Parents Unit reception.
• Set both Parents and Baby Units to the same channel (1 or 2) by switching the channel switch.
• Place Baby Unit in room where you intend to use it. Push the SENSITIVITY switch to Norm position to turn on the Baby
Unit transmission. The power indicator lights (Please refer to Color Index of Power Indicator.)
• Place Parents Unit in room where you intend to use it. Rotate Volume dial to turn power on. The power indicator lights
(Please refer to Color Index of Power Indicator.)
• Light of sound level indicator lights when sound is received:
One or two dots light for shallow sound received.
Three or more dots light for louder sound received.
• When you experience interference (buzzing or static, etc.), switch both units to the alternative channel.
Wireless Baby Monitoring System
SBM 141
EN
